A.
General.
(1)
A preliminary plat shall be required for all subdivisions and shall
be based upon a survey by a registered land surveyor, and the plat
shall be prepared on paper of good quality at a scale of not more
than 100 feet to the inch and shall show correctly on its face the
following information:[1]
(a)
Title under which the proposed subdivision is to be recorded, which
name shall not duplicate or be alike in pronunciation to the name
of any plat heretofore recorded in the Village unless considered an
addition to the subdivision.
(b)
Legal description/location of the proposed subdivision by government
lot, quarter section, township, range, county and state.
(c)
Date, scale and North point.
(d)
Names, telephone numbers, and addresses of the owner and any agent
having control of the land, engineer, subdivider, and land surveyor
preparing the plat.
(2)
The entire area contiguous to the proposed plat owned or controlled
by the subdivider may be required by the Plan Commission to be included
on the preliminary plat even though only a portion of said area is
proposed for immediate development. Where a subdivider owns or controls
adjacent lands in addition to those proposed for development at that
time, he shall submit a concept plan for the development of the adjacent
lands showing streets, utilities, zoning districts, and other information
as may affect the review of the preliminary plat in question. The
Village Engineer may waive these requirements where adjacent development
patterns have already been established.
B.
Plat data. All preliminary plats shall show the following:
(1)
Exact length and bearing of the exterior boundaries of the proposed
subdivision referenced to a corner established in the United States
Public Land Survey and the total acreage encompassed thereby.
(2)
Locations of all existing property boundary lines, structures, drives,
streams and watercourses, marshes, rock outcrops, wooded areas, railroad
tracks and other significant features within the tract being subdivided
or immediately adjacent thereto.
(3)
Location, right-of-way width and names of all existing streets, alleys
or other public ways, easements, railroad and utility rights-of-way
and all section and quarter section lines within the exterior boundaries
of the plat or immediately adjacent thereto.
(4)
Location and names of any adjacent subdivisions, parks and cemeteries
and owners of record of abutting unplatted lands.
(5)
Type, width and elevation of any existing street pavements within
the exterior boundaries of the plat or immediately adjacent thereto,
together with any legally established center-line elevations.
(6)
Location, size and invert elevation of any existing sanitary or storm
sewers, culverts and drainpipes, the location of manholes, catch basins,
hydrants, and electric and communication facilities, whether overhead
or underground, and the location and size of any existing water and
gas mains within the exterior boundaries of the plat or immediately
adjacent thereto. If no sewers or water mains are located on or immediately
adjacent to the tract, the nearest such sewers or water mains which
might be extended to serve the tract shall be indicated by the direction
and distance from the tract, size and invert elevations.
(7)
Corporate limit lines within the exterior boundaries of the plat
or immediately adjacent thereto.
(8)
Existing zoning on and adjacent to the proposed subdivision.
(9)
Adequate topographic information to describe and locate important
physical features, including critical slopes, general drainage, existing
roadways and buildings with elevations referenced to sea level.
(10)
High-water elevation of all ponds, streams, lakes, flowages
and wetlands within the exterior boundaries of the plat or located
within 100 feet therefrom.
(11)
Water elevation of all ponds, streams, lakes, flowages and wetlands
within the exterior boundaries of the plat or located within 100 feet
therefrom at the date of the survey.
(12)
Floodland and shoreland boundaries and the contour line lying
a vertical distance of two feet above the elevation of the one-hundred-year
recurrence interval flood or, where such data is not available, two
feet above the elevation of the maximum flood of record within the
exterior boundaries of the plat or within 100 feet therefrom.
(13)
Location and results of percolation tests within the exterior
boundaries of the plat conducted in accordance with Ch. Comm 83, Wis.
Adm. Code, where the subdivision will not be served by public sanitary
sewer service.
(14)
Location, width and names of all proposed streets and public
rights-of-way, such as alleys and easements.
(15)
Approximate dimensions of all lots together with proposed lot
and block numbers. The area in square feet of each lot shall be provided.
(16)
Location and approximate dimensions of any sites to be reserved
or dedicated for parks, playgrounds, drainageways or other public
use or which are to be used for group housing, shopping centers, church
sites or other nonpublic uses not requiring lotting.
(17)
Approximate radii of all curves.
(18)
Any proposed lake and stream access with a small drawing clearly
indicating the location of the proposed subdivision in relation to
access.
(20)
Soil tests and reports as may be required by the Village Engineer
for the design of roadways, storm drainage facilities, on-site sewage
disposal systems, erosion control facilities and/or other subdivision
improvements and features.
(21)
Setbacks and building lines for each lot consistent with the pertinent requirements of Chapter 525, Zoning, of this Code.
(22)
Design features.
(a)
Locations and widths of proposed alleys, pedestrianways and
utility easements.
(b)
Layout numbers and preliminary acreages and dimensions of lots
and blocks.
(c)
Minimum front, rear, side, and street yard building setback
lines.
(d)
Location and size of proposed sanitary sewer lines and water
mains.
(e)
Gradients of proposed streets and sewer lines (and water mains,
if required).
(f)
Areas, other than streets, alleys, pedestrianways and utility
easements, intended to be dedicated or reserved for public use, including
the size of such area or areas in acres.
(g)
Location and description of survey monuments.
(h)
An identification system for the consecutive numbering of all
blocks and lots within the subdivision.
(i)
Sites, if any, to be reserved for parks or other public uses.
(j)
Sites, if any, for multifamily dwellings, shopping centers,
churches, industry or other nonpublic uses exclusive of single-family
dwellings.
(k)
Provisions for surface water management, including both minor
and major system components, detention/retention facilities, including
existing and postdevelopment one-hundred-year flood elevations, etc.
(l)
Potential resubdivision and use of excessively deep (over 200
feet) or oversized lots must be indicated in a satisfactory manner.
(m)
Any wetlands, floodplains, or environmentally sensitive areas
provided for by any local, state or federal law.
C.
Additional information.
(1)
Where
the Plan Commission or Village Engineer finds that it or he requires
additional information relative to a particular problem presented
by a proposed development in order to review the preliminary plat,
the Plan Commission or Village Engineer shall have the authority to
request in writing such information from the subdivider.
(2)
The
Plan Commission and/or Village officials may require a proposed subdivision
layout of all or part of the contiguously owned land even though division
is not planned at the time.
A.
General. A final plat prepared by a registered land surveyor shall
be required for all subdivisions. It shall comply in all respects
with the requirements of § 236.20, Wis. Stats., and this
chapter.
B.
Additional information. The final plat shall show correctly on its
face, or on a supporting document, in addition to the information
required by § 236.20, Wis. Stats., the following:
(1)
Exact street width along the line of any obliquely intersecting street.
(2)
Exact location and description of streetlighting and lighting utility
easements.
(3)
Railroad rights-of-way within and abutting the plat.
(4)
All lands reserved for future public acquisition or reserved for
the common use of property owners within the plat.
(5)
Special restrictions required by the Village Board, upon the recommendation
of the Plan Commission, relating to access control along public ways
or to the provision of planting strips.
(6)
Certifications by attached information showing that all taxes and
special assessments currently due on the property to be subdivided
have been paid in full.
(7)
Where the groundwater table is equal to or less than nine feet from
the proposed street center-line elevation, the subdivider shall place
the following note on the plat:
Subsoil information indicates the presence of high groundwater
conditions on Lot(s)__________. On these lots, either basement elevations
must be elevated above the groundwater level or the basement exteriors
must be fully waterproofed.
|
(8)
Dimensions of lot lines which shall be shown in feet and hundredths;
no ditto marks shall be permitted. When lot lines are not at right
angles to the street right-of-way line, the width of the lot shall
be indicated at the building setback line in addition to the width
of the lot at the street right-of-way line.
(9)
A numbered identification system for all lots and blocks.
(10)
Contours within the exterior boundaries of the plat and extending
to the center line of adjacent public streets to National Map Accuracy
Standards based upon mean sea level datum at vertical intervals of
not more than two feet. At least two permanent bench marks shall be
located in the immediate vicinity of the plat; the location of the
bench marks shall be indicated on the plat, together with their elevations
referenced to mean sea level datum and the monumentation of the bench
marks clearly and completely described. Where, in the judgment of
the Village Engineer, undue hardship would result because of the remoteness
of the parcel from a mean sea level reference elevation, another datum
may be used.
C.
Deed restrictions. Restrictive covenants and deed registrations for
the proposed subdivision shall be filed with the final plat.
D.
Property owners' association. The legal instruments creating a property
owners' association for the ownership and/or maintenance of common
lands in the subdivision shall be filed with the final plat.
E.
Street dedication. Public rights-of-way for streets and other public
areas shall be dedicated to the Village with final plat approval.
Such dedications shall require the owner's certificate and the
mortgagee's certificate in substantially the same form as required
by § 236.21(2)(a), Wis. Stats.
F.
Survey accuracy.
(1)
Examination. The Village Board and Plan Commission, or their designees,
shall examine all final plats within the Village of Woodville and
may check for the accuracy and closure of the survey, the proper kind
and location of monuments, and legibility and completeness of the
drawing.
(2)
Maximum error of closure. Maximum error of closure before adjustment
of the survey of the exterior boundaries of the subdivision shall
not exceed, in horizontal distance or position, the ratio of one part
in 5,000 (1:5,000) nor, in azimuth, four seconds of arc per interior
angle. If field measurements exceed this maximum, new field measurements
shall be made until a satisfactory closure of the field measurements
has been obtained; the survey of the exterior boundary shall be adjusted
to form a closed geometric figure.
(3)
Street, block and lot dimensions. All street, block and lot dimensions
shall be computed as closed geometric figures based upon the control
provided by the closed exterior boundary survey. If checks disclose
an error for any interior line of the plat greater than the ratio
of one part in 3,000 (1:3,000) or an error in measured angle greater
than one minute of arc for any angle where the shorter side forming
the angle is 300 feet or longer, necessary corrections shall be made.
Where the shorter side of a measured angle is less than 300 feet in
length, the error shall not exceed the value of one minute multiplied
by the quotient of 300 divided by the length of the shorter side;
however, such error shall not in any case exceed five minutes of arc.
(4)
Plat location. Where the plat is located within a quarter section,
the corners of which have been relocated, monumented and coordinated
by the Village, the tie required by § 236.20(3)(b), Wis.
Stats., may be expressed in terms of grid bearing and distance, and
the material and Wisconsin state plane coordinates of the monument
marking the relocated section or quarter corner to which the plat
is tied shall be indicated on the plat. The grid bearing and distance
of the tie shall be determined by a closed survey meeting the error
of closure herein specified for the survey of the exterior boundaries
of the subdivision.
G.
Surveying and monumenting. All final plats shall meet all the surveying
and monumenting requirements of § 236.15, Wis. Stats.
H.
State plane coordinate system. Where the plat is located within a
quarter section, the corners of which have been relocated, monumented
and coordinated by the Village, the plat shall be tied directly to
one of the section or quarter corners so relocated, monumented and
coordinated. The exact grid bearing and distance of such tie shall
be determined by field measurements, and the material and Wisconsin
state plane coordinates of the monument marking the relocated section
or quarter corner to which the plat is tied shall be indicated on
the plat. All distances and bearings shall be referenced to the Wisconsin
Coordinate System, South Zone, and adjusted to the Village's
control survey.
I.
Certificates. All final plats shall provide all the certificates
required by § 236.21, Wis. Stats., and in addition the surveyor
shall certify that he has fully complied with all the provisions of
this chapter.
A.
Additional information. The certified survey map shall show correctly
on its face, in addition to the information required by § 236.34,
Wis. Stats., the following:
(1)
All existing buildings, watercourses, drainage ditches and other
features pertinent to proper division.
(3)
All lands reserved for future acquisition.
(4)
Date of the map.
(5)
Graphic scale.
(6)
Name and address of the owner, subdivider and surveyor.
(7)
Square footage of each parcel.
(8)
Present zoning for the parcels.
B.
State plane coordinate system. Where the map is located within a
quarter section, the corners of which have been relocated, monumented
and coordinated by the Village, the map shall be tied directly to
one of the section or quarter corners so relocated, monumented and
coordinated. The exact grid bearing and distance of such tie shall
be determined by field measurements, and the material and Wisconsin
state plane coordinates of the monument marking the relocated section
or quarter corner to which the map is tied shall be indicated on the
map. All distances and bearings shall be referenced to the Wisconsin
Coordinate System, South Zone, and adjusted to the Village's
control survey.
C.
Certificates. The surveyor shall certify on the face of the certified
survey map that he has fully complied with all the provisions of this
chapter. The Village Board shall certify its approval on the face
of the map.[2]
D.
Street dedication. Dedication of streets and other public areas shall
require, in addition, the owner's certificate and the mortgagee's
certificate in substantially the same form as required by § 236.21(2)(a),
Wis. Stats.
E.
F.
Requirements. To the extent reasonably practicable, the certified
survey shall comply with the provisions of this chapter relating to
general requirements, design standards and required improvements.
Conveyance by metes and bounds shall be prohibited where the lot(s)
involved is less than 1 1/2 acres or 300 feet in width.
[1]
Editor's Note: Original Sec. 14-1-42(a), Certified survey requirements, and (b), Submission and review, which appeared at the beginning of this section, were deleted at time of adoption of Code (see Ch. 1, General Provisions, Art. II). For the procedure for approval of a certified survey map see § 460-13 of this chapter.