The I General Industrial District is intended to provide for
areas in the Town which industrial, manufacturing or other materials
handling, processing and/or storage activities may take place with
maximum economic and environmental feasibility and with minimum negative
impact on residential, agricultural and commercial development. In
an I General Industrial District, no building or premises shall be
used except for the following.
A. Permitted uses.
(1) Uses requiring a standard permit (permitted by right): no uses are
permitted by right.
(2) Uses requiring site plan approval:
(a)
Manufacturing, assembling, converting, altering, finishing,
cleaning, recycling, or any other processing and incidental storage
of products and materials, including but not limited to greenhouses
for the growing or the cultivation of delicate or out-of-season plants.
[Amended 5-19-2021 by L.L. No. 3-2021]
(b)
Wholesaling, storage and warehousing.
(c)
Junkyards and dismantlers.
(e)
Truck and rail terminals and port facilities, including docking,
fueling, loading and unloading.
(g)
Waste storage and/or treatment facilities.
The minimum lot area and dimensions shall be as follows: Refer
to Development Standards in the Schedule of District Regulations for
additional Standards.
A. Area: 80,000 square feet unless otherwise provided for specific uses
or by the Planning Board during site plan review. The minimum area
is not intended to be the result of multiplying the minimum width
times the minimum depth. (Irregular lot size)
D. Yards (distance from any lot line to any building):
(1) Front: 75 feet from the right-of-way or 108 feet from the center
of the road, whichever is greater.
(2) Side: 50 feet. An additional 20 feet must be added to this requirement
if the property is abutting a residential district boundary.
(3) Rear: 50 feet. An additional 20 feet must be added to this requirement
if the property is abutting a residential district boundary.
E. Lot coverage: 35% of the total lot area may be covered by buildings.
The building limitations shall be as follows: