No user shall contribute or cause to be contributed, directly
or indirectly, any pollutant or wastewater which will interfere with
the operation or performance of the POTW. These general prohibitions
apply to all such users of a POTW, whether or not the user is subject
to National Categorical Pretreatment Standards or any other national,
state or local pretreatment standards or requirements.
A. A user may not contribute the following substances to any POTW:
(1) Any liquids, solids or gases which by reason of their nature or quantity
are or may be sufficient either alone or by interaction with other
substances to cause fire or explosion or be injurious in any other
way to the POTW or to the operation of the POTW. At no time shall
two successive readings on an explosion hazard meter at the point
of discharge into the system (or at any point in the system) be more
than 5% nor any single reading over 10% of the lower explosive limit
(LEL) of the meter. Prohibited materials include, but are not limited
to, gasoline, kerosene, naphtha, benzene, toluene, xylene, ethers,
alcohols, ketones, aldehydes, peroxides, chlorates, perchlorates,
bromates, carbides, hydrides and sulfides and any other substances
which the Village, the state or EPA has notified the user is a fire
hazard or a hazard to the system.
(2) Solid or viscous substances which may cause obstruction to the flow
in a sewer or other interference with the operation of the wastewater
treatment facilities such as, but not limited to: grease, garbage
with particles greater than 1/2 inch in any dimension, animal guts
or tissues, paunch manure, bones, hair, hides or fleshings, entrails,
whole blood, feathers, ashes, cinders, sand, spent lime, stone or
marble dust, metal, glass, straw, shavings, grass clippings, rags,
spent grains, spent hops, wastepaper, wood, plastics, gas, tar, asphalt
residues, residues from refining or processing of fuel or lubricating
oil, mud or glass grinding or polishing wastes.
(3) Any wastewater having a pH less than 5.0, unless the POTW is specifically
designed to accommodate such wastewater, or wastewater having any
other corrosive property capable of causing damage or hazard to structures,
equipment and/or personnel of the POTW.
(4) Any wastewater containing toxic pollutants in sufficient quantity,
either singly or by interaction with other pollutants, to injure or
interfere with any wastewater treatment process, constitute a hazard
to humans or animals, create a toxic effect in the receiving waters
of the POTW or to exceed the limitation set forth in a categorical
pretreatment standard. A toxic pollutant shall include but not be
limited to any pollutant identified pursuant to § 307(a)
of the Act.
(5) Any noxious or malodorous liquids, gases or solids which either singly
or by interaction with other wastes are sufficient to create a public
nuisance or hazard to life or are sufficient to prevent entry into
the sewers for their maintenance and repair.
(6) Any substance which may cause the POTW's effluent or any other
product of the POTW, such as residues, sludges or scums, to be unsuitable
for reclamation and reuse or to interfere with the reclamation process
where the POTW is pursuing a reuse and reclamation program. In no
case shall a substance discharged to the POTW cause the POTW to be
in noncompliance with sludge use or disposal criteria, guidelines
or regulations developed under § 405 of the Act; any criteria,
guidelines or regulations affecting sludge use or disposal developed
pursuant to the Solid Waste Disposal Act, the Clean Air Act, the Toxic
Substances Control Act or state criteria applicable to the sludge
management method being used.
(7) Any substance which will cause the POTW to violate its NPDES and/or
state disposal system permit or the receiving water quality standards.
(8) Any wastewater with objectionable color not removed in the treatment
process, such as, but not limited to, dye wastes and vegetable tanning
solutions.
(9) Any wastewater having a temperature which will inhibit biological
activity in the POTW treatment plant resulting in interference, but
in no case wastewater with a temperature at the introduction into
the POTW which exceeds 40° C. (104° F.) unless the POTW treatment
plant is designed to accommodate such temperature.
(10)
Any pollutants, including oxygen demanding pollutants (BOD,
etc.), released at a flow and/or pollutant concentration which a user
knows or has reason to know will cause interference to the POTW. In
no case shall a slug load have a flow rate or contain concentration
or qualities of pollutants that exceed for any time period longer
than 15 minutes more than five times the average twenty-four-hour
concentration, quantities or flow during normal operation.
(11)
Any wastewater containing any radioactive wastes or isotopes
of such half-life or concentration as may exceed limits established
by the Superintendent in compliance with applicable state or federal
regulations.
(12)
Any wastewater which causes a hazard to human life or creates
a public nuisance.
B. When the Superintendent determines that a user(s) is contributing
to the POTW any of the above enumerated substances in such amounts
as to interfere with the operation of the POTW, the Superintendent
shall advise the user(s) of the impact of the contribution on the
POTW and develop effluent limitation(s) for such user to correct the
interference with the POTW.
Upon the promulgation of the Federal Categorical Pretreatment
Standard for a particular industrial subcategory, the federal standard,
if more stringent than limitations imposed under this Part 1 for sources
in that subcategory, shall immediately supersede the limitations imposed
under this Part 1. The Superintendent shall notify all affected users
of the applicable reporting requirements under 40 CFR 403.12.
Where the Village wastewater treatment system achieves consistent
removal of pollutants limited by federal pretreatment standards, the
Village may apply to the approval authority for modification of specific
limits in the federal pretreatment standards. Consistent removal shall
mean reduction in the amount of a pollutant or alteration of the nature
of the pollutant by the wastewater treatment system to a less toxic
or harmless state in the effluent which is achieved by the system
in 95% of the samples taken when measured according to the procedures
set forth in § 403.7(c)(2) of (40 CFR 403) General Pretreatment
Regulations for Existing and New Sources of Pollution promulgated
pursuant to the Act. The Village may modify pollutant discharge limits
in the federal pretreatment standards if the requirements contained
in 40 CFR 403.7 are fulfilled and prior approval from the approval
authority is obtained.
No person shall discharge wastewater containing in excess of:
1.0
|
mg/l arsenic
|
0.3
|
mg/l cadmium
|
0.2
|
mg/l copper
|
1.0
|
mg/l cyanide
|
0.1
|
mg/l lead
|
0.1
|
mg/l mercury
|
2.0
|
mg/l nickel
|
0.1
|
mg/l silver
|
2.0
|
mg/l total chromium
|
0.5
|
mg/l zinc
|
0.1
|
mg/l total identifiable chlorinated hydrocarbons
|
10.0
|
mg/l phenolic compounds which cannot be removed by the Village
wastewater treatment processes.
|
State requirements and limitations on discharges shall apply
in any case where they are more stringent than federal requirements
and limitations or those in this Part 1.
The Village reserves the right to establish by local law more stringent limitations or requirements on discharges to the wastewater disposal system if deemed necessary to comply with the objectives presented in §
116-2 of this Part
1.
No user shall ever increase the use of process water or in any way attempt to dilute a discharge as a partial or complete substitute for adequate treatment to achieve compliance with the limitations contained in the Federal Categorical Pretreatment Standards or in any other pollutant-specific limitation developed by the Village or state. (Comment: Dilution may be an acceptable means of complying with some of the prohibitions set forth in §
116-5, e.g., the pH prohibition).
[Added 3-12-2020 by L.L. No. 1-2020]
No person, firm or corporation shall discharge, or cause to
be discharged, any stormwater, groundwater, roof runoff, subsurface
drainage, or drainage from downspouts, yard drains, sump pumps, yard
or building foundations, ponds, or lawn sprays into any Village sanitary
sewer systems or pipes.