The F overlay zone is intended as a zone to address the ability
to construct and maintain limited fences in street setback areas in
appropriate neighborhoods in residential zones in the North Glendale
Community Plan area in a manner conducive to the public health, safety
and general welfare.
(Ord. 5761, § 6, 2011)
The provisions of the zone underlying the F overlay zone shall
apply except as provided in this chapter.
(Ord. 5761, § 6, 2011)
A fence overlay zone may be designated when:
A.
A minimum
of one block on at least one side of a street from intersection to
intersection; and
B.
Fencing
would not disrupt a visually unified or consistent physical development
pattern.
(Ord. 5761, § 6, 2011)
Notwithstanding any other provisions of this title, the following
additional criteria shall apply to any fence or gate in the street
front setback area or in the street side setback area in the F overlay
zone:
A.
Fences and gates located within the street front or street side setback
area shall be located on private property and shall be at least five
feet from the back of the street curb or roadway pavement (where no
curb exists) and shall not exceed a height, at any point, of 42 inches;
B.
Fences and gates shall utilize an open design along their entire
length in any street front or street side setback area where a minimum
of 50 percent of the fence area is open for any four-foot section
of fence;
C.
No fence or gate shall be electrically charged or made of any sharp-edged
materials, barbed wire, razor wire, chicken wire, chain link, fiber
glass, plain smooth block or painted block;
D.
No fence or gate shall be installed or maintained across a driveway
in any street front or street side setback area; and
E.
All fences and gates shall be maintained in good condition and shall
be kept free of rust, flaking paint, and graffiti. Deteriorated materials
shall be repaired or removed.
(Ord. 5761, § 6, 2011; Ord. 6027, 5/14/2024)
