A. 
The permit fee for any newly constructed or installed private domestic well shall be one hundred dollars ($100.00) to allow for plan review and two (2) inspections.
B. 
The fee for each additional inspection for approval and evaluation purposes shall be fifty dollars ($50.00).
Reference: Section 13.04.190.
(Ordinance 03-04, sec. 1, adopted 2003)
A. 
The deposit from an applicant for water or sewer service shall be as follows:
1. 
Single-family dwellings that are owner occupied will pay a fifty dollar ($50.00) deposit.
2. 
Single-family dwellings that are occupied by a tenant (other than owner occupied) will pay a one hundred dollar ($100.00) deposit.
3. 
Class I commercial establishments will pay a one hundred dollar ($100.00) deposit.
4. 
Class II commercial establishments will pay a one hundred fifty dollar ($150.00) deposit.
5. 
Class III commercial establishments will pay a five hundred dollar ($500.00) deposit (establishments with a 2-inch meter).
6. 
Temporary construction meter accounts shall pay a one thousand dollar ($1,000.00) deposit.
B. 
The deposit for reconnection to municipal services after disconnection due to nonpayment or delinquency shall be triple the applicable deposit as set forth in subsection A of this section.
Reference: Section 13.08.030.
(Ordinance 03-15 adopted 2003)
In the event that any person receiving water or sewer services from the town is disconnected for failure to pay the amount due for such services, the town shall require a reconnection fee in the amount of fifteen dollars ($15.00) or such other fee as the town council may, by resolution, establish from time to time.
Reference: Section 13.08.040.
(Ordinance 03-15 adopted 2003)
If any customer questions the accuracy of a meter and the meter is found to be in calibration, the customer requesting the calibration test shall be charged a fee of twenty-five dollars ($25.00) for residential property and fifty dollars ($50.00) for commercial property for the calibration test, or a fee equal to that charged by the third party for performing the calibration test, whichever is greater.
Reference: Section 13.08.050.
(Ordinance 03-15 adopted 2003)