Sections
17.22.240 through
17.22.252 shall be known as "PDO-12" (Walcott Estates Planned Development Overlay District).
(Ord. 12-01 § 3)
The Walcott Estates planned development overlay district (PDO-12)
is intended to provide regulations for a rural style, transitional
development with liberal open space. It is the intent of the city
to create special regulations that will combine open space with clustered
small-lot single-family residential product to conserve open space
and drainage ways and serve as a transitional development between
medium density single-family residential areas to the south and large
lot rural properties to the north.
(Ord. 12-01 § 3)
The Walcott Estates planned development overlay district (PDO-12), located between Walcott Lane and Butterfield Stage Road, is intended to provide for the development of forty-five single-family detached homes on fee owned lots, on 25.13 gross acres, with a proposed density of 1.8 dwelling units per gross acre. The proposed project is comprised entirely of private residential land uses designed to enhance housing opportunities, consider natural features, incorporate private and common open space, private recreation, and develop a common community theme. The project will provide housing opportunities consistent with the city's general plan policies in response to local market demands and will provide for a visually pleasing environment through adaptation of supplemental performance standards that have been provided to ensure transitional compatibility with adjacent neighborhoods. Supportive housing that complies with Section
17.06.110 shall be a permitted use. Transitional housing shall be permitted by right in single family homes. Accessory dwelling units shall be permitted and shall comply with Chapter
17.23.
(Ord. 12-01 § 3; Ord. 23-11, 11/28/2023; Ord. 23-12, 11/28/2023)
The residential component shall comply with the development
standards set forth in Table 17.22.248. The maximum residential density
shall be two units per gross acre.
Table 17.22.248
Residential Development Standards
Walcott Estates Planned Development Overlay District
|
---|
Residential Development Standards
|
PDO-12
|
---|
Lot Area
|
Minimum lot area
|
4,500 sq. ft.
|
Maximum number of dwelling units per gross acre
|
2.0
|
Lot Dimensions
|
Minimum average width
|
45 ft.
|
Minimum average depth
|
100 ft.
|
Building Setbacks
|
Minimum front yard 1
|
15 ft.
|
Minimum corner side yard
|
10 ft.
|
Minimum interior side yard
|
5 ft.
|
Minimum rear yard
|
20 ft.
|
Minimum building separation
|
10 ft.
|
Other Requirements
|
Maximum building height
|
35 ft.
|
Notes:
|
1.
|
A minimum of twenty-foot setback is required to face of garage
door.
|
(Ord. 12-01 § 3)
The development shall be consistent with the following exhibits:
Exhibit 17.22.252A—Site Plan
|
Exhibit 17.22.252B—Mailbox Trellis
|
Exhibit 17.22.252C—Section at Butterfield Stage
Road
|
Exhibit 17.22.252D—Typical Section at Interior Street
|
Exhibit 17.22.252E—Section at Project Entry
|
Exhibit 17.22.252F—Section at Walcott Lane
|
Exhibit 17.22.252G—Architectural Styles
|
The architecture of the project shall include at least three
different floor plans and three different architectural styles (Spanish,
Craftsman, and Tuscan). At a minimum, the styles shall include the
following features to provide variation along the street.
•
|
Spanish. Stucco finish, concrete "s" tile roof, 4:12 roof pitch,
decorative accent vents, clay pipe accents, decorative foam trim elements,
wood fascias and exposed rafter tails, arched multi-pane windows,
arched entrances, front porches, and decorative wood shutters.
|
•
|
Tuscan. Stucco finish, concrete "s" tile roof, 4:12 roof pitch,
decorative foam trim elements and panel type shutters, wrought iron
accents, arched elements, decorative foam, front porches and stone
veneer.
|
•
|
Craftsman. Smooth stucco finish, concrete flat tile roof, 5:12
roof pitch, wood fascias, enhanced outlookers and wood braces, board
and batten siding, foam trim, tapered porch columns with stone base,
wood railings and shutters, and decorative carriage style garage doors.
|
Other architectural styles may be considered at the discretion
of the director of planning, provided specific details unique to the
proposed architectural style and elevation are incorporated. Articulation
must be provided on all sides of the homes so that each side of each
product provides specific features of the proposed architectural style.
Each of the proposed styles must be differentiated from the others
through the use of door and window types, window and door trim, garage
door design, materials such as stone, roof type and pitch, shutters
and the overall silhouette. In addition, elevations that are visible
from a public street or an open space must incorporate architectural
enhancements.
(Ord. 12-01 § 3)