Village of Fox Point, WI
Milwaukee County
By using eCode360 you agree to be legally bound by the Terms of Use. If you do not agree to the Terms of Use, please do not use eCode360.
Table of Contents
Table of Contents
This chapter is adopted pursuant to the authorization in §§ 61.35 and 62.23, Wis. Stats., and the requirements in § 87.30, Wis. Stats., as a code pursuant to § 66.0103, Wis. Stats.
Uncontrolled development and use of the floodplains and rivers of this municipality would impair the public health, safety, convenience, general welfare and tax base.
This chapter is intended to regulate floodplain development to:
Protect life, health and property;
Minimize expenditures of public funds for flood control projects;
Minimize rescue and relief efforts undertaken at the expense of the taxpayers;
Minimize business interruptions and other economic disruptions;
Minimize damage to public facilities in the floodplain;
Minimize the occurrence of future flood blight areas in the floodplain;
Discourage the victimization of unwary land and home buyers;
Prevent increases in flood heights that could increase flood damage and result in conflicts between property owners; and
Discourage development in a floodplain if there is any practicable alternative to locate the activity, use or structure outside of the floodplain.
This chapter shall be known as the "Floodplain Zoning Code for the Village of Fox Point, Wisconsin."
This chapter regulates all areas that would be covered by the regional flood or base flood. [Note: Base flood elevations are derived from the flood profiles in the Flood Insurance Study. Regional flood elevations may be derived from other studies. Areas covered by the base flood are identified as A Zones on the Flood Insurance Rate Map.]
The boundaries of all floodplain districts are designated as floodplains or A Zones on the maps listed below and the revisions in the Village of Fox Point Floodplain Appendix. Any change to the base flood elevations (BFE) in the Flood Insurance Study (FIS) or on the Flood Insurance Rate Map (FIRM) must be reviewed and approved by the DNR and FEMA before it is effective. No changes to regional flood elevations (RFEs) on non-FEMA maps shall be effective until approved by the DNR. These maps and revisions are on file in the office of the Village Clerk/Treasurer, Village of Fox Point. If more than one map or revision is referenced, the most restrictive information shall apply.
Milwaukee County Flood Insurance Rate Map (FIRM), Panel Numbers 55079C0041E, 55079C0042E, 55079C0043E, and 55079C0044E, dated September 26, 2008, with corresponding profiles that are based on the Flood Insurance Study (FIS) dated September 26, 2008, volume number 55079CV001A-005A.
The regional floodplain areas are divided into three districts as follows:
The Floodway District (FW) is the channel of a river or stream and those portions of the floodplain adjoining the channel required to carry the regional floodwaters.
The Flood-Fringe District (FF) is that portion of the floodplain between the regional flood limits and the floodway.
The General Floodplain District (GFP) is those areas that have been or may be covered by floodwater during the regional flood.
Discrepancies between boundaries on the Official Floodplain Zoning Map and actual field conditions shall be resolved using the criteria in Subsection A or B below. If a significant difference exists, the map shall be amended according to Article VIII of this chapter. The Zoning Administrator can rely on a boundary derived from a profile elevation to grant or deny a land use permit, whether or not a map amendment is required. The Zoning Administrator shall be responsible for documenting actual predevelopment field conditions and the basis upon which the district boundary was determined and for initiating any map amendments required under this section. Disputes between the Zoning Administrator and an applicant over the district boundary line shall be settled according to § 724-38C and the criteria in Subsections A and B below.
If flood profiles exist, the map scale and the profile elevations shall determine the district boundary. The regional or base flood elevations shall govern if there are any discrepancies. [Note: Where the flood profiles are based on established base flood elevations from a FIRM, FEMA must also approve any map amendment pursuant to § 724-42F.]
Where flood profiles do not exist, the location of the boundary shall be determined by the map scale, visual on-site inspection and any information provided by the Department.
Compliance with the provisions of this chapter shall not be grounds for removing land from the floodplain unless it is filled at least two feet above the regional or base flood elevation, the fill is contiguous to land outside the floodplain, and the map is amended pursuant to Article VIII of this chapter. [Note: This procedure does not remove the requirement for the mandatory purchase of flood insurance. The property owner must contact FEMA to request a Letter of Map Change (LOMC).]
Any development or use within the areas regulated by this chapter shall be in compliance with the terms of this chapter and other applicable local, state, and federal regulations.
Unless specifically exempted by law, all cities, villages, towns, and counties are required to comply with this chapter and obtain all necessary permits. State agencies are required to comply if § 13.48(13), Wis. Stats., applies. The construction, reconstruction, maintenance and repair of state highways and bridges by the Wisconsin Department of Transportation are exempt when § 30.2022, Wis. Stats., applies.
This chapter supersedes all the provisions of any municipal zoning ordinance enacted under § 61.35 or 87.30, Wis. Stats., which relate to floodplains. If another ordinance is more restrictive than this chapter, that ordinance shall continue in full force and effect to the extent of the greater restrictions, but not otherwise.
This chapter is not intended to repeal, abrogate or impair any existing deed restrictions, covenants or easements. If this chapter imposes greater restrictions, the provisions of this chapter shall prevail.
In their interpretation and application, the provisions of this chapter are the minimum requirements liberally construed in favor of the governing body and are not a limitation on or repeal of any other powers granted by the Wisconsin Statutes. If a provision of this chapter, required by Ch. NR 116, Wis. Adm. Code, is unclear, the provision shall be interpreted in light of the standards in effect on the date of the adoption of this chapter or in effect on the date of the most recent text amendment to this chapter.
The flood protection standards in this chapter are based on engineering experience and scientific research. Larger floods may occur or the flood height may be increased by man-made or natural causes. This chapter does not imply or guarantee that nonfloodplain areas or permitted floodplain uses will be free from flooding and flood damages, nor does this chapter create liability on the part of, or a cause of action against, the municipality or any officer or employee thereof for any flood damage that may result from reliance on this chapter.
The Milwaukee County floodplain zoning provisions in effect on the date of annexation shall remain in effect and shall be enforced by the municipality for all annexed areas until the municipality adopts and enforces an ordinance which meets the requirements of Ch. NR 116, Wis. Adm. Code, and the National Flood Insurance Program (NFIP). These annexed lands are described on the municipality's official Zoning Map. County floodplain zoning provisions are incorporated by reference for the purpose of administering this section and are on file in the office of the municipal Zoning Administrator. All plats or maps of annexation shall show the regional flood elevation and the location of the floodway.
The community shall review all permit applications to determine whether proposed building sites will be reasonably safe from flooding. If a proposed building site is in a flood-prone area, all new construction and substantial improvements shall be designed or modified and adequately anchored to prevent flotation, collapse, or lateral movement of the structure resulting from hydrodynamic and hydrostatic loads; be constructed with materials resistant to flood damage; be constructed by methods and practices that minimize flood damages; and be constructed with electrical, heating, ventilation, plumbing, and air-conditioning equipment and other service facilities designed and/or located so as to prevent water from entering or accumulating within the components during conditions of flooding. Subdivisions shall be reviewed for compliance with the above standards. All subdivision proposals (including manufactured home parks) shall include regional flood elevation and floodway data for any development that meets the subdivision definition of this chapter.