[Ord. No. 2289 §1, 9-19-2006; Ord. No. 2464 §1, 1-20-2009]
A.
For the purpose of establishing rules and regulations for the construction, alteration, repair, removal, demolition, equipment, use and occupancy, location and maintenance of buildings and structures, including administration and permits, the City of Parkville hereby adopts the following administrative and technical codes, including appendices specified herein, in their entireties, except as otherwise amended. Said amendments are detailed in adopted exhibits and summarized in the Residential and Commercial Guidelines of the City of Parkville, all of which are incorporated herein by reference, and which are on file in the Department of Community Development. The following codes and specified appendices, and amendments and guides adopted by reference, are hereby designated as the Building Code of the City of Parkville.
1.
The 2018 International Building Code, as amended, including the following appendices:
2.
The 2018 International Residential Code for One- and Two-Family Dwellings, as amended, including the following appendices:
a.
Appendix A — Sizing and Capacities of Gas Piping.
b.
Appendix B — Sizing of Venting Systems Serving Appliances Equipped with Draft Hoods, Category 1 Appliances, and Appliances Listed for Use and Type B Vents.
c.
Appendix C — Exit Terminals of Mechanical Draft and Direct-Vent Venting Systems.
d.
Appendix D — Recommended Procedure for Safety Inspection of an Existing Appliance Installation.
e.
Appendix E — Manufactured Housing Used as Dwellings.
f.
Appendix F — Radon Control Methods.
g.
Appendix G — Swimming Pools, Spas and Hot Tubs.
h.
Appendix H — Patio Covers.
i.
Appendix J — Existing Buildings and Structures.
j.
Appendix K — Sound Transmission.
k.
Appendix L — Permit Fees.
l.
Appendix N — Venting Methods.
m.
Appendix O — Automatic Vehicle Gates.
3.
The 2018 International Mechanical Code, as amended.
4.
The 2018 International Plumbing Code, as amended.
5.
The 2018 International Fuel Gas Code, as amended, including the following appendices:
a.
Appendix A — Sizing and Capacities of Gas Piping.
b.
Appendix B — Sizing of Venting Systems Serving Appliances Equipped with Draft Hoods, Category I Appliances, and Appliances Listed for Use and Type B Vents.
c.
Appendix C — Exit Terminals of Mechanical Draft and Direct-Vent Venting Systems.
d.
Appendix D — Recommended Procedure for Safety Inspection of an Existing Appliance Installation.
6.
The 2018 International Fire Code, as amended.
7.
The 2018 National Electrical Code, as amended.
8.
The 2018 International Swimming Pool and Spa Code, as amended.
9.
ICC A117.1-2017 Accessible and Usable Building and Facilities.
[1]
Editor's Note: Amendments to the technical codes adopted by Ord. No. 3027 were attached to said ordinances and incorporated herein by reference and held on file in the City offices.
B.
Where, in any specific case, the Building Code specifies different material, methods of construction or other requirements, the most restrictive shall govern. Where there is a conflict between a general requirement and a specific in the Building Codes, the specific requirement shall be applicable.
C.
Where, in any specific case, a structure or construction shall be located in more than one jurisdiction with authority, the most restrictive Building Code shall apply.
[Ord. No. 2653 §1, 10-2-2012]