The Township shall require haulers of industrial waste to obtain wastewater discharge permits. The Township may require generators of hauled septage and industrial waste to obtain wastewater discharge permits. The Township also may prohibit the disposal of hauled septage and industrial waste. The discharge of hauled septage and industrial waste is subject to all other requirements of this part.
Septage and industrial waste haulers may discharge loads only at locations designated by the Township. No load may be discharged without prior consent of the Township. The Township may collect samples of each hauled load to ensure compliance with applicable standards. The Township may require the septage and industrial waste hauler to provide waste analysis of any load prior to discharge.
Septage and industrial waste haulers must provide a waste-tracking form for every load. This form shall include, at a minimum, the name and address of the septage and/or industrial waste hauler, permit number, truck identification, names and addresses of sources of waste and volume and characteristics of waste. The form shall identify the type of industry, known or suspected waste constituents and whether any wastes are RCRA hazardous wastes.
Any tank truck or any other equipment used or intended to be used within the Township for the removal and/or transportation of domestic waste and/or industrial waste shall conform to the following requirements:
A. 
The container shall be watertight.
B. 
Tanks, containers or other equipment shall be so constructed that every portion of the interior and exterior can be easily cleaned and shall be kept in a clean and sanitary condition.
C. 
Piping, valves and permanent or flexible connections shall be accessible and easily disconnected for cleaning purposes.
D. 
The inlet opening, or openings, to every container shall be so constructed that the material will not spill out during filling, transfer or transport.
E. 
The outlet connections shall be so constructed that no material will leak out or run out to other than the point of discharge, and shall be of a design and type suitable for the material handled and capable of controlling the flow or discharge without spillage, undue spray or flooding of immediate surroundings while in use.
F. 
No connections shall be made at any time between a tap or outlet furnishing potable water on any premises and any container equipment holding material by any means other than an open connection.