For the purpose of this chapter, the City of Hackensack is hereby divided into the following types of districts, differentiated according to use, area and bulk regulations, designated as follows:
A. 
R-100 Single-Family.
B. 
R-75 Single-Family Residential.
C. 
R-60 Single-Family Residential.
D. 
R-50 Single-Family Residential.
E. 
R-2 Single- and Two-Family residential.
F. 
R-2B Single-, Two-Family and Townhouse.
G. 
R-3A Medium-Density Multifamily Residential.
H. 
R-3B Medium-Density Multifamily and Offices.
I. 
R-3 High-Density Multifamily Residential.
J. 
R-4 Transitional Density Residential.
K. 
B-1 Neighborhood Business.
L. 
B-2 Central Business District.
M. 
B-3 General Business.
N. 
B-4 Shopping Center District.
O. 
UN University Office.
P. 
HRO High-Rise Office.
Q. 
O Office.
R. 
M-1 Manufacturing.
S. 
OD Overlay District.
The location and boundaries of said districts are hereby established on the current Zoning Map of the City of Hackensack, as may be amended or supplemented, which is hereby made a part of this chapter.[1] Said map or maps and all notations, references and designations shown thereon shall be, as such, a part of this chapter as if the same were all fully described and set forth herein.
[1]
Editor's Note: The Zoning Map is included as an attachment to this chapter.
A. 
Designation of zone boundaries. The zone boundary lines are intended generally to follow the center lines of streets; the center lines of railroad rights-of-way; existing lot lines; the center lines of rivers, streams and other waterways; and municipal boundary lines. When a district boundary line does not follow such a line, its position shall be shown on the Zoning Map by a specific dimension expressing its distance, in feet, from a street line or other boundary line as indicated.
B. 
Determination of doubtful lines. In cases of uncertainty or disagreement as to the true location of any zone boundary line, the determination thereof shall lie with the jurisdiction of the Board of Adjustment.
C. 
Split-zone lots. Where one or more district boundary lines pass through a lot which is the subject of an application for development, causing a circumstance commonly referred to as split-lot zoning or a split-zone lot, the applicant must comply with the requirements of each zone affecting the lot in accordance with the intersection of those zone district boundaries with the lot in question. Any deviation from the requirements of one or more zone districts affecting the lot shall require relief from the Planning Board or the Zoning Board of Adjustment according to the Municipal Land Use Law.[1]
[Amended 4-25-2023 by Ord. No. 12-2023]
[1]
Editor's Note: See N.J.S.A 40:55D-1 et seq.
D. 
Where a district boundary line is shown as approximately parallel to a street or highway, such boundary shall be construed as being parallel thereto and at such distance from the nearest right-of-way line as indicated on the Zoning Map.