Note: Chapter 22.36 was removed from the code in the 8-89 supplement, in accordance with Ord. 88-O-117. At the city's request, this chapter was, in the 8-90 supplement, returned to the code.
Driveways shall not be permitted in locations that will create
a dangerous or hazardous condition.
(Ord. 76-O-115, 1976)
Maximum driveway openings, as measured at the bottom of the
fully depressed area, shall be as follows:
(1)
Residential District. Maximum driveway width shall not exceed 24
feet;
(2)
Commercial or Industrial Districts. Maximum driveway width shall
not exceed 35 feet.
(Ord. 76-O-115, 1976)
Length of tapered curb for driveways shall be three feet.
(Ord. 76-O-115, 1976)
Minimum driveway spacings shall be as follows:
(1)
Residential District.
(A)
Two feet of full height curb is required between a driveway and a
property line extended to curbline;
(B)
No part of any driveway may be located within five feet of the corner
curb radius;
(C)
Curb cuts for driveways shall be so located that the distance between
said cuts shall be in multiples of 20 feet or to the satisfaction
of the city engineer;
(D)
Driveways on corner lots shall be on the 50% of the lot frontage
most distant from the corner curb radii;
(E)
Driveways on interior lots which have a side lot line adjoining the
rear lot line of an adjacent lot shall be set back a minimum of 20
feet from said side lot line.
(2)
Commercial or Industrial District.
(A)
Twenty-two foot minimum of full height curb is required between driveways
serving the same parcel;
(B)
Two feet of full height curb is required between a driveway and a
property line extended to the curbline with the exception that one
driveway serving adjacent properties may be required by the planning
commission to alleviate traffic congestion;
(C)
No part of any driveway may be located within five feet of a corner
curb radius.
(Ord. 76-O-115, 1976)
