Industrial waste discharge permits shall be expressly subject
to all provisions of this Part 2 and all other applicable local laws,
regulations, charges and fees established by the Town. The conditions
of the industrial waste discharge permit may contain the following:
A. Effluent limitations or other appropriate limitations when toxic
substances are present in the user's wastewater discharge.
B. Specifications for monitoring programs which may include sampling
locations, frequency and method of sampling, number types and standards
for analytical tests and reporting schedules.
C. Requirements for submission of reports for conditions of noncompliance.
D. Requirements for submission of technical reports or discharge reports.
E. Pretreatment requirements.
F. Requirements for installation and maintenance of inspection and sampling
facilities.
G. Schedules for compliance with this Part 2 and other applicable Town
and local laws.
H. Limits on the average and maximum wastewater constituents, flow rates
and time of discharge.
I. Requirements for maintaining and retaining plant records, relating
to wastewater discharge, to be limited to three years unless specified
in the industrial waste discharge permit and affording the Town access
thereto and copying thereof.
J. Requirements for notification of the Coordinator of any new introduction
of wastewater constituents or any substantial change in the volume
or character of the wastewater constituents being introduced into
the POTW.
K. The computation and requirement for payment of the industrial waste
surcharge or any other applicable fees or charges.
L. Requirements for the submission of information concerning the disposal
of waste material separated from the authorized discharge.
M. Periodic compliance reports.
(1) All significant industrial users shall, at a frequency determined
by the Town but in no case less than twice per year (in June and December),
submit a report indicating the nature and concentration of pollutants
in the discharge which are limited by pretreatment standards and the
measured or estimated average and maximum daily flows for the reporting
period. All periodic compliance reports must be signed by an authorized
representative of the user.
(2) All wastewater samples must be representative of the user's
discharge. Wastewater monitoring and flow measurement facilities shall
be properly operated, kept clean, and maintained in good working order
at all times. The failure of a user to keep its monitoring facility
in good working order shall not be grounds for the user to claim that
sample results are unrepresentative of its discharge.
(3) All monitoring and analyses are to be done in accordance with §
230-59 and 40 CFR 403.12(g).
(4) If a user subject to the reporting requirement in this section monitors any pollutant more frequently than required by the Town, using the procedures prescribed in §
230-59 of this Part
2, the results of this monitoring shall be included in the report.
A permittee requesting any modification of a permit shall do
so at least 90 days prior to the date the permittee plans to implement
the modification. Application to the Coordinator for modification
shall include any information as may be deemed necessary by the Town
to evaluate the modification application.
Industrial waste discharge permits are issued to a specific
user for a specific operation. A permit shall not be reassigned, transferred
or sold to a new owner, new user, different premises or a new or changed
operation without the prior approval of the Coordinator. In the event
of any change in ownership of the industrial facility, the permittee
shall notify the new owner of the existence of the permit by letter,
a copy of which shall be forwarded to the Coordinator. If the operations
and processes are to remain the same, the permit may be approved by
the Coordinator for the new owner. A new industrial waste discharge
permit application shall be made by the new owner and facility if
any other changes are made other than the control of ownership.
Industrial waste discharge permits may be modified, suspended
or revoked where the Coordinator finds, after a hearing held in conformance
with the procedures set forth in this Part 2:
A. A violation of any term of the permit or any order or determination
of the Coordinator promulgated under this Part 2 or other applicable
Town local laws;
B. That the permit was obtained by misrepresentation or failure to disclose
fully all relevant facts;
C. A change in conditions or the existence of a condition which requires
either a temporary or permanent reduction or elimination of the authorized
discharge;
D. Refusal of reasonable access to the permittee's premises for
the purpose of inspection or monitoring; or
E. Failure of the permittee to report significant changes in operations
or wastewater constituents and characteristics.
Information and data on a user obtained from reports, surveys,
wastewater discharge permit applications, wastewater discharge permits,
and monitoring programs and from the Town's inspection and sampling
activities shall be available to the public unless the user specifically
requests that it be kept confidential. Wastewater constituents and
characteristics and other "effluent data" as defined by 40 CFR 2.302
will not be recognized as confidential information and will be available
to the public without restriction. Only information that meets the
requirements established in 40 CFR Part 2 will be treated as confidential.
No statement in this Part 2 shall be construed as preventing
any special agreement between the Coordinator and any industrial concern
whereby an industrial waste of unusual constituents or characteristics
may be accepted by the Coordinator for treatment subject to the proper
payment by the industrial user. Under no circumstances shall a special
agreement circumvent federal categorical pretreatment standards.
All measurements, tests and analyses of the constituents and
characteristics of waters and wastes to which reference is made in
this Part 2 shall be determined in accordance with the latest editions
of Standard Methods for the Examination of Water and Wastewater, Methods
for Chemical Analysis of Water and Waste of the EPA and the latest
version of 40 CFR Part 136, Analysis of Pollutants.
Grease, oil and sand interceptors shall be provided when, in
the opinion of the Plumbing Inspector and/or the Coordinator, they
are necessary for the proper handling of liquid wastes containing
grease in excessive amounts or any flammable wastes, sand or other
harmful ingredients, except that such interceptors shall not be required
for private living quarters or dwelling units. All interceptors shall
be of a type and capacity approved by the Plumbing Inspector and/or
the Coordinator and shall be located as to be readily and easily accessible
for cleaning and inspection.