[CC 1979 §42.050]
A.
After
the preliminary plat has been approved by the Commission, a final
plat in the form of a record plat shall be prepared and submitted
to the Commission for approval by that body and the City Board. This
plat shall be drawn on tracing cloth or stable base film of standard
sheet size in India ink and shall be at the same scale as the approved
preliminary plat and shall show or be accompanied by the following
information:
1.
The name of the subdivision and adjacent subdivisions, the names
of streets (to conform wherever possible to existing street names)
and numbers of lots and blocks, in accordance with a systematic arrangement.
In case of branching streets, the lines of departure shall be indicated.
2.
An accurate boundary survey of the property, with bearings and distances,
referenced to section corners, and showing (in dotted lines) the lines
of all adjacent lands and the lines of adjacent streets and alleys,
with their widths and names.
3.
Locations of lots, streets, public highways, alleys, parks and other
features, with accurate dimensions in feet and decimals of feet, with
the length of radii and of arcs of all curves, and with all other
information necessary to reproduce the plat on the ground. Dimensions
shall be shown from all angle points and points of curve in lot lines.
4.
The location of building lines on front and side street and the location
of utility easements.
5.
Profiles of grades for streets, if required by the Board or by the
Commission.
6.
Certification of dedication of all streets, public highways, alleys,
parks and other land intended for public use, signed by the owner
or owners and by all other parties who have a mortgage of lien interest
in the property.
7.
An affidavit of ownership, showing fee simple title and encumbrances
and liens.
8.
Certification by a registered civil engineer or licensed surveyor
to the effect that the plan represents a survey made by him/her, and
that all the necessary survey monuments are correctly shown thereon.
9.
Certificates of approval on the tracing to be filled out by the Commission.
10.
North point, scale and date.
11.
This final plat shall be submitted to the City within ninety (90)
days of the approval of the preliminary plat.
12.
All lot lines identified by bearings and distances.
13.
All bearings and distances or road boundaries.
[CC 1979 §42.060]
All figures and letters shown must be plain, distinct, and of
sufficient size to be easily read and must be of sufficient density
to make a lasting and permanent record.
[CC 1979 §42.070]
When more than one (1) sheet is used, a key map, showing the
entire subdivision at smaller scale with block numbers and street
names, shall be shown on one (1) of the sheets or on a separate sheet
of the same size.
[CC 1979 §42.080]
The engineer shall place sufficient permanent monuments along
the boundaries of the property so that another engineer may retrace
his/her work with accuracy. Iron pins not less than three (3) feet
long and three-fourth (¾) inch diameter shall be placed at
block corners, angle points on the streets, and the beginning and
end of curves on streets.
