[Ord. No. 6035 § II, 11-7-2016]
Users shall provide wastewater treatment as necessary to comply with this Chapter and shall achieve compliance with all categorical Pretreatment Standards, Local Limits, and the prohibitions set out in Section 716.050 of this Chapter within the time limitations specified by EPA, the State, or the Director, whichever is more stringent. Any facilities necessary for compliance shall be provided, operated, and maintained at the User's expense. Detailed plans describing such facilities and operating procedures shall be submitted to the Director for review, and shall be acceptable to the Director before such facilities are constructed. The review of such plans and operating procedures shall in no way relieve the User from the responsibility of modifying such facilities as necessary to produce a discharge acceptable to the BMU under the provisions of this Chapter.
[Ord. No. 6035 § II, 11-7-2016]
A.
Whenever deemed necessary, the Director may require Users to restrict
their discharge during peak flow periods, designate that certain wastewater
be discharged only into specific sewers, relocate and/or consolidate
points of discharge, separate sewage wastestreams from industrial
wastestreams, and such other conditions as may be necessary to protect
the POTW and determine the User's compliance with the requirements
of this Chapter.
B.
The Director may require any person discharging into the POTW to
install and maintain, on their property and at their expense, a suitable
storage and flow-control facility to ensure equalization of flow.
An individual wastewater discharge permit may be issued solely for
flow equalization.
C.
Grease, oil, and sand interceptors shall be provided when, in the
opinion of the Director, they are necessary for the proper handling
of wastewater containing excessive amounts of grease and oil, or sand;
except that such interceptors shall not be required for residential
users. All interception units shall be of a type and capacity approved
by the Director, shall be so located to be easily accessible for cleaning
and inspection. Such interceptors shall be inspected, cleaned, and
repaired by the User at their expense. This shall be in accordance
with Sikeston Municipal Code 715.210, Grease, Oil and Sand Traps.
D.
Users with the potential to discharge flammable substances may be
required to install and maintain an approved combustible gas detection
meter.
[Ord. No. 6035 § II, 11-7-2016]
A.
The Director shall evaluate whether each SIU needs an accidental
discharge/slug discharge control plan or other action to control Slug
Discharges, the Director may require any User to develop, submit for
approval, and implement such a plan or take such other action that
may be necessary to control Slug Discharges. Alternatively, the Director
may develop such a plan for any User. An accidental discharge/slug
discharge control plan shall address, at a minimum, the following:
1.
Description of discharge practices, including non-routine batch
discharges;
2.
Description of stored chemicals;
3.
Procedures for immediately notifying the Director of any accidental or Slug Discharge, as required by Section 716.350 of this Chapter; and
4.
Procedures to prevent adverse impact from any accidental or
Slug Discharge. Such procedures include, but are not limited to, inspection
and maintenance of storage areas, handling and transfer of materials,
loading and unloading operations, control of plant site runoff, worker
training, building of containment structures or equipment, measures
for containing toxic organic pollutants, including solvents, and/or
measures and equipment for emergency response.
[Ord. No. 6035 § II, 11-7-2016]
A.
Septic tank waste may be introduced into the POTW only at locations designated by the Director, and at such times as are established by the Director. Such waste shall not violate Article II of this Chapter or any other requirements established by the BMU. The Director may require septic tank waste haulers to obtain individual wastewater discharge permits.
B.
The Director may require haulers of industrial waste to obtain individual
wastewater discharge permits. The Director may require generators
of hauled industrial waste to obtain individual wastewater discharge
permits. The Director also may prohibit the disposal of hauled industrial
waste. The discharge of hauled industrial waste is subject to all
other requirements of this Chapter.
C.
Industrial waste haulers may discharge loads only at locations designated
by the Director. No load may be discharged without prior consent of
the Director. The Director may collect samples of each hauled load
to ensure compliance with applicable Standards. The Director may require
the industrial waste hauler to provide a waste analysis of any load
prior to discharge.
D.
Industrial waste haulers must provide a waste-tracking form for every
load. This form shall include, at a minimum, the name and address
of the industrial waste hauler, permit number, truck identification,
names and addresses of sources of waste, and volume and characteristics
of waste. The form shall identify the type of industry, known or suspected
waste constituents, and whether any wastes are RCRA hazardous wastes.
