[1991 Code § 185-9]
The sketch plat shall be based on Tax Map information or deed description, plotted at a scale preferably not less than 400 feet to the inch to enable the entire tract to be shown on one sheet, and shall show or include the following information:
A. 
The location of that portion which is to be subdivided in relation to the entire tract.
B. 
All existing structures and wooded areas within the portion to be subdivided and within 200 feet thereof.
C. 
The name of the owner and of all adjoining property owners as disclosed by the most recent municipal tax records.
D. 
The Tax Map sheet, block and lot numbers or such other tax data as is shown on the tax bill.
E. 
All streets or roads and streams within 500 feet of the subdivision.
[1991 Code § 185-10]
The preliminary plat shall be clearly and legibly drawn or reproduced at a scale of not less than one inch equals 100 feet. Preliminary plats shall be designed and drawn by a licensed (New Jersey) land surveyor or by a planner holding full or associate membership in the American Institute of Planners. The plat shall be designed in compliance with the provisions of Article 27-5 and shall show or be accompanied by the following information:
A. 
A key map showing the entire subdivision and its relation to surrounding areas.
B. 
The tract name, Tax Map sheet, block and lot number or other tax data as shown on the tax bill, date, reference meridian, graphic scale and the following names and addresses:
(1) 
The name and address of the record owner or owners.
(2) 
The name and address of the subdivider.
(3) 
The name and address of the person who prepared the map.
C. 
The acreage of the tract to be subdivided to the nearest tenth of an acre.
D. 
Sufficient elevations or contours to determine the general slope and natural drainage of the land and the high and low points and tentative cross sections and center-line profiles for all proposed new streets.
E. 
The location of existing and proposed property lines, streets, buildings, watercourses, railroads, bridges, culverts, drainpipes and any natural features such as wooded areas and rock formations.
F. 
Plans of proposed utility layouts (sewers, storm drains, water, gas, and electricity) showing feasible connections to existing or any proposed utility systems. When an individual water supply or sewage disposal system, or both, is proposed, the plan for the system must be approved by the appropriate local, County or State health agency. Any subdivision or part thereof which does not meet with the established requirements of this chapter or other applicable regulations shall not be approved. Any remedy proposed to overcome such a situation shall first be approved by the appropriate local, County or State health agency.
G. 
A copy of any protective covenants or deed restrictions applying to the land being subdivided shall be submitted with the preliminary plat.
[1991 Code § 185-11]
The final plat shall be drawn in ink on tracing cloth at a scale of not less than one inch equals 100 feet and in compliance with all the provisions of N.J.S. 46:23-9.9 et seq. The final plat shall show or be accompanied by the following:
A. 
The date, the name and location of the subdivision, the name of the owner, a graphic scale and a reference meridian.
B. 
The tract boundary lines, right-of-way lines of streets, street names, easements and other rights-of-way, land to be reserved or dedicated to public use, all lot lines and other site lines, with accurate dimensions, bearings or deflection angles, and radii, arcs, and central angles of all curves.
C. 
The purpose of any easement or land reserved or dedicated to public use shall be designated, and the proposed use of sites other than residential shall be noted.
D. 
Each block shall be numbered, and the lots within each block shall be numbered consecutively beginning with number one.
E. 
The minimum building setback line on all lots and other sites.
F. 
The location and description of all monuments.
G. 
The names of owners of adjoining unsubdivided land.
H. 
Certification by an engineer or surveyor as to the accuracy of the details of the plat.
I. 
Certification that the applicant is the agent or owner of the land or that the owner has given consent under an option agreement.
J. 
When approval of a plat is required by any officer or body of such a municipality, County or State, approval shall be certified on the plat.
K. 
Cross sections and profiles of streets, approved by the Municipal Engineer, shall be required to accompany the final plat.
L. 
Contours at five foot intervals for slopes averaging 10% or greater and at two foot intervals for land of lesser slope, if required by the Planning Board.
M. 
Plans and profiles of storm and sanitary sewers and water mains.
N. 
A certificate from the Tax Collector that all taxes are paid to date.