The purpose and intent of these fencing standards is to create aesthetic fencing that is uniform along frontages with characteristics similar to the existing neighborhood. No fence or wall shall create a hazard to the general public.
(Ord. 713-00; Ord. 807-03; Ord. 1246-16 § 2)
Except as otherwise defined in this chapter, all terms shall have the meaning ascribed in Chapter 16.04 SMC.
(Ord. 807-03; Ord. 1246-16 § 2)
A permit is required for all new fences over three feet in height above the ground constructed within the city of Sultan. All permit fence applications shall be accompanied by the required fee and shall include a site plan drawn to scale indicating property lines, easements, abutting rights-of-way, adjacent driveways, location and height of fence and all structures including fire hydrants and power poles within 10 feet of proposed fence.
(Ord. 713-00; Ord. 807-03; Ord. 1246-16 § 2)
A. 
Fences may be installed on property lines in residentially zoned lots; provided, that fences in front yards may not exceed three feet in height. It shall be the property owner's responsibility to determine the location of all property lines.
B. 
Fences installed on or across an easement in favor of the city of Sultan easement shall be removed by the property owner, or may be removed by the city of Sultan, a city agent, or a city contractor at the property owner's expense, upon request of the city for the purposes of the easement.
C. 
The height of all fences within 15 feet of any right-of-way, street, access easement, or driveway or within 25 feet of any intersection of two streets as measured from the edge of the right-of-way shall not exceed three feet, so as to allow a sight clearance triangle as depicted in Figure 15.08-1.
Figure 15.08-1
D. 
A minimum six-foot-high fence with a 16-foot-wide service access shall be placed around open storm drainage retention/detention systems as required by the 2014 Stormwater Management Manual for Western Washington.
E. 
When a retaining wall three feet in height or greater is contiguous to and below a proposed fence, the proposed fence may be constructed for the purposes of safety not greater than four feet above the top of the retaining wall or the finished grade, whichever is less, without a variance.
F. 
Fence height shall be measured from the top of the fence to the lowest grade of the ground on the property owner's side.
G. 
Supporting fence posts shall be installed into the ground at a distance equal to one-third of the distance of the fence height; provided, that supporting fence posts for privacy fence (solid board) shall be installed at a distance equal to 40 percent of the fence height.
H. 
No fence, structure, or landscaping may be constructed or maintained if it creates a safety or sight hazard to users of the street or to nearby property. Electrical, barbed wire, and any material that may cause a safety hazard shall be prohibited, unless the applicant can prove that the fence is necessary for legal nonconforming agricultural uses.
(Ord. 713-00; Ord. 807-03; Ord. 1246-16 § 2)
In all other zones, fences and walls may be installed up to a height of eight feet; provided, that the following requirements are met:
A. 
Where commercially or industrially zoned property has street frontage across from residential property, there shall be a setback of one foot for each foot in height of the fence or wall. This setback will be densely landscaped to provide a vegetative barrier. A landscaping plan will be submitted to and approved by the community development director prior to construction of the fence or wall. All installed landscaping materials will be maintained in a healthy state.
B. 
A landscaped side yard setback area shall not be required for fences or walls if the commercial or industrially zoned property adjoins or abuts similarly zoned property.
C. 
The height of all fences within 15 feet of any right-of-way, street, access easement, or driveway or within 25 feet of any intersection of two streets as measured from the edge of the right-of-way shall not exceed three feet, so as to allow a sight clearance triangle as depicted in Figure 15.08-1.
(Ord. 807-03; Ord. 1246-16 § 2; Ord. 1347-21 § 7)