In any proposed subdivision in which a proposed street is to
be constructed, the subdivider shall require all utility facilities,
including without limitation telephone and electric lines, to be installed
underground at no expense to the Town. This section is not to conflict
in any way with the power of the Connecticut Public Utilities Commission
to regulate said public utility companies.
[Effective 11-13-1989; 5-14-2001]
A. Driveways shall be designed to accommodate essential service and emergency vehicles with minimum disturbance or alteration of the natural terrain and the indigenous character of the land. Proposed driveways shall be shown on the supplemental map submitted with the application and shall be designed and constructed so as not to cast water on the surface of any existing or proposed street and in compliance with Article
IX of Chapter
185, Road Construction. Areas adjacent to the driveway must be graded to avoid erosion on or off the driveway.
[Amended effective 8-16-2004; 1-1-2007]
(1) All lots shall provide for off-street parking in accordance with
the Zoning Regulations of the Town or Borough, as applicable.
(2) The Commission may allow a lot having adequate street frontage to utilize a shared driveway with a neighboring lot in accordance with the common driveway provisions of Subsection
C, provided that the Inland Wetlands Commission has issued a written recommendation calling for a common driveway in order to avoid a wetlands disturbance or crossing for the driveway construction.
B. Design standards. Driveways shall meet the following standards:
(1) Driveway intersection. All driveways shall intersect the street in a location having the sight distance required by Article
IX of Chapter
185, Road Construction, and shall intersect the street at right angles when possible.
[Amended effective 8-16-2004; 4-1-2008]
(2) Travel width. The minimum travel width of the driveway shall be 10
feet. Driveways serving more than one dwelling shall at no point be
less than 16 feet wide.
(3) Loading rates. All culverts and bridges located under a driveway
shall be designed to carry H20 live loads.
(4) Grading. The driveway grade shall be 5% or less for the first 30
feet measured in from the edge of the street. For the purpose of this
regulation, the term "street" shall apply to both public and private
roadways. Driveways within the lot shall not contain grades greater
than 15% nor average more than 12%. Driveway sections having grades
of 12% or more shall be paved with bituminous concrete or other equal
all-weather surface, including 10 feet preceding and following the
12% or more grades.
[Amended effective 4-1-2008]
(5) Parking area. An area for parking shall be provided in the driveway
within 30 feet of a dwelling. Such parking area shall have a minimum
length of 35 feet and a grade of not more than 5%.
(6) Turning radius. The minimum center turning radius on driveway curves
shall be not less than 37 feet. Based on driveway configuration, the
Town Engineer may determine that a turning radius greater than 37
feet is required for proper accessibility and safety.
[Amended effective 4-14-2003]
(7) Pull-off areas. Driveways longer than 250 feet shall include a pull-off
area to accommodate emergency vehicles. The minimum driveway width
at pull-off areas shall be 16 feet wide and a minimum of 25 feet long.
The maximum distance between pull-off areas shall be 250 feet. A common
driveway of 16 feet in width shall be deemed to have met the requirements
of this section.
(8) Aprons. The entrance of the driveway at the street intersection shall be constructed in accordance with Article
IX of Chapter
185, Road Construction.
[Amended effective 8-16-2004]
C. If the final subdivision plan proposes the creation of rear lots with access strips as permitted by Chapter
595, Zoning, §§ 595-178, and two such strips adjoin each other, the supplemental map shall show, in addition to driveways wholly within each lot as required above, a single, common driveway constructed of bituminous concrete not less than 16 feet wide from the street to the point where the shorter of (or both of) the access strips terminate, together with turnouts to permit passage of emergency vehicles at such intervals as dictated by good engineering practice. The common driveway may be anywhere within the two access strips. Estimates of the cost of construction of the driveway and associated drainage and landscaping shall be submitted by the professional engineer and included within the subdivision bond. The common driveway, drainage and associated landscaping shall be constructed by the subdivider as a subdivision improvement. The subdivider shall submit with the subdivision application an executed covenant and dedication establishing a cross easement on the shared access strips permitting ingress and egress by all lawful means and for all lawful purposes in favor of each lot, together with a requirement that the owner of each lot will, after both lots are improved, share equally the cost of, at a minimum, plowing and pothole repair. A lot shall be considered improved if construction of a structure other than the common driveway has begun on the lot.
[Amended effective 4-1-2008]
D. The Commission may require the subdivider to locate access strips
to rear lots adjacent to each other in order to gain the benefits
of the common driveway provisions. Any final subdivisions plan which
contains adjoining access to rear lots shall show the common driveway
as it is to be built. Such subdivision plans shall contain the following
note for each set of adjacent access strips: "Lots (insert lot #)
and (insert lot #) share a common driveway." The owner of each such
lot shall have the right to enter the access strip of the other lot
for purposes of maintenance, repair or replacement of said driveway.
E. After a common driveway is constructed, separate driveways serving each lot shall not be built unless a special permit is issued by the Commission pursuant to Chapter
595, Zoning.
Lot sizes and road frontages shall meet the requirements of
the Zoning Regulations of the Town or Borough as applicable. Any lot
in a proposed subdivision on which a building or other improvement
is located shall meet the front, side and rear yard requirements of
the Zoning Regulations of the Town or Borough, as applicable, except where the inability to meet said requirements arises
because of the relation of said existing buildings or improvements
with an existing building or improvements with an existing street
or property line. Side lot lines shall generally be at right angles
to straight street lines, or radial to curved street lines. Except
in cases of unusual topography property lines, through lots bounding
on two generally parallel streets will not be permitted. No parcel,
strip, blocking strip or other remnant of land incapable of being
a minimum lot in the zoning district in which it lies shall be left
in any subdivision.
The applicant shall obtain the Selectman's approval of all proposed
street names prior to submission of the application for final approval.
Street names shall be shown on all applicable documents submitted
to the Commission.
Stone or concrete monuments conforming to Town specifications
shall be set at the street line at all points of curvature, points
of tangency, single points and other intermediate points as may be
required by the Town Engineer, and monuments shall be as approved
by the Town Engineer and set as directed by the Town Engineer at the
subdivider's expense. The proposed location of said monuments shall
be indicated on the final subdivision plan.
Where not otherwise marked as set forth in §
560-32, lot corners shall be marked with iron pins at least 1/2 inch in diameter and set at least 18 inches in the ground, with part of said pin left visible above finished grade. Such pins and monuments specified in §
560-32 shall be set prior to the conveyance of said lot by the subdivider or his assignee.
Adjoining subdivisions and sections thereof and subdivisions
under the same ownership shall not duplicate lot numbers but shall
continue the sequence of numbers used previously. Generally, all lots
on the north and east sides of a street shall be even numbers and
lots on the south and west sides of a street shall be odd numbers.
[Amended effective 8-30-2004]
All documents required to be completed by a registered land
surveyor, professional engineer or landscape architect shall bear
the appropriate seal and certification.
Subdivisions plans which were not and are not filed with the
Town Clerk within 90 days after receiving approval and subdivision
plans filed with the Town Clerk prior to February 8, 1956, are not,
and shall not be, considered as approved subdivision plans.