Meter sockets shall be specified by the Borough, installed by the customer and maintained by the customer. The Borough reserves the right to disconnect service when a socket is not maintained in a safe, workmanlike operating manner. Meter sockets for transformer rated meter installations will be specified and provided by the Borough and paid for by the customer. Current transformers (CT's), test blocks, and other equipment required for the metering installation will be specified and provided by the Borough and paid for by the customer.
A. 
Generally. The Borough shall designate the location of meter(s). The customer shall provide a suitable place for the meter(s) and other equipment.
B. 
Mounting support. For secondary or primary metered installations, the customer shall provide a support or other facility as required for mounting of metering equipment. The customer is responsible for keeping metering areas clean, clear of debris, and accessible to the Borough at all times.
C. 
Position of multiple meters. At buildings where multiple meters are required, each meter position shall be clearly and visibly marked in a permanent fashion so that each meter position is identified as to the location to which service is being supplied.
The approach to meters shall not be hazardous nor obstructed and shall always be accessible for reading and testing.
Meters shall not be located where they are subject to injurious mechanical, thermal or chemical action.
Where meters are grouped together, the meters and service switches for each apartment suite or office shall be marked plainly and permanently for identification.
When necessary, meter loops extending 12 inches above the top of the meter entrance shall be provided.
No installation having more than two branch circuits will be allowed on a two-wire service.
All services shall conform to the current edition of the National Electrical Code.
The service for three or more branch circuits must be a three-wire cable service consisting of wires not smaller than No. 8.
Unless good and sufficient reason can be shown contrariwise, the Borough will require outdoor meter installations, except where otherwise directed by the Borough.
Where applicable, the consumer shall make provisions for the installation of a detachable Type S meter.
At least four feet of the service entrance wire shall be left projecting from the service entrance fitting for connection to the Borough's lines.
Where a consumer requires a single or polyphase service installation of more than four-hundred-ampere capacity, current transformers furnished by the Borough shall be installed.
A. 
Meter grouping. All meters in any one building shall be grouped in one location.
B. 
Capacity of meters. The meters, instrument transformers, service connections, and equipment supplied by the Borough for each customer have a definite load capacity and no additions to the equipment or connected load will be allowed except by prior written consent by the Borough.
C. 
Relocation of meters.
(1) 
At customer's request. All costs for moving an installed electric meter at the request of the customer will be borne by the customer.
(2) 
At Borough request. Relocation of the electric meter at the Borough's request will be done at no cost to the customer. The customer will be notified by mail so that arrangements can be made to curtail the electric service for reinstallation. If there is any violation of the terms and conditions of services under these rules and regulations that requires a relocation of the electric meter, the cost will be borne by the customer.