[R.O. 2006 §700.180; Ord. No. 744 §1, 2-16-1993]
For the purposes of this Chapter, the following terms shall
be deemed to have the meanings indicated below:
AIR-GAP SEPARATION
The unobstructed vertical distance through the free atmosphere
between the lowest opening from any pipe or faucet supplying water
to a tank, plumbing fixture, or other device and the flood level rim
of the receptacle, and shall be at least double the diameter of the
supply pipe measured vertically above the flood level rim of the vessel.
In no case shall the gap be less than one (1) inch.
APPROVED
The term "approved" as herein used in reference
to a water supply system or backflow prevention device (or method)
shall mean one that has been approved by the State regulatory agency.
AUXILIARY SUPPLY
Any water source or system, other than the public water supply,
that may be available in the building or premises.
BACK PRESSURE
Backflow caused by a pump, elevated tank, boiler, or other
means that could create pressure within the system greater than the
supply pressure.
BACK SIPHONAGE
A form of backflow due to a negative or subatmospheric pressure
within a water system.
BACKFLOW
The flow other than the intended direction of flow, of any
foreign liquids, gases, or substances into the distribution system
of a public water supply.
CONSUMER
The owner or operator of a private potable water system served
by a public potable water system.
CROSS-CONNECTION
Any physical arrangement whereby a public water supply is
connected, directly or indirectly, with any other water supply system,
sewer, drain, conduit, pool, storage reservoir, plumbing fixture,
or other device which contains, or may contain, contaminated water,
sewage, or other waste or liquid of unknown or unsafe quality which
may be capable of imparting contamination to the public water supply
as a result of backflow. Bypass arrangements, jumper connections,
removable sections, swivel or change-over devices, and other temporary
or permanent devices through which or because of which, backflow could
occur are considered to be cross-connections.
CROSS-CONNECTION, POINT OF
The specific point or location in a public or a consumer's
potable water system where a cross-connection exists.
DOUBLE-CHECK VALVE ASSEMBLY
An assembly composed of two (2) single, independently acting
check valves, including tightly closing shutoff valves located at
each end of the assembly and suitable connections for in-line testing
the watertightness of each check valve.
HAZARD, DEGREE OF
Expresses the results of any evaluation of a health, system,
or plumbing hazard.
HAZARD, HEALTH
Any condition, device, or practice in a water supply system
and its operation that created, or may create, a danger to the health
and well-being of a consumer.
HAZARD, PLUMBING
A cross-connection in a consumer's potable water system that
may permit back siphonage in the event of a negative pressure in the
supply line. (Unprotected plumbing-type cross-connections are considered
to be health hazards. They include, but are not limited to, faulty
connections to fixtures such as toilets, sinks, tubs, lavatories,
wash trays, and domestic washing machines.)
INDUSTRIAL FLUIDS
Any fluid or solution that may chemically, biologically,
or physically degrade the approved water supply.
INDUSTRIAL LINE
A separate water piping system serving water-using devices,
with a backflow preventer or air-gap separation on this line at the
point of takeoff from the potable water line.
INDUSTRIAL PIPING SYSTEM, CONSUMERS
A system used by a consumer for transmission or storage of
anything (fluid, solid, or gas) other than the water supply intended
or used for human consumption or food processing. (Such a system would
include all pipes, conduits, tanks, receptacles, fixtures, equipment,
and appurtenances used to produce, convey, or store substances that
are or may be polluted.)
LABORATORY, APPROVED TESTING
One that is approved by the appropriate health agency and
water laboratory and is properly staffed and equipped with pumps,
meters, measuring devices, and other equipment to test and evaluate
fully a backflow prevention device for design, materials, construction,
and operation.
POLLUTION
The presence in water of any foreign substance (organic,
inorganic, radiologic, or biologic) that tends to degrade its quality
so as to constitute a hazard or to impair is potability or usefulness.
POTABLE WATER
Water that is safe for drinking, personal, or culinary use.
PUBLIC WATER SUPPLY
Any system of water supply intended or used for human consumption
or other domestic uses, including source, treatment, storage, transmission
and distribution facilities where water is furnished to any community,
collection or number of individuals, or is made available to the public
for human consumption or domestic use, but excluding water supplies
serving one (1) single family residence.
REDUCED PRESSURE PRINCIPAL BACKFLOW PREVENTION DEVICE
A device incorporating two (2) or more check valves and an
automatically operating differential relief valve located between
the two (2) checks, two (2) shutoff valves, and equipped with necessary
appurtenances for in-line testing. The device shall operate to maintain
the pressure in the zone between the two (2) check valves, less than
the pressure on the public water supply side of the device. At cessation
of normal flow, the pressure between the check valves shall be less
than the supply pressure. In case of leakage of either check valve,
the differential relief valve shall operate to maintain this reduced
pressure in two (2) pounds per square inch or less, the relief valve
shall open to the atmosphere thereby providing an air-gap in the device.
SERVICE CONNECTION
The terminal end of a service from the public potable water
system, that is, where the water purveyor loses jurisdiction and sanitary
control over the water at its point of delivery to the consumer's
water system.
WATER DELIVERED (DELIVERED WATER)
Any water supplied from a public potable water system to
a consumer's water system after it has passed the point of delivery
and is no longer under the sanitary control of the water system operator.
WATER SUPERVISOR
The consumer or his/her deputy charged with the responsibility
of maintaining a consumer's water system free from cross-connections
and other sanitary defects. (A certified backflow prevention device
tester should not act as a water supervisor unless he/she is a full-time
employee of the consumer, having the day-to-day responsibility for
the installation and use of pipelines and equipment on the premises
and for the avoidance of cross-connections.)
WATER SUPPLY, APPROVED
Any public or consumer's potable water supply that has been
investigated and approved by the State agency having jurisdiction.
WATER SYSTEM, PUBLIC POTABLE
Any publicly owned domestic water system operated under public
health supervision. Such a system includes all sources, facilities,
and appurtenances between the source and the point of delivery, such
as valves, pumps, pipes, conduits, tanks, receptacles, fixtures, equipment,
and appurtenances used to produce, convey, treat, or store a potable
water for public consumption or use.
[R.O. 2006 §700.190; Ord. No. 744 §2, 2-16-1993]
A. The
purpose of this Article is to:
1. Establish a cross-connection control program to protect the health
of water consumers by the control of actual and/or potential cross-connections
through the proper installation and surveillance of backflow prevention
devices on service lines leading to premises where cross-connections
exist or are likely to occur and through the inspection and regulation
of plumbing within the premises to minimize the danger of contamination
of the water system on the premises or the public water supply itself.
2. Protect these supplies against contamination or pollution resulting
from backflow of objectionable fluids through cross-connections.
3. Protect these supplies at the service connection by isolating within
the consumer's premises pollution or contamination that may result
from backflow through cross-connections.
4. Provide means whereby an industrial consumer may utilize a separate
system for his/her industrial uses so as to prevent possible pollution
or contamination of his/her internal potable water system.
[R.O. 2006 §700.200; Ord. No. 744 §3, 2-16-1993]
The implementation of the program to control cross-connections
requires cooperation between the customer, the City Water Department,
the Health Officer and the plumbing authority. The City Water Department
has primary responsibility to prevent contamination of the public
water supply through cross-connections. The customers served and the
Department are jointly responsible for preventing contamination of
the water system within the customer's premises. An effective control
program requires attention to both of these. Backflow prevention devices
are not a substitute for a continuing and aggressive program of cross-connection
investigation, surveillance and control.
[R.O. 2006 §700.210; Ord. No. 744 §4, 2-16-1993]
These regulations will be reasonably interpreted by the City
Water Department. It is the Department's intent to recognize the varying
degrees of hazard and to apply the principle that the degree of protection
shall be commensurate with the degree of hazard.
[R.O. 2006 §700.220; Ord. No. 744 §5, 2-16-1993]
All cross-connections, whether or not such cross-connections
are controlled by automatic devices, such as check valves or by hand-operated
mechanisms such as gate valves or stop cocks, are hereby prohibited.
[R.O. 2006 §700.230; Ord. No. 744 §6, 2-16-1993]
Failure on the part of persons, firms, or corporations to discontinue
the use of any and all cross-connections and to physically separate
such cross-connections will be sufficient cause for the discontinuance
of the public water service to the premises on which the cross-connection
exists.
[R.O. 2006 §700.240; Ord. No. 744 §7, 2-16-1993]
The City Water Department shall, in cooperation with the Health
Officer and/or the local plumbing inspection authority, make periodic
inspections of premises served by the water supply to check for the
presence of cross-connections. Any cross-connections found in such
inspection shall be ordered removed by the Department. If an immediate
hazard to health is caused by the cross-connection, water service
to the premises shall be discontinued until it is verified that the
cross-connection has been removed.
[R.O. 2006 §700.250; Ord. No. 744 §8, 2-16-1993]
A. Backflow
prevention devices shall be installed at the service connection or
within any premises where, in the judgment of the City Water Department,
the nature and the extent of activities on the premises, or the materials
used in connection with the activities, or materials stored on the
premises would present an immediate and dangerous hazard to health
should a cross-connection occur, even though such cross-connection
does not exist at the time the backflow prevention device is required
to be installed. This shall include but not be limited to the following
situations:
1. Premises having an auxiliary water supply, unless the quality of
the auxiliary supply is in compliance with local standards, and is
acceptable to the Department.
2. Premises having internal cross-connections that are not correctable,
or intricate plumbing arrangements which make it impracticable to
ascertain whether or not cross-connections exist.
3. Premises where entry is restricted so that inspections for cross-connections
cannot be made with sufficient frequency or at sufficiently short
notice to assure that cross-connections do not exist.
4. Premises having a repeated history of cross-connections being established
or re-established.
5. Premises on which any substance is handled under pressure so as to
permit entry into the public water supply, or where a cross-connection
could reasonably be expected to occur. This shall include the handling
of process waters and cooling waters.
6. Premises where materials of a toxic or hazardous nature are handled
such that if back siphonage should occur, a serious health hazard
may result.
7. The following types of facilities will fall into one (1) of the above
categories where a backflow prevention device is required to protect
the public water supply. A backflow prevention device shall be installed
at these facilities unless the Department determines no hazard exists
(Partial List):
|
Auxiliary water systems
|
|
Chemical plants using a water process
|
|
Cooling systems
|
|
Farming operations
|
|
Film processing equipment
|
|
Fire protection systems
|
|
Food or beverage processing plants
|
|
Hospitals, mortuaries, clinics
|
|
Irrigation systems
|
|
Laboratories
|
|
Laundry and dyeing facilities
|
|
Metal plating industries
|
|
Nursing Homes
|
|
Paper processing plants
|
|
Petroleum processing or storage plants
|
|
Radioactive material processing plants or nuclear reactors
|
|
Schools with laboratory
|
|
Sewage treatment plants
|
|
Sprinkler systems filled with anti-freeze solution
|
|
Steam generating systems
|
|
Storage tanks, cooling towers and circulating systems
|
|
Water treatment plants.
|
[R.O. 2006 §700.260; Ord. No. 744 §9, 2-16-1993]
A. The
type of protective device required shall be determined by the City
Water Department and shall depend on the degree of hazard which exists.
B. An
air-gap separation or a reduced pressure principle backflow prevention
device shall be installed where the water supply may be contaminated
with sewage, industrial waste of a toxic nature or other contaminant
which would cause a health or system hazard.
C. In
the case of a substance which may be objectionable but not hazardous
to health, a double-check valve assembly, air-gap separation or a
reduced pressure principle backflow prevention device shall be installed.
D. Backflow
prevention devices shall be installed by the Department at the customer's
expense.
E. Any
protective device required in this Section shall be a model approved
by the Department. A double-check valve assembly or a reduced pressure
principle backflow device will be approved.
[R.O. 2006 §700.270; Ord. No. 744 §10, 2-16-1993]
A. Backflow
prevention devices shall be annually inspected and tested by the City
Water Department at the customer's expense, or more often where successive
inspections indicate repeated failure. The devices shall be repaired,
overhauled, or replaced by the Department at the customer's expense
whenever they are found to be defective. Inspections, tests and repairs
and records thereof shall be performed by the Department at the customer's
expense.
B. Failure
of the customer to cooperate in the installation, maintenance, testing
or inspection of backflow prevention devices required in this Section
shall be grounds for the termination of water service to the premises.