Alleys may be required to be constructed in industrial and commercial
districts and where necessary to control access to thoroughfares and
major streets.
(Ord. 88-O-117 § 1, 1988)
Minimum alley widths shall be as follows:
(1)
Alleys only in industrial or commercial zones: Right-of-way and pavement
widths shall be 28 feet.
(2)
Alleys only in residential zones: Right-of-way and pavement widths
shall be 20 feet.
(3)
Alleys abutting various zones: Right-of-way and pavement widths shall
be a minimum of 20 feet and a maximum of 28 feet. Actual width to
be determined by the city engineer based on the approved land use
for the abutting property.
(4)
Santa Fe Commercial District: The following alleys shall be a minimum
of 15 feet in right-of-way and pavement width. The city council may
increase this width upon recommendation of the city engineer where
such additional width is required to improve access to abutting properties.
(A)
The alley running north and south from Chapman Avenue to Center Street
between Melrose Street and Main Street;
(B)
The alley running north and south from approximately 200 feet south
of Chapman Avenue to Center Street between Main Street and Bradford
Avenue;
(C)
The alleys running north and south from Center Street to the alley
approximately 100 feet north of Santa Fe Avenue between Melrose Street
and Main Street and between Main Street and Bradford Avenue;
(D)
The alleys running north and south from Santa Fe Avenue to 100 feet
north of and 100 feet south of Santa Fe Avenue between Walnut Avenue
and Melrose Street;
(E)
The alleys running north and south from approximately 400 feet north
of Center Street to Santa Fe Avenue between Bradford Avenue and Alta
Street.
(Ord. 88-O-117 § 1, 1988; Ord. 89-O-105 § 1, 1989)
All alleys shall have concrete gutters with a minimum width
of four feet and a minimum thickness of six inches (6").
(Ord. 88-O-117 § 1, 1988)
Alleys at the rear of industrial or commercial property shall
be subject to determination by the city as to design and location.
(Ord. 88-O-117 § 1, 1988)
Where two alleys intercept or intersect, the corner shall be
cut on straight line connecting points on both lot lines fifteen feet
(15f) or rounded as per standards on file in the office of the city
engineer.
(Ord. 88-O-117 § 1, 1988)
