Sketch plats submitted to the Planning Board
shall be drawn to a convenient scale and size, as required by the
Planning Board, and shall show the following information:
A. Title of proposed subdivision, graphic scale, North
arrow, date, revision date(s) (if any), property owner's name and
address, applicant's name and address (if other than the owner) and
the name and address of the licensed surveyor preparing the sketch
plat.
B. Location of property lines, existing easements, burial
grounds, railroad rights-of-way, watercourses and existing wooded
areas; location, width and names of all existing or platted roads
or other public ways within or immediately adjacent to the tract;
names of adjoining property owners from the latest Town of Eden assessment
rolls within 500 feet of any perimeter boundary of the subdivision.
C. Location, sizes, elevations and slopes of existing
sewers, water mains, culverts and other underground structures within
the tract and immediately adjacent thereto; existing permanent buildings
and utility poles on or immediately adjacent to the site.
D. Topography, with a contour interval of two feet referred
to sea level datum. All datum provided shall be the latest applicable
United States Coast and Geodetic Survey datum and should be so noted
on the plat.
E. The approximate location of existing wetlands, floodplains
and other environmentally sensitive areas, including a description
of soil types and what, if any, special construction procedures and
guidelines must be followed in areas affected by these soil types.
F. The approximate location and widths of proposed roads.
G. Preliminary proposals for connection with existing
water supply and sanitary sewage systems, or alternative means of
providing water supply and sanitary waste treatment disposal; preliminary
provisions for collecting and discharging surface water drainage both
on the subdivision premises and those downstream and upstream of the
subdivision.
H. The approximate location, dimensions and areas of
all proposed or existing lots.
I. The approximate location, dimensions and area of all
parcels of land proposed to be set aside for park or playground use
or other public use or for the use of property owners in the proposed
subdivision.
J. The location of temporary stakes to enable the Planning
Board to find and appraise features of the sketch plat in the field.
K. Whenever the sketch plat covers only a part of an
applicant's contiguous holdings, the applicant shall submit, at a
convenient scale, a sketch of the proposed subdivision area, together
with its proposed road system, and an indication of the probable future
road system and drainage system of the remaining portion of the tract.
L. A vicinity map showing roads and other general development
of the surrounding area at a scale consistent with the scale of the
Town of Eden tax maps. The sketch plat shall show all school and improvement
district lines and zoning district lines with the zones properly designated.
The proposed lot lines should be shown on this map.
M. All features or resources identified as significant
in the Town of Eden's Natural Resource Inventory, Open Space Index
or Comprehensive Plan.
[Added 11-14-2001 by L.L. No. 8-2001]
Construction plans shall be prepared for all
required improvements. Plans shall be drawn at a scale, as required
by the Planning Board, and map sheets shall be of the same size as
the preliminary plat. The following shall be shown:
A. Profiles showing existing and proposed elevations
along the center lines of all roads. Where a proposed road intersects
an existing road or roads, the elevation along the center line of
the existing road or roads, within 100 feet of the intersection, shall
be shown.
B. The Planning Board may require, where steep slopes
exist, that present and proposed elevations of all proposed roads
shall be shown every 100 feet at five points on a line at right angles
to the center line of the road, and said elevation points shall be
at the center line of the road, each property line and points 25 feet
inside each property line.
C. Plans and profiles showing the locations and typical
cross section of road pavements, including curbs and gutters, sidewalks,
drainage easements, servitudes, rights-of-way, manholes and catch
basins; the locations of roads, trees, road lighting standards and
road signs; the location, size and invert elevations of existing and
proposed sanitary sewers, stormwater drains and fire hydrants; and
exact location and size of all water, gas or other underground utilities
or structures.
D. Location, size, elevation and other appropriate description
of any existing facilities or utilities, including but not limited
to existing roads, sewers, drains, water mains, easements, water bodies,
streams and other pertinent features, such as swamps, wetlands, floodplains,
railroads, buildings and features noted on the Official Map.
E. Topography, at the same scale as the sketch plat,
with a contour interval of two feet, referred to sea level datum.
All datum provided shall be the latest applicable United States Coast
and Geodetic Survey datum and should be so noted on the plat.
F. All specifications and references required by the
Town's construction standards and specifications, including a site-grading
plan for the entire subdivision and an erosion and sediment control
plan.
G. Notation of approval as follows:
|
Approved
|
|
|
_______________________
|
_______________
|
|
Owner
|
Date
|
|
_______________________
|
_______________
|
|
Planning Board Chairman
|
Date
|
H. Title, name, address and signature of professional
engineer and surveyor and date, including revision dates.