Where the map is located within a one-quarter section, the corners of which have been located, monumented, and placed on the State Plane Coordinate System through high order horizontal control surveys conducted to standards established by the Southeastern Wisconsin Regional Planning Commission, the map shall be tied directly to two adjacent section or quarter section corners defining a quarter section line so located, monumented, and placed on the State Plane Coordinate System. The grid bearing and distance of each tie shall be determined by field measurements. The Wisconsin State Plane Coordinates, together with a description, of the monuments marking the section or quarter section corners to which the map is tied shall be shown on the map. All distances and bearings shall be referenced to the Wisconsin State Plane Coordinate System, South Zone, based upon the North American Datum of 1927, and shall be adjusted to the control survey network established to the standards promulgated by the Southeastern Wisconsin Regional Planning Commission for the area concerned. Where the field measurements differ from the control survey data by more than one part in 10,000, in the alternative to adjusting the field measured distances and bearings of the ties to the control survey network, the surveyor shall show both the measured field distances and bearings and the recorded and published control survey distances and bearings concerned. Under this alternative, the discrepancies shall be brought to the attention of the custodian of the control survey data for the area concerned by the surveyor. All distances shall be recorded to the nearest 0.01 foot and all bearings to the nearest one second of arc. The grid bearing and distance of the tie shall be determined by a closed survey meeting the error of closure herein specified for the survey of the exterior boundaries of the certified survey map.