Unless otherwise provided by ordinance, any street constructed
within the City shall conform to the standards and specifications
set out in this article.
The sideline of all streets (and the center line where required
by the City Engineer) shall be marked by monuments at the beginning
and end, and at all angles, curves and points of intersection, with
each such monument to conform to the following requirements:
A. The monument shall be not less than 36 inches (91.4 cm) in length,
not less than five inches (12.7 cm) square at the top, and not less
than six inches (15.2 cm) square at the bottom.
B. The point of the monument shall be marked on a copper, brass or stainless
steel rod embedded in the monument.
C. The monument shall be set in concrete under the supervision of the
City Engineer and shall conform to specifications on file in the office
of the City Engineer.
No person shall remove, deface or change the horizontal or vertical
location of, or otherwise disturb, any monument erected for the purpose
of designating the boundary or grade of any street, public place,
or private property, or any point established with horizontal or vertical
controls.
The roadway area of the street shall be paved for its entire
width, from curb to curb, such paving to be not less than eight inches
(20.3 cm) thick and to conform to specifications on file in the office
of the City Engineer.
Sanitary sewer lines, storm drains and storm sewer lines shall
be installed at such locations as are specified by the City Engineer
or the Planning Board, the size and design thereof to conform to specifications
on file in the office of the City Engineer.
Any person who violates any provision of this article shall,
upon conviction thereof, be punished by a fine not to exceed $500
or by imprisonment for a term not exceeding 90 days, or both.