No vehicle dismantling yard, or junk and salvage yard, or vehicle impounding yard shall be established, maintained or extended in any zone unless it complies with the following requirements:
A.
All operations and storage, including all equipment used in conducting such business, other than parking, shall be conducted within an enclosed building, or within an area enclosed by a solid fence. When two (2) or more vehicle dismantling yards, junk and salvage yards, and/or vehicle impounding yards have a common boundary line, a solid wall or solid fence shall not be required on such common boundary line; provided, however, that a solid wall or solid fence shall enclose the entire combined area devoted to such uses.
B.
Where such fences or walls are provided, other than a decorative wall required pursuant to CMC § 9162.52, they shall be developed as provided herein:
1.
The fences and walls shall be of a uniform height in relation to the ground upon which they stand and shall be a minimum of eight (8) feet and shall not exceed fifteen (15) feet in height. Except in the yard areas where off-street parking is required or provided, said fences or walls shall be set back five (5) feet from the lot line along all frontages abutting a public street or walkway, or abutting a more restrictive zone. This five (5) foot setback area shall be landscaped in a neat, attractive manner and shall be equipped with an irrigation system, permanently and completely installed, which delivers water directly to all landscaped areas. Where off-street parking is required or provided, said wall or fence shall be constructed at the rear of the parking area.
Tall-growing trees shall be planted and maintained along side and rear fences or walls which abut an elevated freeway or residential area, in accordance with a planting plan approved by the Director.
2.
All fences and walls open to view from any public street or walkway or any area in other than an industrial zone shall be constructed of solid masonry, except required fences may be constructed of other material comparable to the foregoing if approved by the Director and in accordance with standards established by resolution of the Council after recommendation by the Commission.
3.
The fences and walls shall be constructed in workmanlike manner, shall be uniform in appearance and shall consist solely of new materials unless the Director approves the substitution of used materials, where, in his opinion, such used materials will provide the equivalent in service, appearance and useful life.
4.
All gates in the fences or walls shall be of solid metal material and shall be no less than eight (8) feet in height and shall not exceed fifteen (15) feet in height. Such gates shall be kept closed when not in use and shall provide a pedestrian access opening unless other pedestrian access is provided.
C.
The entire site shall be paved with an asphalt or concrete surfacing or an oil and aggregate mixture to prevent emulsion of dust or tracking of mud onto public rights-of-way. The site shall be graded to drain to the public street or other drainage provision satisfactory to the Director of Public Works. The Community Development Director shall enforce these dust control standards and may:
D.
The following minimum required off-street parking spaces, and adequate access thereto, shall be maintained on the site:
1.
One (1) off-street parking space (nine (9) feet by twenty (20) feet) for each seven thousand (7,000) square feet of site area or fraction thereof for the first two (2) acres, and two (2) off-street parking spaces for each acre thereafter, to be located outside the walls or fences required by subsection B of this Section and to be in compliance with CMC § 9162.41 through § 9162.7.
2.
One (1) off-street loading area (fourteen (14) feet by forty (40) feet) for each acre of site area or fraction thereof, to be located within the walls or fences required by subsection B of this Section.
3.
Regardless of the size of the site, a minimum of five (5) parking spaces plus one (1) loading area shall be provided.
The parking spaces required herein shall not be used for the parking of vehicles used directly in the conduct of such use or of renovated, repaired or reassembled vehicles which are owned, operated or in possession of the proprietor of the vehicle dismantling yard or junk and salvage yard. |
All off-street parking shall be improved and paved with a surface of three (3) inch asphaltic concrete with concrete wheel stops installed. The interior landscaping, five (5) foot landscaped strip, permanent irrigation system, and decorative wall shall all comply with CMC § 9162.52. |
E.
No wrecked or dismantled vehicles, salvage or junk shall be placed or allowed to remain outside the enclosed yard area.
F.
No wrecked or dismantled vehicles, salvage or junk shall be stored at a height greater than that of the surrounding fence or wall.
G.
The frontage along all dedicated public streets shall be improved with curbs, gutters and sidewalks.
H.
The standards of development as set forth in this Section shall not relieve the proprietors of such establishments from complying with all applicable regulations, laws, and ordinances of the City of Carson, County of Los Angeles and the State of California.
I.
The crushing, smashing, baling or reduction of metal where permitted by the provisions of this Chapter shall be subject to all of the conditions and required improvements set forth in this Section, and in addition, the maximum noise generated by such operation measured from any point on any adjacent property in a more restrictive zone, or along any street, shall be seventy (70) decibels as measured on the A-scale.
J.
All vehicle dismantling yards, junk and salvage yards and vehicle impounding yards shall comply with the requirements set forth in this Section on or before April 1, 1970.
(Ord. 78-429; Ord. 80-532 § 6)