[Added 10-3-2016 by L.L.
No. 10-2016]
A.
Solar energy is a renewable and nonpolluting energy resource that
can prevent fossil fuel emissions and reduce a municipality's energy
load. Energy generated from solar energy systems can be used to offset
energy demand on the grid where excess solar power is generated.
B.
The use of solar energy equipment for the purpose of providing electricity
and energy for heating and/or cooling is a priority and is a necessary
component of the City of Beacon's current and long-term sustainability
agenda.
C.
This article aims to promote the accommodation of solar energy systems
and equipment and the provision for adequate sunlight and convenience
of access necessary therefor and to balance the potential impact on
neighbors when solar collectors may be installed near their property
while preserving the rights of property owners to install solar energy
systems without excess regulation.
As used in this article, the following terms shall have the
meanings indicated:
A solar energy system that consists of integrating photovoltaic
modules into the building envelope, such as the roof or the facade,
which does not alter the roofline.
A photovoltaic panel or tile that is installed flush to the
surface of a roof and which cannot be angled or raised.
A solar energy system that is directly installed in the ground
and is not attached or affixed to an existing structure. Pole-mounted
solar energy systems shall be considered freestanding or ground-mounted
solar energy systems for purposes of this chapter.
An area of land with solar facilities principally used to
capture solar energy and convert it to electrical energy to transfer
to the public electric grid in order to sell electricity to or receive
a credit from a public utility entity, but also may be for on-site
use. Solar facilities consist of one or more freestanding ground-
or roof-mounted solar collector devices, solar-related equipment and
other accessory structures and buildings, including light reflectors,
concentrators, heat exchangers, substations, electrical infrastructure,
transmission lines and other appurtenant structures and facilities.
A solar energy system that relies upon original or retrofitted
design features and building materials of a structure to enhance the
use of natural forces to provide heating and cooling within a building.
A solar energy system that produces electricity by the use
of semiconductor devices, called "photovoltaic cells," which generate
electricity whenever light strikes them.
A person who has skills and knowledge related to the construction
and operation of solar electrical equipment and installations and
has received safety training on the hazards involved. Persons who
are on the list of eligible photovoltaic installers maintained by
the New York State Energy Research and Development Authority (NYSERDA),
or who are certified as a solar installer by the North American Board
of Certified Energy Practitioners (NABCEP), shall be deemed to be
qualified solar installers for the purposes of this definition. Persons
who are not on NYSERDA's list of eligible installers or NABCEP's list
of certified installers may be deemed to be qualified solar installers
if the Building Inspector or such other City officer or employee as
the City Council designates determines such persons have had adequate
training to determine the degree and extent of the hazard and the
personal protective equipment and job planning necessary to perform
the installation safely. Such training shall include the proper use
of special precautionary techniques and personal protective equipment,
as well as the skills and techniques necessary to distinguish exposed
energized parts from other parts of electrical equipment and to determine
the nominal voltage of exposed live parts.
A solar system in which solar panels are mounted on top of
the structure of a roof either as a flush-mounted system or as a module
fixed to frames which can be tilted toward the south at an optimal
angle.
Space open to the sun and clear of overhangs or shade, including
the orientation of streets and lots to the sun so as to permit the
use of active and/or passive solar energy systems on individual properties.
A device or combination of devices which relies upon solar
radiation as an energy source and that is employed for the purposes
of heating or cooling a building, the heating of water or the generation
of electricity. For the purposes of this chapter, a solar collector
does not include any solar energy system of four square feet in size
or less.
Solar collectors, controls, energy storage devices, heat
pumps, heat exchangers, batteries and other materials, hardware or
equipment necessary to the process by which solar radiation is collected,
converted into another form of energy, stored, protected from unnecessary
dissipation and distributed.
A.
Rooftop and building-mounted solar collectors are permitted in all
zoning districts in the City, subject to the following requirements:
(1)
Building permits shall be required for installation of all solar
collectors.
(2)
Any height limitations provided in the City Code shall not be applicable to solar collectors except for the restrictions provided for in the Central Main Street District § 223-41.18E(6) and (7) and the Linkage District § 223-41.21D(5). Solar collectors shall be erected only to such height as reasonably necessary to accomplish the purpose for which they are intended to serve, but in no case shall the maximum height of a panel in a tilted position exceed two feet above the surface of the roof, unless in a nonresidential district, and such structures shall not obstruct solar access to neighboring properties.
[Amended 6-15-2020 by L.L. No. 7-2020]
(3)
In a nonresidential district, the maximum height of a panel in a
tilted position shall not exceed five feet above the surface of the
roof.
(4)
All rooftop and building-mounted solar collectors shall use black
or neutral, nonreflective colors.
(5)
All utility services and electrical wiring shall be underground or
otherwise placed within conduit securely attached to the roof and
walls.
(6)
Rooftop units shall be installed in accordance with all applicable
requirements of the New York State Uniform Fire Prevention and Building
Code.
(7)
In residential districts, panels facing the front yard must be mounted
at the same angle as the roof's surface with a maximum distance of
18 inches between the roof and highest edge of the system.
(8)
Solar panels affixed to a flat roof shall be placed below the line
of sight from a public right-of-way, except where the subject right-of-way
is at a higher elevation than the first-floor elevation of the building.
B.
Building-integrated photovoltaic (BIPV) systems. BIPV systems are
permitted in all zoning districts and shall be shown on the plans
submitted for the building permit application for the building containing
the system.
C.
Freestanding and ground-mounted solar collectors are permitted as
accessory structures in all zoning districts of the City, subject
to the following requirements:
(1)
Building permits are required for the installation of all ground-mounted
solar collectors.
(2)
The location of the solar collector shall meet all applicable setback
requirements for accessory structures in the zoning district in which
it is located.
(3)
The height of the solar collector and any mounts shall not exceed
20 feet when oriented at maximum tilt.
(4)
The total surface area of all ground-mounted and freestanding solar
collectors on the lot shall not exceed 1,000 square feet. The area
beneath ground-mounted and freestanding solar collectors shall be
included in calculating total surface area.
(5)
The solar collector shall be located in a side or rear yard.
(6)
Freestanding and ground-mounted solar collectors shall be screened
when possible and practicable from adjoining lots and street rights-of-way
through the use of architectural features, earth berms, landscaping,
fencing or other screening which will harmonize with the character
of the property and surrounding area. The proposed screening shall
not interfere with normal operation of the solar collectors.
(7)
Freestanding and ground-mounted solar collectors on corner lots shall
be restricted to areas that are not highly visible from the street.
(8)
The solar collectors shall not emit unreasonable glare and negatively
impact adjacent properties.
(9)
Solar energy equipment shall be located in a manner to reasonably
minimize view blockage for surrounding properties and shading of property
to the north, while still providing adequate solar access for collectors.
(10)
Solar collectors and solar energy equipment shall not be placed
in such a way as to obstruct proper sight distance or otherwise interfere
with pedestrian or traffic flow or means of ingress or egress.
D.
If a solar collector ceases to perform its originally intended function
for more than 12 consecutive months, the property owner shall remove
the collector, mount and associated equipment and facilities by no
later than 90 days after the end of the twelve-month period.
A.
Large-scale solar collectors or solar farms shall be subject to site development plan review by the Planning Board in accordance with the provisions of § 223-25 and shall meet the following supplementary regulations:
(1)
Large-scale solar collectors or solar farms shall not be permitted
in areas zoned for residential use.
(2)
Height and setback restrictions.
(a)
The maximum height for freestanding solar panels located on
the ground or attached to a framework located on the ground shall
not exceed 20 feet in height above the ground.
(b)
The minimum setback from property lines shall be 25 feet.
(c)
A landscaped buffer shall be provided around all equipment and
solar collectors to provide screening from adjacent properties and
roads.
(3)
Design standards.
(a)
Removal of trees and other existing vegetation should be minimized
or offset with planting elsewhere on the property.
(b)
All on-site utility and transmission lines shall, to the extent
feasible, be placed underground.
(c)
Solar collectors and other facilities shall be designed and
located in order to prevent reflective glare toward any inhabited
buildings on adjacent properties and roads.
(d)
All solar collectors and mechanical equipment, including any
structure for batteries or storage cells, shall be enclosed by a minimum
six-foot-high fence with a self-locking gate provided with landscape
screening.
(e)
A large-scale solar collector or solar farm to be connected
to the utility grid shall provide a "proof of concept" letter from
the utility company acknowledging the solar farm will be connected
to the utility grid in order to sell electricity to the public utility.
(5)
Abandonment.
(a)
All applications for a large-scale solar collection system or
solar farm shall be accompanied by a decommissioning plan to be implemented
upon abandonment, or cessation of activity, or in conjunction with
removal of the facility, prior to issuance of a building permit.
(b)
If the applicant begins but does not complete construction of
the project within 18 months after receiving final site plan approval,
this may be deemed abandonment of the project and require implementation
of the decommissioning plan to the extent applicable.
(c)
The decommissioning plan must ensure the site will be restored
to a useful, nonhazardous condition without delay, including, but
not limited to, the following:
[1]
Removal of aboveground and below-ground equipment, structures
and foundations.
[2]
Restoration of the surface grade and soil after removal of equipment.
[3]
Revegetation of restored soil areas with native seed mixes,
excluding any invasive species.
[4]
The plan should include a time frame for the completion of site
restoration work.
(d)
In the event that the facility is not completed and functioning
within 18 months of the issuance of the final site plan approval,
the City may notify the operator and/or the owner to complete construction
and installation of the facility within 180 days. If the owner and/or
operator fails to perform, the City may notify the owner and/or operator
to implement the decommissioning plan.
(e)
Upon cessation of activity of a constructed facility for more
than 12 consecutive months, the City may notify the owner and/or operator
of the facility to implement the decommissioning plan at the owner's
expense.
A.
All solar collector installations must be performed by a qualified
solar installer, and prior to operation, the electrical connections
must be inspected by the Building Inspector and by an appropriate
electrical inspection person or agency, as determined by the City.
In addition, any connection to the public utility grid must be inspected
by the appropriate public utility.
B.
Solar energy systems shall be maintained in good working order.
C.
Rooftop and building-mounted solar collectors shall meet New York's
Uniform Fire Prevention and Building Code standards.
D.
When solar storage batteries are included as part of the solar collector
system, they must be placed in a secure container or enclosure meeting
the requirements of the New York State Fire Prevention and Building
Code when in use and when no longer used shall be disposed of in accordance
with the laws and regulations of City and other applicable laws and
regulations.
E.
Marking of equipment.
(1)
Solar energy systems and equipment shall be marked in order to provide
emergency responders with appropriate warning and guidance with respect
to isolating the solar electric system. Materials used for marking
shall be weather-resistant. For residential applications, the marking
may be placed within the main service disconnect. If the main service
disconnect is operable with the service panel closed, then the marking
should be placed on the outside cover.
(2)
For commercial application, the marking shall be placed adjacent
to the main service disconnect in a location clearly visible from
the location where the lever is operated.
A.
If a person is found to be in violation of the provisions of this
article, appeals should be made in accordance with the established
procedures and time limits of the City Zoning Code and New York State
law.
B.
If a building permit for a solar energy device is denied based upon
a failure to meet the requirements of this article, the applicant
may seek relief from the Zoning Board of Appeals in accordance with
the established procedures and time limits of the Zoning Code and
New York State law.
