[R.O. 2009 § 17.18.010; Ord. No. 6220, 4-26-2021]
The intent of this district is to provide for a variety of housing
types ranging from single-family units to apartment buildings. This
district is designed to create a buffer between lower density one-
and two-family districts and more intensive uses of land such as commercial
and industrial developments.
[R.O. 2009 § 17.18.020; Ord. No. 6220, 4-26-2021]
A. In District "R-5," no building or land shall be used and no building
shall hereafter be erected, constructed, reconstructed or altered
except for one (1) or more of the following uses:
1.
Any use permitted by right in Districts "R-1," "R-2" and "R-4";
2.
Multiple-family dwellings;
3.
Boarding or lodging houses;
4.
Convalescent homes, nursing homes or homes for the aged;
6.
Privately operated libraries, museums or mortuaries;
7.
Public or private hospitals, clinics or orphanages; and
8.
Family day care homes in compliance with State Statutes and
local codes.
[R.O. 2009 § 17.18.030; Ord. No. 5327 §III, 5-18-2000; Ord. No. 5961 §§I, XII, 8-25-2014; Ord. No. 6220, 4-26-2021]
A. The following uses may be permitted in District "R-5" after proper application for placement or relocation of manufactured housing on appropriately zoned lots, review and approval pursuant to the provisions of this Section and Article
V, Board of Adjustment, of this Chapter:
1.
Any conditional use provided for in Districts "R-1," "R-2" and
"R-4" except that the provisions for manufactured home Class A units
in District "R-2" shall be limited to the installation or construction
of single-family dwellings as infill development or unit replacement
only.
2.
Single-family attached housing and zero lot line construction as provided for in Chapter
405, Article
VII, Division 15.
[R.O. 2009 § 17.18.040; Ord. No. 6220, 4-26-2021]
A. In District "R-5," any building, dwelling or portion thereof hereafter erected, constructed, reconstructed or altered shall be subject to the following regulations (for exceptions see Article
VIII "Height And Area Exceptions" of this Chapter): Also See Reference Table 450.1, set out as Exhibit A to this Ch.
405.
1.
The minimum lot area in District "R-5" shall provide five thousand
(5,000) square feet for single-family detached units, two thousand
seven hundred fifty (2,750) square feet for each unit in a two-family
structure and three thousand (3,000) square feet for each unit in
a multi-family structure.
2.
The minimum lot width in District "R-5" shall not be less than
seventy-five (75) feet at the building line; except that where a lot
has less width than herein required and in separate ownership at the
time of passage of this Chapter, this regulation shall not prohibit
the erection of a one-family dwelling.
3.
Yards. All buildings in District "R-5" hereafter erected or structurally altered shall comply with the front, rear and side yard regulations of District "R-1," except as provided for in Article
VIII of this Chapter.
4.
Building Height. In District "R-5," no building shall hereafter
be erected or structurally altered to exceed three (3) stories or
forty (40) feet in height, provided that the requirements established
in the current City Building Code are complied with, otherwise the
maximum height for this district shall be the same as District "R-4."
[Ord. No. 5961 §§ I, XIII, 8-25-2014; Ord. No. 6220, 4-26-2021]
A. All manufactured homes located within the City of Sikeston shall
be set upon a permanent foundation properly designed and enclosed
in accordance with the International Building Code.
1.
Manufactured homes shall be attached to a permanent footing,
which manner of placement shall be as stated on the building permit,
and meet all manufacturer's specifications for support.
a.
Pier pads are not permitted.
b.
All footings shall have reinforced steel, as dictated by appropriate
building codes.
c.
A minimum of eighteen (18) inches of crawl space must be maintained
under the entire manufactured unit.
B. Manufactured home anchors shall be embedded in the footing or foundation
to HUD, Missouri Public Service Commission and manufacturer's specifications.
C. Within ninety (90) days of the manufactured home's setup, underpinning
shall be installed in such a way that all areas directly under the
home are enclosed.
1.
Underpinning shall be similar in appearance to materials used
for the siding of the manufactured home to which it is attached.
2.
Said underpinning/foundation shall have permanently installed
venting in accordance with the manufacturer's specifications. Deletions
or omissions of vents are not allowed, and homes will not be approved
for occupancy without appropriate venting.