[R.O. 2008 §280.030; Ord. No. 2292 §1, 10-11-2005]
The purpose of the "SR" District is to provide for the construction
of new detached single-family residences. The regulations of this
district are intended to protect and conserve existing areas of predominately
single-family detached dwellings, while allowing the construction
of new units within the limitations prescribed herein.
[R.O. 2008 §280.032; Ord. No. 2292 §1; 10-11-2005; Ord. No. 2455 §1, 7-12-2011; Ord. No. 2575 §1, 3-8-2016]
A.
The following are permitted uses in the "SR" District:
3.
Construction of detached single-family dwellings:
a.
On legal lots of record recorded on or before February 23, 2016,
having a minimum lot area of five thousand (5,000) square feet, a
minimum lot width of forty (40) feet and a minimum lot depth of one
hundred (100) feet; and
[Ord. No. 2763, 1-24-2023]
4.
Alterations, additions or reconstruction to an existing detached single-family dwelling approved in accordance with the provisions of Article XI having a minimum area of at least five thousand (5,000) square feet.
5.
Accessory structures and uses on lots five thousand (5,000) square feet or greater in accordance with the provisions of Article XVI, provided that surface parking lots adjacent to the "COR" District shall be a permitted accessory use after compliance with the provisions of special permit procedure, Articles XI and XII and provided all other applicable ordinances and regulations are complied with.
[R.O. 2008 §280.033; Ord. No. 2292 §1, 10-11-2005]
[Ord. No. 2575 § 1, 3-8-2016]
[R.O. 2008 §280.034; Ord. No. 2292 §1, 10-11-2005; Ord. No. 2575 §1, 3-8-2016]
A.
Upon approval in accordance with site plan review procedures set forth in Article XI, a lot having:
1.
Less than the minimum lot size requirements set forth in Section
400.220(1); but
2.
At least six thousand (6,000) square feet in area, sixty (60)
feet in width and one hundred (100) feet in depth may be used for
a detached single-family dwelling, provided the lot contains a lot
width and an area equal to or greater than the average lot width and
average area of all lots located within two hundred (200) feet of
the lot.
B.
For purposes of determining average lot width and average area, only those lots which are within the "SR" District and which are included within the same subdivision as the lot shall be considered. As used in this Section, a "subdivision" shall mean a tract composed of a minimum of six (6) lots depicted on a duly recorded plat. Where a lot is not located within a subdivision, all lots within the "SR" District and which are within two hundred (200) feet of the lot shall be considered. The average area shall be determined in accordance with the calculation process set forth in Section 400.240(C).
C.
Calculation process for determining average allowable lot size for
"SR" Zoning District:
Step 1:
| |||
1.
|
Identify and calculate the area of each applicable lot within
two hundred (200) feet of the parcel in question which contains more
than six thousand (6,000) square feet, but less than fifteen thousand
(15,000) square feet.
| ||
2.
|
Total the area of all existing residential lots from Step 1-1.
| ||
3.
|
Total the number of existing residential lots from Step 1-1.
| ||
Step 2:
| |||
1.
|
Calculate the total area of all applicable lots within two hundred
(200) feet of the parcel in question which are under six thousand
(6,000) square feet.
| ||
2.
|
Divide the total area in Step 2-1 by six thousand (6,000) square
feet (number of hypothetical six thousand (6,000) square foot lots
in this area).
| ||
Step 3:
| |||
1.
|
Total the number of applicable lots over fifteen thousand (15,000)
square feet within two hundred (200) feet of the parcel in question.
| ||
2.
|
Multiply number of lots in Step 3-1 by fifteen thousand (15,000)
square feet = allowable area for total calculations purposes.
| ||
Step 4:
| |||
Add steps 1-2, 2-1 and 3-2 = total area (for calculations purposes).
| |||
Step 5:
| |||
Add steps 1-3, 2-2 and 3-1 = total lots (for calculation purposes).
| |||
Step 6:
| |||
Step 4/Step 5 = minimum lot size allowable for parcel in question.
|
D.
The provisions of Subsections (A) through (C) notwithstanding, the variable and minimum lot dimensions resulting from or found in this Section shall not be applied to restrict:
1.
Alterations, additions or reconstruction of existing dwellings
on any lot having an area greater than five thousand (5,000) square
feet and less than fifteen thousand (15,000) square feet.
[R.O. 2008 §280.035; Ord. No. 2292 §1, 10-11-2005; Ord. No. 2340 §1, 5-22-2007]
A.
Residential Floor Area Ratio. In no case shall a single-family
detached residence exceed a residential floor area ratio of:
1.
For lots six thousand (6,000) square feet or less in area, 0.50;
2.
For lots greater than six thousand (6,000) square feet in area but
less than twenty thousand (20,000) square feet, 0.30 or three thousand
five hundred (3,500) square feet, whichever is greater; and
3.
For lots twenty (20,000) square feet or greater in area, 0.25 or
six thousand (6,000) square feet, whichever is greater.
B.
Lot Coverage. In no case shall the lot coverage of a single-family
detached residential lot exceed:
1.
For lots six thousand (6,000) square feet or less in area, forty
percent (40%);
2.
For lots greater than six thousand (6,000) square feet in area but
less than twenty thousand (20,000) square feet, twenty-five percent
(25%) or two thousand five hundred (2,500) square feet, whichever
is greater; and
3.
For lots twenty thousand (20,000) square feet or greater in area,
twenty percent (20%) or five thousand (5,000) square feet, whichever
is greater.
C.
Residential Building Height. In no case shall the residential
building height of a single-family detached residence exceed thirty-five
(35) feet.
[R.O. 2008 §280.036; Ord. No. 2292 §1, 10-11-2005]
A.
Minimum Front Yard Setback. The minimum front yard setback
shall equal the front yard setback of the legal lot of record as set
out on the plat thereof. In no event shall the front yard setback
be less than twenty-five (25) feet.
B.
Minimum Side Yard Setback. The minimum side yard setback
for each side yard shall be as follows:
C.
Rear Yard Setback. Each interior lot shall provide a minimum
rear yard setback of twenty percent (20%) of the lot depth. No lot
shall provide a rear yard setback less than twenty (20) feet.
[R.O. 2008 §280.037; Ord. No. 2292 §1, 10-11-2005; Ord. No. 2575 §1, 3-8-2016]