A. 
All subdivisions shall conform to the Town of Hampstead and Environs Comprehensive Plan, Zoning Ordinance, Subdivision Regulations, and to all other applicable ordinances, resolutions and plans, including the Carroll County Water and Sewer Master Plan. More stringent design provisions may be required by the Commission if it is demonstrated that they are necessary to promote the public health, safety or welfare, or to promote good subdivision design.
B. 
In laying out a subdivision, the developer shall comply with all requirements of the Maryland Department of the Environment and Carroll County Health Department governing subdivision of land.
C. 
The proposed subdivision shall not violate the provisions of any enforceable deed restrictions or covenants attached to the property.
Proposed streets shall be shown by providing a minimum right-of-way width of 50 feet. Where it is determined by the Commission that a street should be designed in a subdivision to carry traffic from other areas or adjacent subdivisions, whether existing or potential, a minimum of 60 feet shall be shown. Where a subdivision is created fronting on an existing Town-maintained road, front lot lines of a subdivision shall be established 25 or 30 feet from the center of the existing Town-maintained road. Culs-de-sac shall terminate in a circular area with a minimum right-of-way diameter of 100 feet.
A. 
Streets, roads and public ways shall be located in such a manner as to provide for the safe and orderly movement of vehicular traffic to, from and through the subdivision. The course and terminus of any streets, roads and public ways shall be located in such manner as to allow the reasonable, planned development of adjacent undeveloped parcels.
B. 
Street names shall be approved by the Commission prior to submitting a final plat to ensure no duplications.
A. 
Easements shall be shown on the final plat where a natural watercourse (stream) exists or where natural or street drainage is located or may be provided, such easement to be a minimum of 15 feet, except in the case of a natural watercourse, which shall contain adequate easement area to provide for a one-hundred-year storm.
B. 
Whenever a residential subdivision abuts a nonresidential subdivision, use or undeveloped land not located in a residential district, a permanently landscaped buffer strip of at least 20 feet in width shall be provided.
C. 
The legal form of all easements shall be provided upon submission of the preliminary plan.
A. 
Streets, curbs, gutters, sidewalks and driveway aprons shall be constructed in accordance with those standards and regulations as set forth in local regulations and design specifications, the Design Manual, Roads and Storm Drains, Carroll County, Maryland, Department of Public Works, as adopted on April 14, 1994, by the County Commissioners of Carroll County, and the Maryland Department of Transportation State Highway Administration Standard Specification for Construction and Materials as published in October 1993, and as may hereinafter be amended. Where standards vary, local regulations and design specifications shall take precedence. All new road construction shall use the Superpave materials and paving system as defined by the Maryland State Highway Administration.
B. 
All construction shall be done under the immediate supervision of an inspector appointed by the Town Manager. No improvement will be accepted until the Town Manager and appointed inspector are satisfied that the work has been performed according to the plans, profiles and specifications furnished and to the lines and grades established.
C. 
A suitable guaranty shall be provided to the Town by the developer prior to final approval of the final subdivision plat by the Commission in order to ensure construction by the developer of those streets as shown.
D. 
Curbs and gutters are required in all subdivisions containing lots having an area of 40,000 square feet or less. Subdivisions containing lots having an area greater than 40,000 square feet may be required to install curb and gutter as directed by the Town.
E. 
Driveway access to the street shall not be located within 10 feet of a storm drain. All driveway access to the street shall be by a concrete driveway apron in conformance with Town standards.
F. 
Unless an exception is granted by the Commission, culs-de-sac shall be not more than 500 feet in length measured along the center line from the center line of the street of origin to the center of the turnaround, and each shall have a terminus generally circular in shape, with a right-of-way diameter of 100 feet and a center on, or within 30 feet of, the cul-de-sac center line.
G. 
Signs, sign posts, and pavement markings, as required, shall meet the minimum requirements for similar signs and posts as shown and set forth in the Manual for Uniform Traffic Control Devices for Streets and Highways.
H. 
In all subdivisions where lots are less than 40,000 square feet, sidewalks shall be provided along one side of all public streets except expressways. In all subdivisions where lots are less than 20,000 square feet, sidewalks shall be provided along both sides of all public streets except expressways. The Town also may require that sidewalks be provided elsewhere than as required above, where considered necessary.
A. 
All electric and telephone distribution lines shall be installed underground, except those overhead distribution feeder lines necessary to serve that subdivision and in locations as approved by the Commission. Cable-switching enclosures, pad-mounted transformers, and service pedestals may also be installed above the ground and may be installed as a part of the streetlighting standards where approved by the Commission.
B. 
Water mains shall be not less than six inches in diameter and shall be arranged so as to avoid dead ends. Shut-off valves shall be provided at each branch main connection and elsewhere as required to permit adequate sectionalizing for maintenance purposes. Fire hydrants shall be installed throughout the entire system at intervals not exceeding 400 feet. A house service connection shall be provided at the center line of each lot or as specified by the Hampstead Public Works Department, extending to within one foot of the property line, before roadway pavement is constructed. Materials, system arrangement, and details of design shall be subject to the approval of the Town.
C. 
Stormwater management facilities shall be designed in accordance with Chapter 113 of the Town Code. All such facilities shall be located in such a manner as to facilitate municipal ownership and maintenance of such facilities.
A. 
Every lot shall contain a suitable building site.
B. 
Lot size. Lot dimensions and area shall be not less than the requirements of the Zoning Ordinance or as determined by the Maryland Department of the Environment, whichever is greater.
C. 
Lot width. The minimum width of lots shall be as follows:
(1) 
All lots containing an area of 7,500 square feet, but less than 10,000 square feet, shall have a minimum width of 70 feet at the required minimum building line.
(2) 
All lots containing an area of 10,000 square feet, but less than 20,000 square feet, shall have a minimum width of 80 feet at the required minimum building line.
(3) 
All lots containing an area of 20,000 square feet, but less than 40,000 square feet, shall have a minimum width of 100 feet at the required minimum building line.
(4) 
All lots containing an area of 40,000 square feet, but less than three acres, shall have a minimum width of 150 feet at the required minimum building line.
(5) 
All lots containing three acres or more shall have a minimum width of 250 feet at the required minimum building line.
(6) 
The minimum width at the right-of-way line for lots fronting on a cul-de-sac turnaround shall be not less than 36 feet.
D. 
Lot frontage. Except as allowed by § 119-11, each proposed lot containing an area of less than three acres shall front upon a street accepted by the Town of Hampstead as a public street. The front of any lot shall not face the rear yard of any other lot.
E. 
Lot lines. Side lot lines shall be at right angles or radial to the street line, or substantially so.
A. 
Every lot shall have access to it that is sufficient to afford a reasonable means of ingress and egress for vehicles and emergency vehicles as well as for all those likely to need or desire access to the property in its intended use.
B. 
The creation of "flag" or "panhandle" lots may be permissible by the Commission only under the following circumstances:
(1) 
To avoid providing direct access onto an arterial.
(2) 
When a property owner demonstrates that, because of the irregular shape of a tract or its difficult topography or for some other substantial reason, the creation of a flag lot is reasonably necessary to avoid extreme hardship to the property owner and can be accomplished without creating substantially adverse effects on neighboring properties or the public health or safety.
A. 
In nonresidential subdivisions, including industrial and commercial tracts, the subdivider shall demonstrate to the satisfaction of the Commission that the street, parcel and block pattern is specifically adapted to the uses anticipated and takes into account other uses in the vicinity.
B. 
Whenever a nonresidential subdivision abuts a residential subdivision, use or undeveloped land located in a residential district, a permanently landscaped buffer strip of at least 20 feet in width shall be provided.
Where there is a discrepancy between minimum standards or dimensions noted herein and other official regulations, the highest standards shall apply.
Subdivisions shall be designed to protect environmental resource areas in accordance with the Environmental Resource Areas Guidelines as published in Appendix A to the Environmental Resources Element of the Hampstead Comprehensive Plan and as modified from time to time.
The developer shall provide a wellhead buffer easement for any portion of the subdivision within the wellhead buffer. This area shall be preserved with an ownership arrangement acceptable to the Town. The total wellhead buffer for a community wellhead shall be a circular area having a minimum one-hundred-foot radius which extends around any existing or proposed community water supply well or well site, as may be designated on the adopted Water and Sewer Master Plan or the Comprehensive Plan, or identified during the development process, unless this configuration and/or size is specifically modified by the Commission in its approval of the preliminary subdivision plan. The wellhead buffer shall be shown on the preliminary plan and included on the final plat.