Erosion and sedimentation control measures shall
meet the standards and specifications of the Town of Stanley Sediment
and Erosion Control Ordinance.
As required by this chapter, all monuments must
be installed by the subdivider. Upon completion of subdivision streets,
sewers and other improvements, the subdivider shall make certain that
all monuments required by the Town are clearly visible for inspection
and use. Such monuments shall be inspected and approved by the Town
before any improvements are accepted by the governing body.
A. Location of steel pins. Steel pins shall be used as
monuments at all street corners and at all points where the street
line intersects the exterior boundaries of the subdivision and at
right angle points and points of curve in each street. Such monuments
shall meet the specifications of the Virginia Department of Transportation.
B. Location of iron pipe. All other lot corners shall
be marked with iron pipe not less than 3/4 inch in diameter and 24
inches long and driven so as to be flush with the finished grade.
When rock is encountered, a hole shall be drilled four inches deep
in the rock, into which shall be cemented a steel rod 1/2 inch in
diameter, the top of which shall be flush with the finished grade
line.
The installation of streetlights, if required,
shall be in accordance with design standards and specifications of
the Town and the Virginia Department of Transportation.