No person shall discharge or cause to be discharged any stormwater, surface water, groundwater, roof runoff, subsurface drainage, uncontaminated cooling water or unpolluted industrial process waters to any sanitary sewer.
Stormwater and all other unpolluted drainage shall be discharged to such sewers as are specifically designated as storm sewers or to a natural outlet. Uncontaminated industrial process waters may be discharged, on approval of the Sewer Administrator, village and DEC, to a storm sewer or natural outlet.
No person shall discharge or deposit or cause or allow to be discharged or deposited into the wastewater treatment system any wastewater which contains the following:
A. 
Explosive mixtures: liquids, solids or gases which, by reason of their nature or quantity, are or may be sufficient, either alone or by interaction with other substances, to cause fire or explosion or be injurious in any other way to the wastewater treatment system or to the operation of the system. At no time shall two successive readings on an explosion hazard meter at the point of discharge into the public sewer system be more than 5% nor any single reading over 10% of the lower explosive limit (LEL) of the meter. Prohibited materials include, but are not limited to, gasoline, kerosene, naphtha, benzene, toluene, xylene, ethers, alcohols, ketones, aldehydes, peroxides, chlorates, perchlorates, bromates, carbides, hydrides and sulfides.
B. 
Toxic substances: any toxic substances in amounts exceeding standards promulgated by the Administrator of the United States Environmental Protection Agency pursuant to the Act [now Section 307(a)] and chemical elements or compounds, phenols or other taste- or odor-producing substances or any other substances which, singly or by interaction with other wastes, are not susceptible to treatment or which may interfere with the biological processes or efficiency of the wastewater treatment system or that will pass through the system without being treated to the required degree.
C. 
Corrosive wastes: any wastes which will cause corrosion or deterioration of the wastewater treatment system. All wastes discharged to the public sewer system must have a pH value in the range of 6.0 to 9.0 standard units. Prohibited materials include, but are not limited to, acids, sulfides, concentrated chloride and fluoride compounds and substances which will react with water to form acidic products.
D. 
Solid or viscous wastes: solid or viscous substances in quantities or of such size capable of causing obstruction to the flow in sewers or other interference with the proper operation of the wastewater treatment system, such as, but not limited to, ashes, cinders, sand, mud, straw, shavings, metal, glass, rags, feathers, tar, plastics, wood, whole blood, hair and fleshings or hides, animal guts or tissues, entrails, bones, spent lime, stone or marble dust, grass clippings, spent grains, spent hops, wastepaper, asphalt residues, residues from refining or processing of fuel or lubricating oil and similar substances. This prohibition includes any wastewater which, by interaction with other waters or wastes in the wastewater treatment system, forms suspended solids which obstruct the flow in the sewer or create a condition that interferes with the proper operation of the wastewater treatment system.
E. 
Oil and grease: any wastewater containing fats, wax, grease or oils, whether emulsified or not, in excess of 100 mg/l or containing substances which may solidify or become viscous at temperatures between 32° and 150° F. (0° and 65° C.).
F. 
Excessive temperature: any wastewater causing the temperature in the public sewer to exceed 150° F. (65° C.) or the temperature of the influent to the treatment facilities to exceed 104° F. (40° C.).
G. 
Improperly shredded garbage: garbage that is not properly shredded garbage as heretofore defined.
H. 
Noxious materials: noxious or malodorous solids, liquids or gases which, either singly or by interaction with other wastes, are capable of creating a public nuisance or hazard to any form of life or are or may be sufficient to prevent entry into a sewer for its maintenance and repair.
I. 
Radioactive wastes: radioactive wastes or isotopes of such half-life or concentration that they do not comply with regulations or orders issued by the appropriate authority having control over their use and/or which will or may cause damage or hazards to the wastewater treatment system or personnel operating the system.
J. 
Excessive discharge rate: quantities of wastewater flow or concentrations, or both, which constitute a slug as defined herein.
K. 
Discolored material: waste with color, such as but not limited to dye water or vegetable tanning solution, that is not removable by the treatment process.
A. 
General limitations on incompatible pollutants. No person shall discharge or convey or permit or allow to be discharged or conveyed to a public sanitary sewer any wastewater containing incompatible pollutants of such character or quantity that will:
(1) 
Violate pretreatment standards.
(2) 
Cause the wastewater treatment works to violate its SPDES permit requirements.
(3) 
Violate the provisions of this chapter, the Village Local Sewer Law or other applicable laws, rules or regulations.
(4) 
Not be susceptible to treatment or interfere with the process or efficiency of the treatment system.
B. 
Specific limitations on certain incompatible pollutants. The following are the maximum concentrations of pollutants allowable in wastewater discharges to the wastewater treatment system as established by the DEC. This chapter includes by reference any future revisions or additions to this list as promulgated by the DEC or EPA. Dilution of any wastewater discharge for the purpose of satisfying these requirements shall be considered a violation of this chapter.
Parameter
30 Day Average Effluent Concentration Limits
(mg/l)
Boron
1.0
Cadmium
0.4
Hexavalent Chromium
0.2
Total Chromium
4.0
Copper
0.8
Lead
0.2
Mercury
0.2
Nickel
4.0
Zinc
1.2
Arsenic
0.2
Available Chlorine
50.0
Cyanide-free
0.4
Cyanide-complex
1.6
Selenium
0.2
Sulfide
6.0
Barium
4.0
Manganese
4.0
Gold
0.2
Silver
0.2
Fluorides
To Fresh Water
4.0*
To Saline Water
36.0
Phenol
4.0
NOTES:
*
May be multiplied by a factor of 1.5 if the municipal water supply is not fluoridated.
C. 
Limitations on compatible pollutants. In cases where effluent characteristics of an industrial or commercial discharge exceed the permissible limits for the compatible pollutants listed below in Subsections (1), (2), (3) and (4) of this Subsection C, the acceptability of such excessive strength wastewater will be left to the judgment of the Sewer Administrator and the village or any other federal, state or local agencies having jurisdiction. The primary judgment criteria for the determination of acceptability by the Sewer Administrator, village and responsible authorities will be whether the admission of such waste will, when added to the existing wastewater flows, cause the wastewater treatment system to violate its SPDES permit or other provisions of this chapter. If it is determined that the wastewater is acceptable, permission to discharge said compatible pollutants may be granted under conditions stated by the Sewer Administrator and village. However, the payment of an additional industrial operation and maintenance surcharge in accordance with Article IX for the additional industrial operation and maintenance will be required, and a user charge for the additional capital construction costs will be required to cover the cost of treating the excessive strength wastewater. These charges are in addition to any sewer charges for the nonexcessive waste discharge. "Excessive strength wastewater" is defined as:
(1) 
Suspended solids such as but not limited to lime slurries or lime residues in concentrations exceeding 250 mg/l or dissolved solids such as but not limited to sodium chloride in concentrations greater than 10,000 mg/l and sodium sulfate in concentrations greater than 500 mg/l.
(2) 
Concentrations of BOD which exceed 250 mg/l.
(3) 
Wastewater having chlorine demand requirements exceeding 9.0 mg/l.
(4) 
Concentrations of free ammonia which exceed 25 mg/l.
A. 
No person shall discharge or cause to be discharged to the wastewater treatment system wastewaters containing substances subject to an applicable Federal Categorical Pretreatment Standard promulgated by the EPA in excess of the quantity prescribed in such applicable pretreatment standard, except as otherwise provided in this section. The Sewer Administrator shall notify the affected industrial users of the required schedule for obtaining compliance with the applicable pretreatment standards; however, new sources shall initially comply with the existing pretreatment standards. The allowance of a time period in order to achieve compliance with the pretreatment standards will in no case be interpreted to allow any industry to discharge wastes in the interim that interfere with the wastewater treatment plant complying with its existing SPDES permit or violate any provision of this chapter. Review, control and monitoring of the pretreatment system will be in accordance with Article V.
B. 
Upon application by an industrial user, the Sewer Administrator and village may revise any limitations on substances specified in the applicable pretreatment standards to reflect removal of the substances by the wastewater treatment facility. The revised discharge limit for specified substances shall be derived in accordance with the Act.
C. 
Upon application by an industrial user, the Sewer Administrator and village may adjust any limitation on substances specified in the applicable pretreatment standards to consider factors relating to such user which are fundamentally different from the factors considered by EPA during the development of the pretreatment standard. Requests for and determinations of a fundamentally different adjustment shall be in accordance with the Act.
D. 
The cost to the Town and village for all services necessary to implement this section shall be paid for by the industrial or commercial (if applicable) user. Work under §§ 311-19C and 311-20B and 311-20C will not be carried out without prior agreement by the industrial user for payment of the costs, including engineering, laboratory and legal costs incurred by the Town and village in connection with such work.
No person shall discharge waste other than from premises within the boundaries of Sanitary Sewer District No. 1 which are the source of such waste, except in the discretion of the Sewer Administrator and village and on terms and conditions, including fees, established by the Sewer Administrator and village.