[Ord. 558, 9/4/2012]
A building or structure may be erected or altered, to be used
either in whole or in part, and a lot may be used or occupied for
any of the following uses and no other, provided that such uses, buildings
or structures shall comply with such regulations as yard, lot sizes,
lot width, building area, heights, impervious surfaces, easements,
buffer yards, off-street parking and other requirements as specified
by this chapter.
[Ord. 558, 9/4/2012]
All uses shall comply with the area and dimensional requirements listed in this section, unless a greater area or dimensional requirement is stated in Part
14, Use Regulations, for the specific use; in which case the requirements of Part
14 shall apply.
A. Lot area and dimensional requirements.
(1) Single-family detached dwelling.
(a)
A lot area of not less than 9,000 square feet.
(b)
Lot width of not less than 60 feet at the building line and
front property line shall be provided for each single-family dwelling.
(c)
Minimum yards.
1)
Front: 30 feet; 50 feet for arterial or collector streets.
3)
Sides: 20 feet aggregate, no side less than eight feet.
(2) Two-family dwelling.
(a)
Lot area of 10,000 square feet for two dwellings (5,000 square
feet per dwelling) is required.
(b)
Lot width for each two-family dwelling shall be 100 feet.
(c)
Minimum yards.
1)
Front: 30 feet; 50 feet for arterial or collector streets.
3)
Sides: 20 feet aggregate, no less than eight for each side.
(3) Multifamily dwellings and townhouses.
(a)
Minimum lot area of five acres required.
(b)
Maximum density: five units per acre.
(c)
Lot width for the tract: 200 feet.
(d)
Maximum building length: 160 feet.
(e)
Minimum distance between buildings: 35 feet.
(4) Other principal uses permitted in this district shall have a lot
area of not less than 20,000 square feet with a width of not less
than 100 feet at the building line and 80 feet at the front property
line, unless otherwise required under this chapter.
B. Where a single-family or two-family dwelling is constructed on a
lot, not more than 35% of the area of any lot shall be occupied by
buildings or structures.
C. For all other permitted uses in this district, no more than 25% of
the area of the lot shall be occupied by buildings or structures.
D. Impervious surface ratio. No more than 35% of the total lot area
shall be covered with impervious surface.
[Ord. 558, 9/4/2012]
Along any residential zoning district boundary line or along
any lot line separating a residential use from a nonresidential use,
a buffer yard shall be provided which shall be not less than 50 feet
in width measured from such boundary line or from the street line
where such street constitutes the district boundary line and shall
be in accordance with the provisions of this chapter. Such buffer
yards may be conterminous with any required yard in this district,
and in case of conflict, the largest yard requirement shall apply.
[Ord. 558, 9/4/2012]
Each building in use shall be served by public water and sanitary
sewer facilities at the time of development. All public utilities,
such as telephone, cable television, electric, etc., shall be placed
underground.
[Ord. 558, 9/4/2012]
No dwelling unit shall exceed a vertical height of 35 feet, which height shall be measured in accordance with the definition of "building height" in §
27-202 of this chapter.
[Ord. 558, 9/4/2012]
Buildings shall be designed such that no more than three adjoining
dwelling units shall have an identical front yard setback. An average
of at least four-foot setback variations per dwelling unit is required.