A.
Purpose. In order to provide adequate space for access of light and circulation of air, to facilitate the prevention and fighting of fires, to prevent undue concentration of population, and to lessen congestion on streets, no building or premise shall be erected, altered, or used except in accordance with the standards set forth herein.
B.
Bulk requirements. Table I, "General Use and Bulk Requirements,"[1] contains regulations affecting the bulk and arrangement of buildings and structures, the density of residential and nonresidential development and of materials and equipment occupying land in connection with nonbuilding uses thereof for each of the districts established by Article III.
[1]
Editor's Note: Said table is included as an attachment to this chapter.
C.
Existing lots of record. For the purposes of this Zoning Chapter:
(1)
Two or more contiguous noncomplying vacant parcels of land in common ownership on or after the effective date of this Zoning Chapter shall be deemed to be merged to form one or more lots complying so far as possible to the bulk standards of the district in which the parcels are located. The lots shall be merged so as to reduce the degree of noncompliance and to create lots that comply with the use and bulk requirements of the applicable zoning district.
(2)
One or more vacant parcels of land that adjoin a noncomplying lot in common ownership on or after the effective date of this Zoning Chapter and containing a building or structure shall be deemed to be merged with said improved lot to the extent necessary to bring the improved lot into compliance so far as possible. If any remaining vacant parcel(s) constitutes a complying lot, said parcel(s) shall remain a separate lot. Otherwise, the merged lots shall constitute one lot.
(3)
No lot so merged, or portion thereof, may be subdivided in any manner that will create or increase the degree of noncompliance.
D.
Grandfathering of lots to be used for the construction of single-family detached dwellings. Any lot in existence prior to the effective date of this Zoning Chapter, which did not adjoin another lot in common ownership and does not presently adjoin a lot in common ownership, and whose lot area, lot width, and/or lot depth are less than the minimum lot requirements for the district in which it is located, may be considered as complying with the minimum lot area requirements, and no variance shall be required, and a single-family detached dwelling only may be constructed, provided that:
(1)
Single-family detached dwellings are a permitted use in the zoning district in which the dwelling would be located.
(2)
The lot has a minimum lot area of 10,000 square feet and a minimum lot width of 75 feet.
(3)
Any such single-family detached dwelling shall conform with all yard, floor area ratio, impervious coverage and building height requirements of the district with a minimum lot area requirement in which the lot would conform in descending order from the largest to smallest lot area.
(4)
The dwelling can be served by water supply and wastewater facilities which meet health department standards for said facilities.
E.
Existing average density (cluster) developments. Any lot located within a residential subdivision that was approved prior to the effective date of this Zoning Chapter and platted in accordance with Section 278 of the New York State Town Law shall be developed in accordance with the bulk requirements set forth on the residential subdivision plat. The bulk requirements on the cluster subdivision plat shall supersede the bulk requirements applicable to the zoning district within which said lot is located.
F.
Planned integrated development (PID) bulk standards. Any PID which receives special use permit approval from the Town Board and which special use permit has not expired shall be subject to the bulk requirements and design standards contained in the special use permit. Unless regulated therein, the provisions of this Zoning Chapter shall govern.
