The purposes of this chapter are:
A.
To provide an alternative method for division of land for commercial zoned property, mobile home parks, trailer parks or condominiums; and
(Ord. 11-0329, § 3 (Exh. 1))
A.
Any person seeking the use of a binding site plan process to divide property for the purpose of sale, lease or transfer of ownership of commercial zoned property, lease of mobile homes or travel trailers or creation of condominium units is required to have an approved binding site plan prior to any property division, as provided for in Chapter 58.17, 64.32 or 64.34 RCW, and as required by this chapter. A binding site plan shall be based on a building permit, an as-built site plan for developed sites, a site plan review, or a general site plan showing the anticipated development plan for the entire site.
B.
The site that is subject to the binding site plan shall consist of one or more contiguous lots.
C.
The site that is subject to the binding site plan may be reviewed independently for developed sites, concurrently with or subsequent to a site development permit application for undeveloped land or concurrently with or subsequent to a building permit application.
D.
The binding site plan process creates or alters lot lines and does not authorize substantial improvements or changes to the property or the uses thereon.
(Ord. 11-0329, § 3 (Exh. 1))
A.
The binding site plan shall ensure that the collective lots continue to function as one site with respect to, but not limited to, lot access, interior circulation, open space, landscaping, drainage facilities, facility maintenance and parking.
B.
The binding site plan shall:
1.
Identify the areas and locations of all streets, improvements, utilities, open spaces, critical areas, parking areas, landscaped areas, surveyed topography for preliminary map, water bodies and drainage features and building envelopes;
2.
Contain inscriptions or attachments setting forth such limitations and conditions for the use of the land as are established by the city manager or the hearing examiner; and
3.
Contain provisions requiring any development or division of land to be in conformance with the approved site plan.
C.
Conditions of use, maintenance and restrictions on redevelopment of shared open space, parking, access and other improvements shall be identified and enforced by covenants, easements or other similar mechanisms.
(Ord. 11-0329, § 3 (Exh. 1))
A.
Alteration of a binding site plan shall be accomplished by following the same process required for a new application as set forth in this chapter.
B.
Changes to a building permit, site plan review or general site plan within a binding site plan area shall also require alteration of the binding site plan unless the city manager determines that such changes are consistent with the approved binding site plan.
(Ord. 11-0329, § 3 (Exh. 1))
A.
Vacation of a binding site plan shall be accomplished by following the same procedure and satisfying the same laws, rules and conditions as required for a new binding site plan application, as set forth in this chapter. If a portion of a binding site plan is vacated, the property subject to the vacated portion shall constitute one lot unless the property is subsequently divided by an approved subdivision or short subdivision or another binding site plan.
B.
If a building permit, site plan review or general site plan is revised or expires, then the binding site plan shall be vacated unless the city manager determines that the revision or expiration is consistent with the approved binding site plan.
(Ord. 11-0329 § 3 (Exh. 1))
A.
Plat certificates or owner’s duplicate certificates for registered land pursuant to Chapter 65.12 RCW shall be provided to the department by the owner along with a copy of the last real estate transaction for all adjoining unplatted parcels.
B.
Prior to recording, the approved binding site plan shall be surveyed and the final recording forms shall be prepared by a land surveyor. A final binding site plan shall be prepared on forms 18 inches by 24 inches in size, allowing for a two-inch border on one of the 18-inch sides, to allow for binding, and one-half-inch borders on the other three sides. The two-inch border will typically be on the top or left side depending on the configuration of the drawing.
C.
The approved binding site plan recording documents shall include the following:
1.
Except for a binding site plan for a condominium, identification of lots by number on a binding site plan containing more than one lot. Tracts shall be similarly designated and each tract shall be clearly identified with the ownership and purpose;
3.
Reference to the recording number of the completed survey if the boundaries have been previously surveyed;
4.
Reference to all agreements or covenants required as a condition of approval;
5.
Notarized signatures of all parties having an ownership interest in the land being divided;
6.
The binding site plan limitations and conditions, including irrevocable dedications of property, and a provision stating that any development of the site shall be in conformity with the approved binding site plan;
7.
Approval of the development engineer;
8.
Approval of the city manager;
9.
Recording certificate required for signature of the city manager;
10.
City file number; and
11.
Approval of the King County assessor.
D.
Lots, parcels or tracts created through the binding site plan procedure shall be legal lots of record. All provisions, conditions and requirements of the binding site plan shall be legally enforceable on the purchaser or any other person acquiring a lease or other ownership interest of any lot, parcel, or tract created pursuant to the binding site plan.
E.
No person shall sell, transfer or lease any lot, tract or parcel created pursuant to the binding site plan that does not conform to the requirements of the binding site plan or without binding site plan approval.
(Ord. 11-0329, § 3 (Exh. 1))