The Intermediate Commercial (C-2) District is intended to provide
a commercial zoning district that meets the community-wide needs for
general retail and services. This district's regulations allow for
the establishment of small to moderate commercial uses in structures
generally consisting of a footprint of no larger than 7,000 square
feet without becoming overly intrusive to surrounding areas. The district
should enhance the overall image of the Town through aesthetics, site
layout, access management, and residential buffering.
Where the standards of the C-2 District conflict with other
regulations of the Town of Elma Code, the more restrictive standards
shall apply.
The following is a list of uses that are permitted within the
C-2 District. The maximum building footprint shall be 7,000 square
feet, with the total area of the building not to exceed 10,000 square
feet (two-story maximum).
A. Principal.
(1) Any use permitted under the C-1 District.
(2) Residential on the upper floors of an approved commercial use, limited
to two dwelling units.
[Amended 2-4-2015 by L.L.
No. 1-2015]
(3) Personal service establishments, including but not limited to beauty
salons, barbershops, minor appliance/electronic repair, laundromats,
and dry cleaners.
(4) Food, drug, and convenience stores.
(6) Nurseries and greenhouses.
(7) Art, dance, music, or photography studios.
(8) Mortuary or funeral parlors.
B. Accessory.
(1) Uses and structures customarily incidental to permitted uses.
(2) Private garages, barns, or sheds with a maximum size of 250 square feet. (Refer to §
144-17, Accessory buildings.)
(3) Temporary food or agricultural stands. (Refer to §
144-14, Farm produce stands.)
(4) Outside storage of a single commercial vehicle, provided it is stored
on the property for which it serves, is not used as signage for the
business when stored, and is not stored within the required front
yard of a lot.
To ensure that certain undesirable uses are not allowed in the
C-2 District, in the case that there is some indecision on a permitted
use, or to ensure that a special use permit is not granted, the following
is a list of uses that are specifically prohibited within the C-2
District:
A. Principal.
(1)
Truck terminals and wholesale or retail distribution centers.
(2)
Any industrial manufacturing use.
(5)
Any outside storage of construction vehicles, building equipment,
or building contractor supplies.
The minimum lot dimensions for permitted uses and structures
in the C-2 District shall be as follows:
A. Minimum lot dimensions.
(1)
All lots shall have a minimum lot width of 100 feet as measured
at the street right-of-way.
(2)
All lots shall have a minimum lot depth of 300 feet.
(3)
The minimum lot size shall be 30,000 square feet.
B. Maximum lot coverage.
(1)
All buildings, structures, and impervious surfaces (parking
areas, driveways, and other paved surfaces) contained on a lot shall
have a maximum total lot coverage of 75%.
C. Maximum height. The height regulations herein shall supersede §
144-95, Building height, for structures in the C-2 District only and shall constitute the maximum height for any new structure in the C-2 District:
(1)
All principal structures: 35 feet to the peak and not to exceed
two stories.
(2)
All accessory buildings: 18 feet to the peak and not to exceed
one story.
D. Required yards. The following table identifies the minimum setbacks required for new structures within the C-2 District. Refer to Article
XVI, Multiple Dwellings, for required yards of multiple-family developments.
Use
|
Yards
|
From an Abutting Residential Zoning District
or an Abutting Existing Residential Use
(regardless of zoning district)
|
---|
Front
|
Rear
|
Side
|
---|
Residential uses
|
50 feet
|
Principal uses: 10 feet
|
Principal uses: 10 feet on each side
|
No additional setbacks required
|
|
|
Accessory uses: 10 feet
|
Accessory uses: 10 feet on each side
|
|
All other uses
|
50 feet
|
Principal uses: 10 feet
|
Principal uses: 10 feet on each side
|
Principal uses: 30-foot rear setback abutting such
and 20-foot setback on each side abutting such
|
|
|
Accessory uses: 10 feet
|
Accessory uses: 10 feet on each side
|
Accessory uses: 20-foot rear setback abutting such
and 10-foot setback on each side abutting such
|
In addition to the general standards outlined in this section,
all development within the C-2 District, with the exception of single-
and two-family residential and agricultural structures, shall conform
to the Town's Design Guidelines, where applicable (copy to be obtained
from the Town).
A. Architecture; general design.
(1)
The architecture, design, and layout of the site is subject
to review by the Planning Board and generally should promote the character
of a community commercial node that is not overly intrusive to adjacent
residential neighborhoods.
(2)
The applicant shall submit building plans and elevations showing
how any proposed structure conforms to and enhances the character
of the neighborhood and, if applicable, meets the specific requirements
of any overlay district.
(3)
Buildings that are designed around a corporate image or franchise
design are discouraged. The architecture and design of buildings shall
take on a character unique to the Town of Elma.
(4)
Buildings intended for use by multiple tenants should be designed
in such a way to avoid the appearance of a long strip plaza and should
contain features such as variations in scale and design and should
incorporate breaks in the building that contain landscaped areas,
gathering spaces, or architectural amenities.
(5)
The side of a building that fronts a street shall not consist
of a blank, monotonous wall that would not meet the neighborhood character
intent. Strategies that could be applied to a building facade to improve
its appearance include incorporating recesses and projections, alternating
roof lines and pitches, varying building materials, colors, and/or
designs, and street-level windows.
(6)
All rooftop HVAC units, communications equipment, or other rooftop
equipment shall be screened from view at ground level by use of building
and/or roof features compatible with the design of the building.
(7)
In general, at least 25% of any side of a nonresidential building
that faces the street shall consist of windows.
B. Site layout.
(1)
For lots that are developed with a single building, the building
shall be oriented towards, and have a front entrance facing, the street
on which the building fronts. When a building fronts more than one
street, the building should be oriented towards, and have a front
entrance facing, the street on which adjacent buildings with similar
uses front.
(2)
Lots developed with multiple buildings or intended for multiple
tenants shall be well planned to create interconnection and unity
of the site and avoid the scattered, disconnected layout of buildings.
(3)
Pedestrian walkways shall be installed between principal buildings,
or in the case of a multitenant building, between leasable entrances,
on a single site and shall be constructed of concrete, decorative
brick, or other material approved by the Planning Board.
C. Parking, driveway, and loading areas. In addition to the regulations defined in Article
IV, Off-Street Parking, any parking and/or loading area within a C-2 Zoning District shall meet the following:
(1)
All required parking, driveways, and loading ingress and egress
areas shall be paved with blacktop, concrete, or other acceptable
dust-free paving material.
(2)
Parking and loading areas must be set back from the street right-of-way
a minimum of 10 feet and shall be set back from the rear and side
property line a minimum of two feet, except in the case of shared
access.
(3)
Parking and loading areas shall be screened according to §
144-44E(3).
(4)
Driveways providing ingress and egress from parking and/or loading areas are subject to §§
144-33 and
144-44E(4).
D. Landscaping/screening. Any permitted use developed within the C-2
District shall conform to the following:
(1)
Existing natural vegetation and trees shall be preserved to
the greatest extent practicable. Other landscaping treatments such
as trees and shrubbery shall be located as directed by the Planning
Board through site plan review to achieve the desired character and
conformance with the surrounding, properties.
(2)
A minimum of 10% of the area devoted to parking shall consist
of landscaping, subject to the approval of the Planning Board.
(3)
The placement of landscaping is encouraged within islands and
along the periphery of the parking areas, within the front and side
yards, and around the building.
(4)
The required yard for any use abutting a Residential A, Residential B, or Residential C and Agricultural Zone, or any use abutting an existing residential use, shall be as identified in §
144-86.2D. Required yards shall consist of natural vegetation and undisturbed greenspace. If the Planning Board determines that the natural vegetation within the required yard does not provide a sufficient buffer, it may require additional screening by earthen berm, landscaping, masonry wall, fence, or other screening.
(5)
Trash containers, dumpsters, storage areas, and HVAC and mechanical
equipment shall not be located within the required front, side, or
rear setback and shall be screened from public view by fencing or
continuous landscaping.
E. Signage. Signage shall conform to the regulations defined in §
144-102.1, Signs.
(1) No digital signs other than static images.
[Added 10-19-2011]
F. Access management. The objective of access management is to reduce
the number of conflict points and to ensure vehicular and pedestrian
safety.
(1)
Shared access and cross access of adjacent lots is encouraged,
subject to Planning Board review, to reduce the number of curb cuts
and provide access control.
(2)
The location and number of access points are subject to the
review and approval of the Planning Board, Town Engineer and, when
appropriate, the Town Highway Superintendent.
(4)
Access management should reference the NYSDOT Best Practices
in Arterial Management.
G. Other. Any permitted use developed within the C-2 District shall
conform to the following additional provisions:
(1)
The placement of lighting on the site shall be subject to review
of the Planning Board to ensure site lighting is directed away from
adjacent properties and does not produce night glow. The use of LED
lighting is encouraged.
(2)
Site lighting shall consist of cut-off, shielded, or directional
lighting fixtures. The use of LED lighting is encouraged.
(3)
The intensity of light at the perimeter of the site shall not
exceed 0.1 footcandle.
The Planning Board will require, as a condition of site plan
approval, that the applicant file a two-year maintenance bond, in
such amount as determined by the Town Planning Board, to insure that
the proposed development's required landscaping is maintained in compliance
with approved plans. An estimate of the value of the landscaping will
be required as part of the site plan approval so that an amount can
be determined for the bond.