A. 
Purpose. The purpose of this chapter is:
1. 
To protect the public potable water supply of Valley Center, Kansas from pollution or contamination due to cross-connection;
2. 
To prohibit and eliminate all cross-connections within the public potable water supply system; and
3. 
To provide for the maintenance of a continuing effective cross-connection control program and thus protect the public health.
B. 
Responsibility. The city superintendent shall be responsible for effectively conducting the cross-connection control program of the Valley Center, Kansas, public potable water supply. If in the judgement of said city superintendent an approved backflow prevention device is required the city superintendent or his agent will give notice in writing to the customer to install the proper device. The customer shall immediately install the proper device at the customers expense. Failure to comply shall be grounds for discontinuing water service to said customer until the device is properly installed.
(Ord. 765 § 1, 1990; Ord. 1317, 2-20-2018)
As used in this chapter:
1. 
"Agency"
means the department of the municipal government or water purveyor invested with the responsibility for enforcement of this chapter.
2. 
"Air gap"
means the unobstructed vertical distance at least twice the diameter of the supply line and no less than one inch, through the free atmosphere between the lowest opening from any pipe or faucet supplying water to a tank, plumbing fixture, or other device and the flood level rim of the receptacle.
3. 
"Approved device"
means devices tested and accepted by a recognized testing laboratory approved by the Kansas Department of Health and Environment and the city superintendent.
4. 
"Backflow"
means the flow of water or other substances into the distribution system of a potable supply of water from any source other than its intended source. Backsiphonage is one type of backflow.
5. 
"Backflow preventer"
means a device or approved method to prevent backflow.
6. 
"Backsiphonage"
means the reverse of contaminated or polluted substances from a plumbing fixture or any vessel or source into the potable water supply system due to negative pressure in said system.
7. 
"Contaminant"
means any substance that upon entering the potable water supply would render it a danger to the health or life of the consumer, and potentially others in the public works system.
8. 
"Cross-connection"
means any physical connection or arrangement between two otherwise separate piping systems, one of which contains potable water and the other which contains water or any substance of unknown or questionable quality whereby there may be flow from one system to the other.
9. 
"Double check valve assembly"
means a device consisting of two internally loaded soft seated check valves with positive shut-off valves on both upstream and downstream ends, and properly located test ports.
10. 
"Dual check valve"
means a device consisting of two internally loaded soft seated check valves. This device does not contain test ports and is acceptable for use only at the meter of residential customers, provided that regularly scheduled service proves the device is functioning properly.
11. 
"Flood level rim"
means the edge of the receptacle from which water overflows.
12. 
"Free water surface"
means a water surface at atmospheric pressure.
13. 
"Frost-proof closet"
means a hopper with no water in the bowl and with the trap and water supply control valve located below frost line of the buried hydrant.
14. 
"KDHE"
means the Kansas Department of Health and Environment.
15. 
"Plumbing"
means the practice, materials and fixtures used in the installation, maintenance, extension and alteration of all piping fixtures, appliances and appurtenances.
16. 
"Pollution"
means the presence of any foreign substance (organic, inorganic or biological) in water which tends to degrade its quality so as to constitute a hazard or impair the usefulness or quality of the water to a degree which does not create an actual hazard to the public health but which does adversely affect the water.
17. 
"Reduced pressure zone backflow preventer"
means an approved device of two independently acting soft seated approved check valves together with a hydraulically operating mechanically independent differential pressure relief valve located between the check valves and at the same time below the first check valve. The unit shall contain properly located test cocks and resilient seated shut-off valves at each end of the assembly. To be approved these assemblies must be accessible for inspection and testing and be installed in an aboveground location where no part of the assembly will be submerged.
18. 
"Tester"
means a trained technician certified in the testing and repair of backflow preventers.
19. 
"Vacuum"
means any absolute pressure less than that exerted by the atmosphere.
20. 
"Vacuum breaker"
means a device that permits entrance of air into the water supply distribution line to prevent backsiphonage.
21. 
"Water, Potable."
"Potable water" means water free from impurities in quantities sufficient to cause disease or harmful physiological affect the overall quality of water. Its quality shall conform to Kansas Department of Health and Environment requirements for public water supplies.
22. 
"Water, Nonpotable."
"Nonpotable water" means water that is not safe for human consumption or that is of questionable potability.
(Ord. 765 § 2, 1990; Ord. 1317, 2-20-2018)
A. 
General. A public potable water supply system shall be designed, installed and maintained in such a manner as to prevent cross-contamination from nonpotable sources through cross-connections or any piping connection to the system.
B. 
Cross-connections Prohibited. Cross-connections are prohibited except when and where as approved by the city superintendent suitable backflow preventers are properly installed, tested and maintained to insure proper operation on a continuing basis.
C. 
Interconnections. Interconnection between two or more public water supplies shall be permitted only with the approval of the Kansas Department of Health and Environment. (K.S.A. 65-163[a])
D. 
Individual water supplies. Cross-connections between a private water supply and the public potable water are prohibited. (K.S.A. 65-163[a])
E. 
Connections to boilers. Potable water connections to boiler feed water systems in which boiler water conditioning chemicals are found or can be introduced shall be made through an air gap or through a reduced pressure principle and assembly backflow preventer located in the potable water line before the point where such chemicals may be introduced.
F. 
Prohibited connections. Connection to the public potable water supply system for the following is prohibited unless properly protected by the appropriate backflow prevention device:
1. 
Bidets; should be tempered.
2. 
Operating, dissecting, embalming, and mortuary tables or similar equipment in such installations the hose used for water supply shall terminate at least twelve (12) inches away from every point of the table or attachments;
3. 
Pumps for nonpotable substances. Priming only through an air gap;
4. 
Building drains, sewers, or vent systems;
5. 
Commercial buildings or industrial plants manufacturing or otherwise using polluting or contaminating substances;
6. 
Any fixture of similar hazard.
G. 
Refrigeration unit condensers and cooling jackets. Except when potable water provided for a refrigeration condenser or cooling jacket is entirely outside the piping or tank containing a toxic refrigerant, the inlet connection shall be provided with an approved backflow preventer. Heat exchangers used to heat water for potable use shall be of the double wall type vented to the atmosphere.
H. 
Protective devices required. The type of protective device required under this chapter shall be determined by the degree of hazard which exists as follows:
1. 
Premises having auxiliary water supply shall protect the public system by either an approved air gap or an approved reduced pressure principles backflow prevention assembly.
2. 
Premises having water or substances which would be nonhazardous to the health and well-being of the consumers shall protect the public system with no less than an approved double check valve assembly.
3. 
Premises where material dangerous to health are handled in a manner which creates an actual or potential hazard shall protect the public system by an approved air gap or an approved reduced pressure principle backflow prevention assembly.
4. 
Premises where cross-connections are uncontrolled shall protect the public water supply by installing an approved air gap or an approved reduced pressure principle backflow prevention device at the service connection.
5. 
Premises where because of security requirements or other prohibitions it is impossible to complete an in plant cross-connection inspection, the public system shall be protected by an approved air gap or an approved reduced pressure principle backflow prevention assembly. Premises which may fall into one or more of the above mentioned categories may be, but are not limited to the following:
a. 
Beverage bottling plants;
b. 
Buildings. Hotels, apartments, public or private buildings, or other structures having actual or potential cross connections;
c. 
Car wash facilities;
d. 
Chemical manufacturing, handling, or processing plants;
e. 
Chemically contaminated water;
f. 
Dairies and cold storage facilities;
g. 
Film or photography processing laboratories;
h. 
Fire systems;
i. 
Hospitals, medical centers, morgues, mortuaries, autopsy facilities, clinics, or nursing and convalescent homes;
j. 
Irrigation systems;
k. 
Laundries;
l. 
Metal cleaning, processing, or fabricating plants;
m. 
Oil and gas production, storage, or transmission facilities;
n. 
Packing or food processing plants;
o. 
Paper and paper products plants;
p. 
Power plants;
q. 
Radioactive materials plants or handling facilities;
r. 
Restricted or classified facilities;
s. 
Rubber plants;
t. 
Sand, gravel, or asphalt plants;
u. 
Sewage and storm drainage facilities and reclaimed water systems;
w. 
Solar heating systems;
x. 
Temporary service-fire hydrants, air valves, blow-offs and other outlets;
y. 
Waterfront marinas.
(Ord. 765 § 3, 1990; Ord. 1317, 2-20-2018)
Approved devices shall be installed at all fixtures and equipment where backflow or backsiphonage may occur and where a minimum air gap between the potable water outlet and the fixture or equipment flood level rim cannot be maintained. Backflow and backsiphonage devices of all types shall be in an accessible location. Installation in pits or any other location not properly drained shall be prohibited, except that dual check valves may be installed in the meter box.
A. 
Connections not subject to backpressure. Where a water connection is not subject to back pressure, a vacuum breaker shall be installed on the discharge side of the last valve on the line servicing the fixture or equipment. A list of some conditions requiring protective devices of this kind are given in the following table titled "Cross-Connections Where Protective Devices are Required."
CROSS-CONNECTIONS WHERE PROTECTIVE DEVICES ARE REQUIRED AND CRITICAL LEVEL (C-L) SETTINGS FOR VACUUM BREAKERS
Fixtures or Equipment
Method of Installation
Aspirators and ejectors
C-L at least 6 inches above flood level of receptacle served.
Dental units
On models without built in vacuum breakers C-L at least 6 inches above flood level rim of bowl.
Commercial dish washing machine
C-L at least 6 inches above flood level of machine. Installed on both hot and cold water supply lines.
Garbage can cleaning machines
C-L at least 6 inches above flood level of machine. Installed on both hot and cold water supply lines.
Hose Outlets
C-L at least 6 inches above highest point on hose line.
Commercial laundry machines
C-L at least 6 inches above flood level of machine. Installed on both hot and cold water supply lines.
Lawn sprinklers
C-L at least 6 inches above highest sprinkler head or discharge outlet.
Steam tables
C-L at least 6 inches above flood level rim.
Tanks and vats
C-L at least 6 inches above flood level rim or line.
Through urinals
C-L at least 30 inches above perforated flush pipe.
Flush tanks
Equipment with anti-siphon ball cock, installed according to manufacturer's instruction.
Hose bibs
C-L at least 6 inches above flood level of receptacle served, required on all hose treaded connections.
B. 
Connections subject to backpressure. Where a potable water connection is made to a line, fixture, tank, vat, pump, or other equipment with a hazard of backflow or backsiphonage where the water connection is subject to backpressure, and an air gap cannot be installed, the city superintendent may require the use of an approved reduced pressure principle backflow preventer. A partial list of such connections is shown in the following table "Partial List of Cross-connections Subject to Back Pressure."
WATER SUPPLY-CROSS-CONNECTIONS
PARTIAL LIST OF CROSS-CONNECTIONS
SUBJECT TO BACK PRESSURE
Chemical lines
Pumps
Dock water outlets
Steam lines
Individual water supplies
Swimming pools
Industrial process water lines
Pressure tanks
Tanks and vats — bottom inlets
Hose bibs. PVB or SVB serve perfectly well
C. 
Barometric loop. Water connections where an actual or potential backsiphonage hazard exists may in lieu of devices specified above be provided with a barometric loop which extends above the connection and descends the same to the first outlet. Barometric loops shall precede the point of connection.
D. 
Dual check valve. Dual check valves may be installed at the meter. These valves shall be inspected and repaired not less frequent than every third year. These valves shall be installed only in situations where the city superintendent is assured that only non-contaminating substances are subject to backflow into the potable system.
E. 
Vacuum breakers. Atmospheric vacuum breakers shall be installed with the critical level at least six inches above the flood rim of the fixture they serve and on the discharge side of the last control valve to the fixture and all the downstream piping. No shut-off valve or faucet shall be installed beyond the atmospheric vacuum breaker. Pressure vacuum breakers shall be installed with the critical level at least twelve (12) inches above the flood rim but may have control valves downstream from the vacuum breaker. For closed equipment or vessels such as pressure sterilizers the top of the vessel shall be considered the flood level rim and a check valve shall be installed on the discharge side of the pressure vacuum breaker.
(Ord. 765 § 4, 1990; Ord. 1317, 2-20-2018)
It shall be the responsibility of building and premise owners to maintain all backflow preventers and vacuum breakers within the building or on the premises in good working order and to make sure no piping or other arrangements have been installed for the purpose of bypassing the backflow devices. Testing and repair of these devices should be made by qualified technicians. (Qualified technicians are those technicians who have completed the training acceptable for compliance with this code.) The city superintendent shall certify the device testers after ascertaining the technician meets the above qualifications. The city superintendent will also assure the proper installation of all backflow preventers and will set appropriate testing and rebuild schedules for such devices. Testing intervals shall not exceed one year and rebuild intervals shall not exceed five years.
A. 
Certified Tester/Repair Technicians. All certified test/repair technicians shall be re-certified as tester/repair technicians at the time of the adoption of the ordinance codified in this chapter, shall continue to be certified for a period of not more than three years as determined by the city superintendent.
(Ord. 765 § 5, 1990; Ord. 1317, 2-20-2018)
A. 
The city superintendent shall notify the owner, or authorized agent of the owner, of a building or premises in which there is found a violation of this chapter of such violation. The city superintendent shall set a reasonable time for the owner to have the violation corrected. If the owner fails to correct the violation within the specified time the city shall cease delivery of water to the building or premises until the violation shall be satisfactorily corrected.
B. 
Fines. Anyone convicted of a violation of this chapter after failing to correct said violation following reasonable notice as set out above, shall be fined in an amount not to exceed five hundred dollars ($500.00) and shall be sentenced to serve no more than thirty (30) days of confinement or by both such fine and confinement.
(Ord. 765 § 6, 1990; Ord. 1317, 2-20-2018)