The model codes listed below, as approved and adopted by the State Building Code Council (SBCC), together with any amendments or additions, are adopted by this reference. The Uniform Fire Code applies to all new construction, remodeling or repairs. Copies of the Uniform Fire Code are on file in the offices of the city clerk-treasurer and the building inspector.
A. 
Uniform Fire Code (UFC) and Standards;
B. 
Uniform Fire Code Appendix Chapter 11-B (Protection of Flammable and Combustible Liquid Tanks in Locations Subject to Flooding); and
C. 
Uniform Fire Code Appendix Chapter 11-F (Protected Aboveground Tanks for Motor Vehicle Fuel-Dispensing Stations Outside Buildings).
(Ord. 627 (part), 1999. Formerly 15.86.010; Ord. 832 § 1 (part), 2014)
A. 
The provisions of this chapter apply to all commercial buildings constructed or developed within the city limits, when the buildings will be served by water mains and fire hydrants capable of delivering the required water, unless specifically exempted by this chapter, or unless waived or modified by the fire chief pursuant to Section 14.16.090.
B. 
Decisions of the fire chief are considered to be made in the best interest, and with the concurrence, of an affected fire district in the absence of any credible evidence to the contrary.
(Ord. 627 (part), 1999. Formerly 15.86.020; Ord. 832 § 1 (part), 2014)
Every development must include a system of fire hydrants sufficient to provide adequate fire protection for the buildings located or intended to be located within the development. The following hydrant standards apply unless waived or modified pursuant to Section 14.16.090:
A. 
Any new hydrant installations must comply with the most recent edition of the document entitled “Conditions and Standards for Connecting to the City’s Water System.”
B. 
Spacing.
1. 
Within areas exclusively developed for residential occupancy, maximum distance from a fire hydrant to an access point of any lot is three hundred (300) feet along a roadway.
2. 
The maximum distance between hydrants in residential areas is no greater than six hundred (600) feet.
3. 
For all other occupancy types, the maximum distance from a fire hydrant to the access point of the lot is one hundred fifty (150) feet along a roadway.
4. 
When any portion of a commercial building is more than one hundred fifty (150) feet from the water supply on a public street and when required by the fire chief, on-site fire hydrants and mains capable of supplying the required fire flow must be provided. Water supply may consist of reservoirs, pressure tanks, elevator tanks, water mains, or other fixed systems capable of supplying the required fire flow as approved by the fire chief and city.
C. 
Location.
1. 
Whenever possible, hydrants must be located at street intersections; provided, that when such location results in spacing distances greater than allowed by this chapter, additional hydrants may be required between intersections; provided further, that when the required fire flow is greater than two thousand five hundred (2,500) GPM, the number and location of hydrants will be determined by the city and approved by the fire chief.
2. 
Fire apparatus access roads must be provided and maintained in accordance with the most recent edition of the Pacific County roads standards.
3. 
When fire protection facilities are installed by the developer pursuant to Section 901.3 of the UFC, the facilities must be installed before any combustible construction is installed on-site.
4. 
Water mains and fire hydrants must be capable of delivering the required fire flow to the site and will remain the responsibility of the developer until accepted by the city.
5. 
When alternate provisions are provided pursuant to Section 14.16.090 the above requirements may be waived or modified.
6. 
When locating hydrants, consideration will be given to hazardous operations and the practicality of sound fire service practices (fences, roadways, barriers to operation, etc.), the recommended location preferred by the city, and the required ten (10) foot vehicle clear zone on each side of each hydrant.
D. 
Additional Location Requirements for Commercial Buildings.
1. 
The minimum number of public and private hydrants required will be determined by dividing the required fire flow for the building by one thousand five hundred (1,500).
2. 
Hydrants may be located no closer than fifty (50) feet to and no more than three hundred (300) feet from a building.
3. 
No hydrant may be located more than one hundred fifty (150) feet from a sprinkler or standpipe connection.
E. 
Installation.
1. 
Hydrants must stand plumb and be set to the finished grade.
2. 
The bottom of the lowest outlet of the hydrant must be no less than twelve (12) inches above the grade.
3. 
There must be a thirty-six (36) inch radius of clear area about the hydrant for the operation of a hydrant wrench on the outlets and the control valve.
4. 
The pumper port must face the street or, where the street cannot be clearly identified, must face the most likely location of a fire truck while pumping, as determined by the fire chief.
F. 
Fire hydrants must be protected from damage.
1. 
Internal maintenance of public fire hydrants is the responsibility of the city.
2. 
Private hydrants must be protected and maintained in accordance with the Uniform Fire Code.
(Ord. 627 (part), 1999. Formerly 15.86.050; Ord. 832 § 1 (part), 2014)
The following standards relating to water mains, hydrant branches, and fire flow apply to all new development in the city unless waived or modified, pursuant to Section 14.16.090:
A. 
Hydrant branches must not have a domestic supply outlet and must meet the design standards of the city (see Chapter 14.06).
B. 
New or replaced water mains serving fire hydrants must meet the design standards of the city (see Chapter 14.06).
C. 
Flow Requirements.
1. 
Service mains supplying hydrants must be designed to provide not less than five hundred (500) GPM at twenty (20) pounds per square inch residual pressure over and above the computed maximum daily domestic consumption for the period of time specified in the Washington Survey and Rating Bureau’s Grading Schedule, Table 4.
2. 
In addition, service mains supplying hydrants must provide the fire flow required to each building covered at the number of gallons per minute specified in UFC Appendix IIIA, except as to single dwellings. The fire chief may require construction in compliance with design from a registered professional engineer in order to assure that the required fire flow will be achieved.
(Ord. 627 (part), 1999. Formerly 15.86.060; Ord. 832 § 1 (part), 2014)
A. 
Before any new hydrants or mains serving hydrants are installed, the developer must provide plans, prepared by a licensed engineer, for review by the city.
B. 
Upon completed installation and acceptance by the city, the developer must give the fire chief two (2) copies of the accurate and identifiable as-built drawings or plans showing the location of all mains, hydrant branches, valves and fire hydrants installed.
(Ord. 627 (part), 1999. Formerly 15.86.070; Ord. 832 § 1 (part), 2014)
A. 
The fire chief must certify that the plans have been reviewed before a development permit for any new or substantially altered commercial building, plat development or residential complex is issued.
B. 
If the plans are in compliance with this chapter, a notice of approval for issuance of a building permit will be forwarded to the building inspector. The approval will be based on the provisions of this chapter being satisfied before the start of any construction.
(Ord. 627 (part), 1999. Formerly 15.86.080; Ord. 832 § 1 (part), 2014)
A. 
Subject to acceptance by the city, the fire chief may grant a waiver or modification to the standards contained in Sections 14.16.050 and 14.16.060 if:
1. 
Strict compliance with the standards would create a substantial hardship on the applicant; and
2. 
A waiver or modification does not result in inadequate fire protection.
B. 
Waivers or modifications must:
1. 
Be in writing;
2. 
State the reasons for the waiver or modification; and
3. 
Be provided to the fire district that has jurisdiction over the project.
(Ord. 627 (part), 1999. Formerly 15.86.090; Ord. 832 § 1 (part), 2014)
A. 
Obstructing the view of a fire hydrant by any means for a distance of fifty (50) feet from any direction of vehicular approach is prohibited.
B. 
Each violation will be punished by a fine of two hundred fifty dollars ($250.00) per violation, not to exceed a fine of two hundred fifty dollars ($250.00) per day that violations occur. Any violation of this section is declared a public nuisance, subject to immediate abatement and subject to Section 15.02.140.
(Ord. 627 (part), 1999. Formerly 15.86.100; Ord. 832 § 1 (part), 2014; Ord. 959 § 8, 2025)