The general regulations affecting the use of buildings and land and the bulk and arrangement of buildings and of materials and equipment occupying land in connection with the nonbuilding use thereof, for each of the districts established by Article
II, are hereby established as set forth in this section.
A. Use Table. The accompanying table, entitled "Table
of General Use Regulations," shall be part of this section, and is
referred to herein as "Use Table."
B. Bulk Table. The accompanying table, entitled "Table
of General Bulk Regulations," shall be part of this section, and is
referred to herein as "Bulk Table."
The Bulk Table is divided into columns, each
column headed by a number for reference. The Bulk Table is divided
into groups, each group being identified by a letter corresponding
to the letter symbol appearing in the Use Table adjacent to each use
or combination of uses. Each of the uses within each group is regulated
by the bulk regulations for the indicated use group.
A. Other articles herein contain supplemental requirements
applying to bulk, setback and coverage of specified uses.
B. Special bulk requirements. Not more than the percentages
indicated in the following table shall be counted as part of any minimum
lot area requirement of this chapter:
|
Item
|
Maximum Percentage Counted
|
---|
|
Land under water
|
50%
|
|
Subject to or within the
|
50%
|
|
|
100-year-frequency floodplain
|
|
|
Within easements or rights-of-
|
50%
|
|
|
way for overhead utilities
|
|
|
With slopes (unexcavated)
|
|
|
|
Over 25%
|
50%
|
|
|
50% or greater
|
25%
|
|
Within a designated street
|
0%
|
|
|
line of any road
|
|
|
Within the Hudson River
|
0%
|
|
|
|
C. Street frontage for residential lots fronting on culs-de-sac
or on a street with a radius of curvature at the center line of 100
feet or less, or in other appropriate circumstances, may be reduced
by the Planning Board at the time of subdivision plat approval to
no less than 1/2 of the required dimensions. No portion of the lot,
along the access route from its frontage into the lot, shall be narrower
than the approved frontage. The Planning Board, at the time of subdivision
approval, may modify and reduce the required lot width for any lot,
but the same may not be reduced to less than 1/2 of the required lot
width.