Note: §§ 20.36.010—20.36.100 and §§ 20.36.130—20.36.150, derived from Prior code §§ 2-12.75—2-12.84, 2-12.87—2-12.89 and Ord. 1393, Ord. 1719, Ord. 2000, Ord. 1869, Ord. 2015, were repealed by Ord. 2299, 10/21/2025.
Section 101.3 Scope is amended by deleting item D, and re-numbering remaining items to read as follows:
Each exterior door shall be secured as follows:
A. 
Exterior doors (excluding glass patio doors) and doors leading from garage areas into dwelling shall be of solid core no less than one and three-eighths inch thickness.
B. 
Exterior doors leading from outside to interior of attached garage shall be of solid core no less than one and three-eighths inch thickness.
C. 
Exterior doors (excluding glass patio doors) and doors leading from garage areas into dwellings shall have a self-locking lock with deadlatch.
D. 
The deadlatch lock and dead bolt lock on the same door shall be keyed alike (one key will fit both locks).
E. 
Pairs of doors shall have flush bolts with a minimum throw of five-eighths inch at the head and foot (floor and ceiling) of the inactive leaf.
F. 
Doorstop on a wooden jamb for an in-swing door shall be of one-piece construction with the jamb joined by a rabbet.
G. 
Nonremovable pin or interlocking stud-type hinge shall be used in pin-type hinge which is accessible from the outside when the door is closed.
H. 
Cylinders shall be so designed or protected that they cannot be gripped by pliers or other wrenching devices.
I. 
The lock or locks shall be operated from the inside of the door by a device not requiring a key.
J. 
Locks shall be provided on all sliding patio doors.
K. 
Sliding patio glass doors opening onto patios or balconies which are less than one story above grade or are otherwise accessible from the outside shall have the moveable section of the door sliding on the inside of the fixed portion of the door or possess an approved secondary lock mounted on interior of moveable section.
L. 
The lock bolt on all glass patio doors shall engage the strike sufficiently to prevent its being disengaged by any possible movement of the door within the space or clearance provided for installation and operation. The strike area shall be of material adequate to maintain effectiveness of bolt strength.
(Prior code § 2-12.86; Ord. 2197 § 2, 2019; Ord. 2241 § 2, 2022)