No person shall discharge or cause to be discharged the following described substances, materials, waters or wastes if it appears likely in the opinion of the Public Works Director that such wastes can harm either the sewers, sewage treatment process or equipment, have an adverse effect on the receiving stream, or can otherwise endanger life, limb, public property or constitute a nuisance. In forming this opinion as to the acceptability of these wastes, the Public Works Director will give consideration to such factors as quantities of subject wastes in relation to flows and velocities in the sewers, materials of construction of the sewers, nature of the sewage treatment process, capacity of the sewage treatment plant, degree of treatable wastes in the sewage treatment plant, and other pertinent factors. The substances prohibited are:
1. Any liquid or vapor having a temperature higher than 140 degrees Fahrenheit (60 degrees centigrade).
2. Any water or waste containing fats, gas, grease, or oils, whether emulsified or not, in excess of 100 mg/l or containing substances which may solidify or become viscous at temperatures between 32 and 150 degrees Fahrenheit (zero and 65 degrees centigrade).
3. Any garbage that has not been properly shredded. The installation and operation of any garbage grinder equipped with a motor of three-fourths horsepower (0.75 hp) or greater shall be subject to the review and approval of the Public Works Director.
4. Any waters or wastes containing strong acid iron pickling wastes or concentrated plating solutions, whether neutralized or not.
5. Any waters or wastes containing iron, chromium, copper, zinc, and similar objectionable or toxic substances; or wastes exerting an excessive chlorine requirement, to such degree that any such material received in the composite sewage at the sewage treatment works exceeds the limits established by the Public Works Director for such materials.
6. Any waters or wastes containing phenols or other taste- or odor-producing substances, in such concentrations exceeding limits which may be established by the Public Works Director as necessary, after treatment of the composite sewage, to meet the requirements of the State, Federal, or other public agencies of jurisdiction of such discharge to the receiving waters.
7. Any radioactive wastes or isotopes of such half-life or concentration as may exceed limits established by the Public Works Director in compliance with applicable State or Federal regulations.
8. Materials which exert or cause:
a. Unusual concentrations of inert suspended solids (such as, but not limited to, fuller's earth, lime slurries, and lime residues) or of dissolved solids (such as, but not limited to, sodium chloride and sodium sulfate).
b. Excessive discoloration (such as, but not limited to, dye wastes and vegetable tanning solutions).
c. Unusual BOD, chemical oxygen demand, or chlorine requirements in such quantities as to constitute a significant load on the sewage treatment works.
d. Unusual volume of flow or concentration of wastes constituting slugs as defined herein.
9. Waters or wastes containing substances which are not amenable to treatment or reduction by the sewage treatment processes employed or are amenable to treatment only to such degree that the sewage treatment plant effluent cannot meet the requirements of other agencies having jurisdiction over discharge to the receiving waters.
10. Any waters or wastes containing suspended solids of such character and quantity that unusual attention or expense is required to handle such material at the sewage treatment plant.
11. Any noxious or malodorous gas or substance capable of creating a public nuisance, including the contents of septic tanks and cesspools, without written consent of the Public Works Director.
(Ord. 601 Art. VI § 4, 1991; Ord. 738 § 1, 1997; Ord. 935 § 1, 2015; Ord. 997 § 1 (Exh. A), 2023)