[R.O. 2009 § 17.14.010; Ord. No. 5961 §§I, VI 8-25-2014; Ord. No. 6220, 4-26-2021]
It is the purpose and intent of this Chapter to allow the placement of Class A manufactured homes within this district to increase the options available for low to moderate income households in select residential areas of the City. The placement of manufactured housing would be permitted subject to the requirements and procedures set forth herein. Single ownership of the lot and manufactured housing unit must be demonstrated before a building permit will be issued, and in no case shall a manufactured home pad or lot be rented out in this district.
[R.O. 2009 § 17.14.020; Ord. No. 5961 §§I, VII 8-25-2014; Ord. No. 6220, 4-26-2021]
A. 
In District "R-3," no building, structure or premises shall hereafter be erected, constructed, reconstructed or altered, located, or relocated except for one (1) or more of the following uses:
1. 
Any use permitted in Districts "R-1" or "R-2."
2. 
Class A manufactured home unit as defined by this regulation, and installed per regulations established by the City of Sikeston, and the Missouri Public Service Commission.
[R.O. 2009 § 17.14.030; Ord. No. 5961 §§I, VIII 8-25-2014; Ord. No. 6220, 4-26-2021]
All conditional uses permitted in Districts "R-1" and "R-2" are also permitted in this district subject to the same provisions for application for placement or relocation of manufactured housing on appropriately zoned lots, review and approval, except that the provisions for zero lot line construction will not be permitted for the installation or construction of manufactured housing.
[R.O. 2009 § 17.14.040; Ord. No. 6220, 4-26-2021]
A. 
In District "R-3," the height and area regulations for District "R-2" shall apply to all conventionally built structures. The following additional height and area provisions shall apply to manufactured housing units hereafter erected, constructed, reconstructed or altered within this district. Also See Reference Table 450.1, set out as Exhibit A to this Ch. 405.
1. 
Yard And Area Regulations. Placement of the manufactured housing unit on a lot within this district shall be made only after the submission and approval of a site plan detailing the precise location of the housing unit in relation to all property lines, rights-of-way and easements. In no case will less than fifty percent (50%) of the lot be allocated for the placement of yards and open spaces in order to comply with the spirit and intent of yard and area requirements established for residential districts. The rulings and decisions of the City Zoning Officer in these matters are final except as provided for in Article V "Board of Adjustment" of this Chapter.
2. 
Building Height. In District "R-3," no building manufactured housing unit shall hereafter be erected or structurally altered to exceed one (1) story or sixteen (16) feet in height.
[Ord. No. 5961 §§I, IX, 8-25-2014; Ord. No. 6220, 4-26-2021]
A. 
All manufactured homes located within the City of Sikeston shall be set upon a permanent foundation properly designed and enclosed in accordance with the International Building Code.
1. 
Manufactured homes shall be attached to a permanent footing, which manner of placement shall be as stated on the building permit, and meet all manufacturer's specifications for support.
a. 
Pier pads are not permitted.
b. 
All footings shall have reinforced steel, as dictated by appropriate building codes.
c. 
A minimum of eighteen (18) inches of crawl space must be maintained under the entire manufactured unit.
B. 
Manufactured home anchors shall be embedded in the footing or foundation to HUD, Missouri Public Service Commission and manufacturer's specifications.
C. 
Within ninety (90) days of the manufactured home's setup, underpinning shall be installed in such a way that all areas directly under the home are enclosed.
1. 
Underpinning shall be similar in appearance to materials used for the siding of the manufactured home to which it is attached.
2. 
Said underpinning/foundation shall have permanently installed venting in accordance with the manufacturer's specifications. Deletions or omissions of vents are not allowed, and homes will not be approved for occupancy without appropriate venting.