All manufactured homes in the Village of Bath shall conform
to the following requirements.
All new manufactured home units installed shall meet the requirements
of the Residential Code of New York State, Appendix E, Manufactured
Housing Used as Dwellings.
Each manufactured home shall be provided with supports installed
according to the manufactured home manufacturer's instructions.
Units not provided with such instructions shall be installed in compliance
with the following unless the entire system shall be designed by a
registered professional engineer.
A.
Placement.
(1)
The manufactured home shall be placed upon a stand consisting of
appropriate material properly placed, graded and compacted so as to
be durable and adequate for the maximum load anticipated during all
seasons.
(2)
The stand shall have a longitudinal gradient of 0% to 5% and adequate
crown or cross gradient for surface drainage.
(3)
The manufactured home stand shall include provisions for all utility
connections at appropriate locations.
(4)
The manufactured home stand shall include provision for supports
prior to or at the time a manufactured home is set in place.
B.
Supports. Supports shall be provided not more than 12 feet on center,
beginning from the front of the manufactured home. End supports shall
be no more than three feet from the ends of the manufactured home.
Each manufactured home shall be skirted around the bottom portion
with uniform durable material properly ventilated, within 60 days,
weather permitting, of placement of the unit.
