[Amended 12-20-1977 by Ord. No. 77-14]
For the purposes of this chapter, the Borough is divided into the following zones, any or all of which may contain a Conservation District:
R-40 Residential Zone
R-15 Residential Zone
R-10 Residential Zone
RLM Residential Zone
[Added 7-21-1987 by Ord. No. 87-11]
AR-1 Age-Restricted 1 Residential Zone
[Added 5-24-1995 by Ord. No. 95-4]
AR-2 Age Restricted 2 Residential Zone
[Added 9-13-1995 by Ord. No. 95-8]
C-1 Commercial Zone
C-2 Highway Business Zone
SCO Shopping Center/Office District
OTP Office/Technical Park District
[Added 2-15-1983 by Ord. No. 83-1]
OR Office Residential District
[Added 8-21-1984 by Ord. No. 84-20]
PO Professional Office District
[Added 8-26-1992 by Ord. No. 92-13]
M-1 Industrial Zone
[Amended 12-20-1977 by Ord. No. 77-14; 6-21-1983 by Ord. No. 83-10; 12-15-2003 by Ord. No. 2003-19; 11-21-2005 by Ord. No. 2005-17]
The boundaries of the zones are hereby established as shown on a map entitled "Zoning Map, Borough of Gibbsboro, Camden County," dated October 20, 2005, on file in the office of the Borough Clerk. The map, with all explanatory matter thereon, shall be deemed to accompany and is hereby made a part of this chapter as if fully described herein.
Where uncertainty exists as to any of the boundaries as shown on the map, the following rules shall apply.
A. 
Zone boundary lines are intended to follow the center line of streets, railroad rights-of-way, streams and lot or property lines as they exist on plats of record on December 16, 1963, unless such zone boundary lines are fixed by dimensions as shown on the Zoning Map.
B. 
Where boundaries are not fixed by dimensions and where they approximately follow lot lines and where they do not scale more than 10 feet distant therefrom, the lot lines shall be construed to be such boundaries, unless specifically shown otherwise.
C. 
In unsubdivided land and where a zone boundary divides a lot, the location of the boundary, unless the same is indicated by dimensions shown on the map, shall be determined by the use of the scale appearing thereon.[1]
[1]
Editor's Note: Original § 181-7, Schedule of requirements, amended 12-20-1977 by Ord. No. 77-14, which immediately followed this section, was repealed 6-21-1983 by Ord. No. 83-10.