It shall be unlawful for any person to discharge or cause to
be discharged any wastewater into any storm drain or watercourse within
the city, except for those persons with approved permits for such
discharges.
(Ordinance 450-12, sec. 3(A), adopted 1/19/12)
No person shall discharge or cause to be discharged any stormwater,
groundwater, roof runoff, subsurface drainage or drainage from downspouts,
yard drains, yard fountains and ponds, or lawn sprays into any sanitary
sewer. Water from swimming pools, unpolluted industrial water, or
cooling water from various equipment shall not be discharged into
sanitary sewers if an alternate acceptable means of disposal is available.
If an alternate acceptable means of disposal is not available, such
water may be discharged into the sanitary sewer provided the water
meets the discharge prohibitions and limitations of this article.
(Ordinance 450-12, sec. 3(B), adopted 1/19/12)
It shall be unlawful for any person to deposit or discharge
into the sanitary sewer any wastewater or solid, including trucked
or hauled wastes, unless such deposit or discharge, at a designated
discharge point, has been approved by the authority.
(Ordinance 450-12, sec. 3(C), adopted 1/19/12)
No person shall contribute or cause to be discharged directly
or indirectly, into any public sanitary sewer, any of the following
described substances, materials, water or waste:
(1) Any liquid or vapor having a temperature higher than one hundred
fifty (150) degrees Fahrenheit (65 degrees centigrade).
(2) Any water or waste which contains wax, grease, oil, plastic or other
substance that will solidify or become discernibly viscous at temperatures
between thirty-two (32) degrees to one hundred fifty (150) degrees
Fahrenheit, thereby contributing to clogging, plugging or otherwise
restricting the flow of wastewater through the collection system.
(3) Pollutants which create a fire or explosion hazard in the sewer system
or POTW, including but not limited to waste streams with a closed
cup flashpoint of less than 140 degrees Fahrenheit or 60 degrees centigrade
using the test methods specified in 40 CFR part 261.21. This includes
flammable or explosive liquids, solids or gases such as gasoline,
kerosene, benzene, naphtha, etc., which by reason of their chemical
properties or quantity may be sufficient, either alone or by interaction,
to cause fire or explosion.
(4) Solid or viscous substances in quantities capable of causing obstruction
in the flow in sewers or other interference with proper operation
of the POTW, such as, but not limited to, ashes, cinders, sand, mud,
straw, shavings, metal, glass, rags, feathers, tar, plastics, wood,
whole blood, paunch manure, hair and fleshings, entrails, lime slurry,
lime residues, slops, chemical residues, paint residues, or bulk solids.
(5) Any garbage that has not been properly comminuted or shredded to
such a degree that all particles will be carried freely under the
flow conditions normally prevailing in public sewers, with no particle
greater than one-half (1/2) inch in any dimension.
(6) Any noxious or malodorous substances which can form a gas which,
either singly or by interaction with other wastes, is capable of causing
objectionable odors or hazards to life or forms solids in concentrations
exceeding limits established in this article, or creates any other
condition deleterious to structures or treatment processes, or requires
unusual provisions, attention or expense to handle such material.
(7) Any noxious or malodorous liquids, gases, or solids which either
singly or by interaction are capable of creating a public nuisance
or hazard to life or which may prevent entry into the sewers for their
maintenance and repair.
(8) Any substance which may cause the POTW’s effluent or treatment
residues, sludges, or scums to be unsuitable for reclamation and reuse
or to interfere with the reclamation process as determined pursuant
to criteria in this article. In no case shall a substance discharged
to the POTW cause the POTW to be in noncompliance with sludge use
or disposal criteria, guidelines or regulations developed under section
405 of the Act or any criteria, guidelines or regulations affecting
sludge use or disposal developed pursuant to the Solid Waste Disposal
Act, the Resource Conservation and Recovery Act, the Clean Air Act,
the Toxic Substances Control Act or state standards applicable to
the sludge management method being used.
(9) Any substance which will cause the POTW to violate its TPDES or other
disposal system permits, or the receiving stream water quality standards.
(10) Any substance with objectionable color not removed in the treatment
process, such as, but not limited to, dye wastes and vegetable tanning
solutions.
(11) Any slugload. Also, oxygen-demanding pollutants (BOD, etc.) released
in a discharge at a flow rate and/or pollutant concentration which,
either singly or by interaction with other pollutants, will cause
interference with the POTW.
(12) Any wastewater which causes a hazard to human life or creates a public
nuisance.
(13) Any dump or slugload of waste containing concentrated organic solvents
or mixtures of solvents which are defined as hazardous by the Federal
Resource Conservation and Recovery Act.
(14) Petroleum oil, nonbiodegradable cutting oil, or products of mineral
oil origin in amounts that will cause obstruction of flow in the sewer
line, or interference or pass-through.
(15) Deny or condition new or increased contributions of pollutants, or
changes in the nature of pollutants, to the POTW by industrial users
where such contributions do not meet applicable pretreatment standards
and requirements or where such contributions would cause the POTW
to violate its TPDES permit.
(16) Hydrogen sulfide, sulfur dioxide or nitrous oxide in excess of 10
parts per million.
(17) Radioactive wastes or isotopes with a half-life or concentration
exceeding limits established by the authority in compliance with applicable
state or federal regulations.
(18) Toxic pollutants in sufficient quantity, either singly or by interaction
with other wastes, to injure or interfere with any wastewater treatment
process, constitute a hazard to humans or animals, or pass through
the treatment plant and impair aquatic life in receiving water, as
expressed by the results of acute or chronic toxicity tests of the
POTW effluent.
(19) A temperature which inhibits or interferes with biological activity
in the POTW treatment plant. In no case shall wastewater be introduced
which would have a temperature exceeding 40°C (104°F) upon
entering the POTW treatment plant.
(20) Pollutants in excess of the limitations established in an applicable
categorical pretreatment standard set forth in title 40 of the Code
of Federal Regulations.
(21) Wastewaters which emanate vapors causing the atmosphere in the sewer
system to exceed 20% of the lower explosive limit in the immediate
area of the discharge.
(22) BTEX concentration greater than 1.0 mg/l.
(23) Oil and grease.
(A) Petroleum oil, nonbiodegradable cutting oil, or non-polar products
of mineral oil origin in concentrations greater than 200 mg/l.
(B) Visible free floatable polar oils, fats, or grease or a concentration
greater than 250 mg/l in wastewater discharged from industrial or
commercial facilities into the POTW.
(C) In no case shall discharges in amounts that cause interference or
operational problems with the POTW be allowed.
(Ordinance 450-12, sec. 3(D), adopted 1/19/12)
No person shall contribute or cause to be discharged, directly
or indirectly, into any sanitary sewer any wastewaters containing
or having:
(1) Acids or alkalis capable of causing damage to sewage disposal structures
or personnel or having a pH value lower than 5.0 or higher than 12.0.
(2) Metals in the form of compounds or elements with total concentrations
exceeding the following:
Pollutant
|
Maximum Allowable Discharge Limit
(mg/l)
|
---|
Arsenic
|
0.25
|
Cadmium
|
0.15
|
Chromium
|
5.0
|
Copper
|
4.0
|
Lead
|
2.9
|
Mercury
|
0.01
|
Nickel
|
2.0
|
Silver
|
1.0
|
Zinc
|
5.0
|
(3) Cyanide or cyanogen compounds (expressed as total CN) in excess of
1.0 mg/l.
(4) The director may develop best management practices (BMPs), by ordinance
or in individual wastewater discharge permits, to help implement local
limits and other pretreatment standards and the requirements of this
article.
(5) A person commits an offense if with criminal negligence the person
processes or stores pollutants, substances, or wastewater prohibited
by this article in such a manner that they could be discharged to
the POTW.
(Ordinance 450-12, sec. 3(E), adopted 1/19/12)