Town of Herman, WI
Dodge County
By using eCode360 you agree to be legally bound by the Terms of Use. If you do not agree to the Terms of Use, please do not use eCode360.
[HISTORY: Adopted by the Town Board of the Town of Herman at time of adoption of Code (see Ch. 1, General Provisions, Art. II). Amendments noted where applicable.]
Building construction — See Ch. 170.
Land division and development — See Ch. 251.
Streets and sidewalks — See Ch. 334.
The purpose of this chapter is to promote the safety and general welfare of the citizens of the Town of Herman through Town authorization of driveway locations and minimum standards which allow proper drainage of surface waters within Town ditches.
The following definitions shall be applicable in this chapter:
A private roadway which serves no more than one parcel of land owned by the same individual(s).
All private routes of ingress and egress from any public right-of-way which provide access to one residential dwelling unit or residential property.
All private routes of ingress and egress from any public right-of-way which provide access to two or more residential dwelling units or residential properties.
No person, partnership, company or corporation shall locate, establish or construct any new driveway or install any culvert without having first obtained a driveway permit application from the Zoning Administrator, who shall collect the fee as determined by the Town Board. Application for such permit shall include a drawing which accurately portrays the location, dimension and grade of the driveway on the subject property, as well as a statement of the proposed materials to be used.
All driveways installed, altered, changed, replaced or extended shall require a permit and meet the following requirements:
Width and location. The width and location of driveway openings for vehicular ingress and egress along Town roads shall be approved by the Zoning Administrator.
New driveway length. Any new driveway to serve a principal structure is recommended to be not longer than 500 feet depending on further design and engineering standards.
Driveway islands. Islands between driveway openings shall be provided with a minimum of 10 feet between all driveways and five feet at all lot lines, measured along a line 10 feet from and parallel to edge of pavement.
Driveways openings. Openings for vehicular ingress and egress shall not exceed 35 feet nor be less than 20 feet, measured at right angles to the center line of the driveway, except as increased by permissible radii. Radii between the highway pavement and the driveway shall be no greater than 40 feet for commercial and industrial buildings and no greater than 30 feet for other uses.
Field access driveways. An accessway whose primary purpose is field access is not considered to be a driveway for purposes of this chapter.
Other agency approvals. The property owner/developer shall obtain permission from the State of Wisconsin Department of Transportation for access to state and federal highways and from the Dodge County Highway Department for access to any county highway.
Each driveway shall have a culvert at least 18 inches in diameter at the ditch line where the driveway meets the public road, unless waived or modified on showing of hardship or difficulty by the Zoning Administrator and, in the case of county or state highways, approved by the County Highway Department or district engineer of the Wisconsin Department of Transportation.
Used culverts are not permitted without authorization by the Zoning Administrator.
The property owner shall install the culvert and shall keep such culvert unobstructed and clean.
In no case shall the culvert diameter be less than 18 inches nor shall the culvert length be less two feet greater than the width of the driveway.
End walls need not be constructed unless so directed by the Zoning Administrator.
Culverts shall be placed in the ditch line at elevations that will assure proper drainage.
Material used for backfill shall be of a quality acceptable to the Town and shall be free from frozen lumps, wood, stumps, or other extraneous or perishable/biodegradeable materials.
The minimum cover, measured from the top of the culvert pipe to the top of the subgrade, shall be six inches.
Erosion control measures shall be implemented as necessary to control erosion when culvert and/or driveways are installed, as directed by the Town.
The property owner shall install the culvert and be responsible for the cost thereof. Illegal culverts shall be removed at the owner's expense following notice and a prior opportunity to correct. Maintenance of culverts and/or driveways and repair of defective culverts shall be the responsibility of property owners, except that when the Town does a reditching project and culverts are replaced, the Town will replace the culvert and pay the cost thereof.
Drainage; apron interference with pavement prohibited. The surface of the driveway connecting with the highway cross sections shall slope downward and away from the highway shoulder a sufficient distance to preclude ordinary surface water drainage from flowing onto the highway roadbed. Under no circumstances shall such driveway apron extend above any highway pavement surface.
Private drives, defined herein as private routes of ingress and egress from any public right-of-way which provides access to one residential unit or residential property, shall cut back all vegetation, trees, and shrubbery so that a ten-foot clearance height is provided. All branches and shrubbery shall also be cut to a distance of 10 feet on either side of the centerline of the traveled surface portion of the private drive.
[Added 11-11-2015 by Ord. No. 15-06]
The final inspection and approval for driveways will be made by the Town Chairperson or Zoning Administrator upon completion of construction.
No person, firm or corporation shall place, construct, or locate, or cause to be placed, constructed or located, any obstruction or structure within the right-of-way limits of any highway in the Town of Herman except as permitted by this chapter. As used herein, the term "structure" includes a private driveway, a portion of which extends into any highway, and which is in nonconformance with the requirements of this chapter. Filling of ditches and/or culverts located within a public right-of-way is prohibited without written approval from the Town Board.
Temporary driveways installed during building construction shall be removed prior to building occupancy, and restoration of the public right-of-way shall be completed within six months of such abandonment. Failure to restore the site to original condition may require the Town to correct the restoration and bill the property owner as a special charge.
Any person, partnership, company or corporation who or which violates any provision of this chapter shall pay, when a permit fee is required, double the required fee and shall remove, alter or correct the installation as ordered by the Town of Herman. If the owner or occupant does not correct the installation as ordered by the Town within the allotted time, the work of correcting the installation shall be done by the Town and the expenses thereof shall be charged against the property as a special charge pursuant to § 66.0627, Wis. Stats., after notice and hearing. In addition, a forfeiture penalty may also be applicable per § 1-4 of this Code, with each day of noncompliance being a separate violation.