This article shall be known as "Maintenance of Vacant Buildings"
and is supplementary to applicable provisions of the New York State
Uniform Fire Prevention and Building Code.
This article provides standards governing the facilities and
the condition and maintenance of vacant premises to safeguard the
safety, health and welfare of the community.
This article shall be applicable to the following:
A. Lots, plots or parcels of land on which buildings designed for or
developed for residential use or occupancy, mixed-occupancy buildings,
nonresidential occupancy or accessory structures are located; and
B. Buildings designed for or developed for residential use or occupancy,
including one- and two-family dwellings and multiple dwellings, mixed-occupancy
buildings, nonresidential occupancy and accessory structures.
C. Definitions in Article
I of this chapter shall apply.
Provision for safe and continuous entry shall be provided to
the interior of a building or structure from the exterior at a street
or to a yard, court or passageway leading to a public open area at
any time entry is necessary for purposes of required maintenance or
inspection.
Railings or parapet walls shall be maintained at open sides
of balconies, mezzanines, porches, accessible roofs, exit passageways,
areaways, motor vehicle parking decks and ramps and around floor openings.
Chimneys, smokestacks, flues, gas vents, smoke pipes and connectors
shall be maintained structurally safe and smoketight.
Fuel gas pipe systems shall be maintained gastight, safe and
operative under conditions of use or shall be disconnected at the
main.
Tanks shall be maintained so as not to be a hazard or shall
be discontinued in a manner consistent with Chapter C of the State
Uniform Fire Prevention and Building Code (9 NYCRR).
Electrical fixtures, devices, wiring and systems shall be maintained
in safe working condition in a manner which will avoid a potential
source of ignition or shock, or service shall be discontinued at the
supply.
Elevators, dumbwaiters and escalators shall be maintained or
taken out of service, in accordance with ANSI A17.1.