[Ord. 146, 1/10/2008]
1.
For the purposes of this chapter, the Township is hereby divided
into zoning districts which shall be designated as follows.
A.
RA Residential Agricultural District.
B.
RM Residential Moderate Density District.
C.
GC General Commercial District.
D.
I Industrial District.
E.
SC Special Conservation District.
F.
CSO Corridor Site Overlay District.
G.
CPO Corridor Perimeter Overlay District.
H.
YRO Yutes Run Overlay District.
I.
AO Airport Overlay District.
2.
The overlay districts shall be an addition to, and not a replacement
for, the underlying zoning district designation for properties located
within the overlay districts.
[Ord. 146, 1/10/2008]
The boundaries of the Township zoning districts hereby established
are shown on the Official Township Zoning Map attached hereto and
incorporated herein at Appendix 27-A. This Zoning Map and all of the
notations, references and other data shown thereon are hereby incorporated
by reference into this chapter and shall be as much a part of this
chapter as if all were fully described herein.
[Ord. 146, 1/10/2008; as amended by Ord. 173, 8/5/2014, § 2]
1.
Where uncertainty exists as to the boundaries of any zoning district
as shown on said map, the following rules shall apply:
A.
Zoning district boundary lines are intended to follow or be parallel
to the center line of streets, and streams and to lot or property
lines as they exist on a recorded deed or plan of record in the Allegheny
County Department of Real Estate office at the time of the adoption
of this chapter, unless such zoning district boundary lines are fixed
by dimensions as shown on the Zoning Map.
B.
Where a zoning district boundary is not fixed by dimensions and where
it approximately follows lot lines, rights-of-ways, road center lines,
stream channels or municipal limits, and where it does not scale more
than 10 feet therefrom, such lines shall be construed to be said zoning
district boundaries unless specifically shown otherwise.
C.
Where a zoning district boundary does not follow lot lines, the location
of such boundary, unless the same is indicated by dimensions, shall
be determined by the use of the scale appearing on the Zoning Map.
2.
When there is disagreement on the location of zoning district boundaries,
a determination shall be made by the Zoning Officer, with appeal from
the determination of the Zoning Officer made to the Zoning Hearing
Board.
[Ord. 146, 1/10/2008]
1.
The permitted uses, conditional uses and uses by special exception
for each zoning district are set forth in Table 27-1 of this chapter.[1]
[1]
Editor's Note: Table 27-1 is included as an attachment to this chapter.
2.
As uses in Table 27-1 of this chapter:
A.
The letter "P" denote a permitted use by right, subject to the requirements specified this chapter and after a zoning use permit and/or zoning occupancy permit have been issued in accordance with Part 22 of this chapter.
B.
The letters "CU" denote a use that is permitted by conditional use, subject to the requirements specified in this chapter and provided that the Board of Supervisors grants the conditional use approval pursuant to Part 15 of this chapter.
C.
The letters "SE" denote a use that is permitted by special exception,
subject to the requirements specified in this chapter and provided
that the Zoning Hearing Board grants the special exception approval
pursuant to this chapter.
[Ord. 146, 1/10/2008; as amended by Ord. 154, 9/1/2009, §§ 3,
4; by Ord. 158, 4/6/2010, § 2; by Ord. 170, 6/5/2012, § 4;
and by Ord. 173, 8/5/2014, § 7]
Uses which are not specifically listed as a permitted use, conditional use or use by special exception in any zoning district shall be permitted as a conditional use in the I Industrial District pursuant to the procedures and requirements of Part 15 hereof provided that the applicant demonstrates that the proposed use complies with the general standards and criteria of § 27-1503 and the express standards and criteria of § 27-1559.
