[Adopted 7-9-1999]
A.
Outside lamps and lighting.
[Amended 4-11-2008; 1-17-2014]
(1)
One outside lamp shall be installed on the premises
at a location to be approved by the Building Official.
(a)
Outside lamps required by this article shall be lit between
dusk and dawn each and every day.
(2)
All outside lighting shall be oriented, shielded or both, so that
glare and illumination of adjacent properties is minimized.
B.
Exterior stairs from the ground to the first floor
of a dwelling may or may not be enclosed. Exterior stairs from the
ground to a second floor shall be enclosed.
[Added 10-8-1999]
C.
Separate steps on the exterior of a dwelling to a
bedroom or a bedroom and bath suite are expressly prohibited.
[Added 10-8-1999]
D.
A construction site shall have an access pathway for
trucks and vehicles no wider than 20 feet and which must be improved
to a depth of two inches with crusher run or gravel. The size, depth
and location must appear on the site plan and building permit application.
[Added 10-8-1999]
E.
Building criteria.
[Added 1-14-2000; amended 1-11-2002]
(1)
Siding.
(a)
All materials used for construction for the siding
of a house, garage or accessory building, including but not limited
to corner boards, trim around the windows and doors and facia board,
shall be made of stone, brick, wood, a painted cementicious material
such as Hardi-plank, or solid PVC material, such as "KOMA Trimboard,"
as defined by the list of properties of KOMA Trimboard dated February
9, 2005.
[Amended 7-8-2005]
(b)
Stucco may only be used on a foundation to cover block.
(c)
T-111 siding material, stucco, plywood, vinyl, aluminum
and dryvit are strictly prohibited for the siding of a house, garage,
pilings, accessory building, corner boards, trim around the windows
and doors and facia boards.
(d)
The perimeter of the area created by exposed pilings
which constitute the foundation of a house or structure shall be enclosed
with lattice or other covering. All materials used to cover the perimeter
of the area created by the exposed pilings shall be made of wood or
a painted cementious material or Hardi-plank.
[Amended 10-20-2008]
(2)
Accessories. Accessories to a house, garage or accessory
building may be of the following materials:
(a)
Exterior doors must be made of clad/wood, solid wood
or painted steel, aluminum, vinyl or fiberglass.
(b)
Windows must be made of clad/wood or solid wood. Solid
vinyl windows are prohibited.
(c)
Shutters must be made of vinyl or wood.
(d)
Columns must be wood, a painted composite material
such as Fypon or wrapped with wood.
(e)
Soffits must be made of a beaded vinyl, wood or a
cementicious product such as Hardi-plank.
(f)
Railings must be made of wood, metal or high-quality
grade vinyl.
(g)
Decking must be made of wood or Trex.
(h)
Patios must be made of slate, brick, stone or concrete.
(3)
Roofing. Roofing must be architectural grade asphalt
shingles, composition or dimensional, heavy weight copper or standing
seam metal, clay, slate or cedar shake. Corrugated metal roof or lightweight
shingles are prohibited. Gutters must be made of heavy-gauge aluminum,
copper or metal.
[Amended 7-12-2013]
(4)
Garages. Vehicular access to garages shall only be
to that part of the garage facing away from the street on which a
lot fronts. The doors of a garage providing vehicular access shall
not be less than 90° perpendicular to a straight line intersecting
boundary corners of the lot fronting on a street.
[Added 7-14-2006]
(5)
To avoid undue hardship, nothing in this chapter shall
be deemed to require changes in the plans, construction or designated
materials of any structure on which actual construction was lawfully
begun prior to the effective date of the adoption of the amendment
and upon which actual building construction has been diligently carried
on. Replacement of any nonconforming materials shall be only with
conforming materials.
F.
Building permit.
[Added 10-12-2001]
(1)
A building permit, in addition to any other requirements of the ordinances of the Town of Henlopen Acres, shall be required. Such permit may be combined with the zoning permit required pursuant to §§ 130-35 through 42 and building permit required pursuant to § 71-12.[2]
[2]
Editor’s Note: This reference is to § 71-12 in former Ch. 71, Floodplain Management, which was repealed 10-10-2014. The repealing ordinance also adopted Ch. 71, Flood Damage Reduction, and provided that it supersede any references to flood and floodplain management in Ch. 43. See also now § 71-11, Permits required.
(2)
An amount of $5,000 cash or in a form acceptable to
the Town shall be deposited by the owner, his/her/their agents, employees
or assigns, prior to the issuance of any building permit for major
construction, which shall be defined as construction of a new structure
or remodeling of an existing structure in an estimated amount greater
than $50,000. Such deposit shall be used by the Town to repair any
damage to Town property in the event such damage is not repaired by
the owners, his/her/their agents, employees or assigns. It shall be
the responsibility of the owner to see that all repairs identified
by the Town are completed satisfactorily within 30 days of notice
from the Town. Once such repairs are accepted by the Town, the deposit
or that amount remaining of the deposit shall be refunded within 30
days of such acceptance.
[Added 4-16-2004]
G.
Relocation or moving of buildings within Town.
[Added 1-10-2003]
(1)
No building permit shall be issued to relocate any
building or structure or portion thereof from one site within the
corporate limits of the Town to another site within or without the
Town, using Town rights-of-way, unless a professional engineer or
architect duly licensed in the State of Delaware shall certify, in
writing, to the Town that said building or structure or portion thereof
complies with the Town building code and the State Fire Code.
(2)
Procedure. A letter of request for a relocation or
moving permit shall be filed with the Mayor and Commissioners by submitting
same to the Zoning/Building Official. Such request shall include the
plan for such moving or relocation:
(a)
The routes to be used.
(b)
The location, approximate height and type of any trees
or shrubs which are reasonably expected to be necessary to be trimmed
or removed.
(c)
Letters of disconnect from any utility that will be
involved.
(d)
Dates for the commencement and expected completion
of the relocating or moving.
(e)
Name and address of mover.
(3)
All the trees and shrubs which are removed must be
replaced at the applicant's expense and without any expense or liability
to the Town with trees and shrubs of a similar type, height and size
as determined by the Town. Such replacement shall be planted during
the normal planting season for such trees and shrubs and shall be
replaced at the applicant's expense and without any expense or liability
to the Town if any shrub or tree does not survive for a period of
12 months from the date of planting.
(4)
A bond approved by the Town Solicitor issued by a
surety company authorized to do business in the State of Delaware
or an irrevocable letter of credit with the terms being approved by
the Town Solicitor issued by a bank or trust company authorized to
do business in the State of Delaware in an amount approved by the
Commissioners shall be filed with the Town before any work of moving
or relocating is commenced. Once the moving is commenced, it shall
proceed with due diligence and without any undue delay.
(5)
The cost of any replacement or repair of any utility
lines located in the rights-of-way used for moving or relocating,
including any engineering or inspection fees, or both, shall be at
the applicant's expense and without any expense or liability to the
Town.
(6)
Any damage to streets, paving or other public improvements
or property resulting from any activities conducted under a building
or repair permit issued or while relocating or moving a building or
clearing or filling a lot shall be repaired in order that such improvements
or property is in a similar condition after the moving or relocating
as it was before the moving or relocating, as determined by the Town,
and by the applicant at applicant's sole expense and without any expense
or liability to the Town.
H.
Sediment and erosion control.
[Added 7-9-2004]
(1)
The owner, which term shall also include the owner's
agents, employees, successors and assigns, shall be responsible for
constructing and maintaining sediment and erosion controls as required
by the Town and in accordance with the Delaware Erosion and Sediment
Control Handbook.
(2)
Sediment and erosion control requirements.
(a)
The Town shall issue no building permit for building
construction until such time that all required perimeter erosion and
sediment controls (including, but not limited to, silt fences, perimeter
dikes, sediment traps) are installed by the owner and accepted and
approved by state and County agencies.
(b)
The Town shall issue no certificate of occupancy for
lots until such time that all required perimeter erosion and sediment
controls other than silt fences (which shall remain in place until
such a time as the Town has approved removal of those structures)
are removed.
(3)
Failure to complete or maintain improvements.
(a)
Site management corrective measures. Failure of the
owner, properly and promptly, to install and maintain drainage structures,
stormwater management facilities, sanitary sewers, sediment and erosion
controls, or other site management measures required by the Town,
shall result in the following:
[1]
Notwithstanding any notification provision in
this chapter, the Town, through the Town Manager or designee, shall
list deficiencies and endeavor to notify the owner that the deficiencies
must be corrected within a specified time. Such notice may be effected
by the most expeditious method as decided by the Town Manager, including,
but not limited to, fax, hand delivery, regular mail, certified mail,
telephone, or electronic mail. The Town, through the Town Manager,
may notify the owner in advance of any proposed action, but failure
of the Town to do so will not affect the owner's or the Town's rights
or obligations hereunder.
[2]
Failure to comply.
[a]
Notwithstanding other remedies available in
this chapter, failure to achieve compliance by the date specified
shall be cause for the Town to take such action as it determines appropriate,
including but not limited to:
[b]
If there is not complete compliance within seven
days of the date specified in the notification, the Town may issue
a stop-work order on all building permits issued to the owner. The
determination as to whether there is complete compliance with the
notification rests solely with the Town.
[3]
The structures relative to building permits
and certificates of occupancy stated above shall not be lifted until
all deficiencies have been satisfactorily remedied as determined by
the Town.
(b)
Deteriorating or unsafe conditions. If the condition
of an improvement presents a health, safety, or welfare risk, the
Town may take immediate corrective action without notice to the owner.
The Town may use the proceeds from the building permit deposit to
perform any work necessary or remove or correct the condition.
I.
Site preparation. Site preparation, including but
not limited to, demolition of all or any portion of an existing structure,
removal of any trees, bushes, or ground cover on any lot as part of
or in anticipation of any construction, demolition or removal or reconstruction
shall not begin until a zoning certificate/building permit has been
issued.
[Added 4-11-2008; amended 12-11-2009]
J.
Solar panels/collectors.
[Added 12-11-2009; amended 10-9-2020]
(1)
Only roof-mounted solar panels/collectors (solar panels) may be installed
and used on any principal structure, subject to any applicable building
code, including but not limited to the International Residential Code,
Section R324, and approved by the Environmental Approval Committee
(EAC).
(2)
The
placement of solar energy equipment on roofs of principal buildings
is permitted. For aesthetic purposes, the front slope of the principal
building shall not be used unless no other location of the solar energy
equipment is feasible.
(3)
The roof-mounted solar panels shall be parallel to and no higher than six inches from the roofline or flush with the roof covering. Roof-mounted solar energy equipment shall be located so as to not increase the total height of the structure above the maximum allowable height of the structure on which it is located, in accordance with the applicable zoning regulations (see Chapter 130, Zoning). Ground-mounted, freestanding solar panels and panels on side walls are prohibited.
(4)
The EAC, in its review of any application for solar panels, may consider:
(a)
The location where solar panels may be placed on roofs.
(b)
The concealment of supportive structures, fixtures and piping
for solar panels.
(c)
The color harmonization of solar panels among commercially available
products with color of the roof and/or structure where the solar panels
are to be located.
(d)
The aggregate size or coverage or total number of solar panels.
(e)
In applying the factors listed herein, the EAC should allow
70% annual access to solar energy per a Solar Pathfinder study or
equivalent and should not be more restrictive than 10% of its maximum
potential efficiency.
(f)
Solar energy operations are prohibited as a principal use. These
are systems whose main purpose is to generate energy for sale back
into the energy system, rather than being consumed on site.
(g)
Only commercially made and professionally installed solar energy
systems are permitted. All solar systems shall be installed by a contractor
that is approved and certified by the NABCEP (North American Board
of Certified Energy Practitioners) and/or have proof of professional
training and licensure.
K.
Site work.
[Added 7-9-2010]
(1)
Application
requirements. Applicants intending to construct a dwelling or other
structure, requiring the construction of footings, foundations, pilings,
slabs on grade, or other earth-moving activities, shall include a
site plan with their application for a building permit.
(2)
Site
plan. A site plan shall be drawn by a professional engineer or a land
surveyor licensed in the State of Delaware. The applicant must submit
two copies showing the entire property of the applicant and as much
adjacent property as may be affected by the proposed activity and/or
stormwater subsequent to the proposed activity. A site plan shall
also include property lines, lot and block number, local address,
Sussex County tax map number, property elevation contour lines, and
location of all improvements, including but not limited to structures,
driveways, walks, stairs, swimming pool and any proposed changes to
the existing grade.
(3)
Review. A site plan is subject to review for compliance with § 43-5H, Sediment and erosion control, as well as Chapter 71, Floodplain Management,[3] and all provisions of Chapter 130, Zoning, including review by the Environmental Review Committee if, in the opinion of the Town Manager and Zoning Officer, grading and earthwork activities are excessive and may impact the adjacent properties and/or the community.
