[Amended 4-26-1988 by L.L. No. 3-1988; 6-12-2001 by L.L. No. 21-2001; 1-27-2004 by L.L. No.
2-2004; 2-27-2007 by L.L. No. 5-2007]
A fee schedule shall be established, and changed
as needed, by resolution of the Southampton Town Board. A copy of
the fee schedule is on file with the Town Clerk’s office and
the Department of Land Management. In addition to the above-referenced
fee schedule, the Planning Board may require an applicant to pay an
amount, to be held in escrow and ultimately disbursed, to pay the
costs incurred by the Town for all consulting services it may reasonably
seek to engage, including, but not limited to: archaeological, engineering,
planning, legal and clerical costs incurred in processing and review
of a proposed subdivision. Such amount deemed necessary for escrow
shall be reasonably related to costs attendant to the Town’s
review, and such amount shall be computed by the Planning Board in
consultation with the applicant. Further, if such escrow payment is
deemed necessary, this fee shall be in addition to and exclusive of
any fee(s) properly assessed to the applicant in connection with the
SEQRA process.
The preliminary plat shall be prepared by a
licensed land surveyor and shall show the information noted in this
section:
A. Size and type of drawing:
(1) Sheet size shall be either 18 inches 20 inches or
36 inches by 20 inches.
(2) The original drawing may be done with pencil on vellum
tracing paper, with scaled dimensions and careful lettering, using
upper case letters at a minimum height of 1/8 inch.
(3) The scale of the drawing shall be not more than 100
feet to the inch and shall be a common engineering scale.
B. Title block:
(1) Name of proposed subdivision.
(2) Location by postal district.
(3) Name and address of subdivider.
(4) Name, address, license number and seal of licensed
land surveyor preparing the drawings.
(5) Total acreage of entire tract.
(6) Total number of proposed lots and zoning district.
(7) The term "preliminary plat" must show on the map.
C. Other notations:
(1) Date of original preparation and of each subsequent
revision.
(3) Certification by the licensed land surveyor that the
topography shown resulted from an actual survey and the date of that
survey.
D. Key maps, at scales of 600 and 1,000 feet to the inch
(separate sheet, if desired):
(1) Proposed subdivision streets.
(2) Surrounding streets, existing and proposed.
(3) Relationship to nearby highway or collector street.
(4) Any municipal boundary within 500 feet of premises.
E. Approximate boundaries and owners of adjacent acreage
properties and boundaries and name of adjacent subdivision.
F. Subdivision boundary lines (heavy solid line) and
survey data.
H. Topographic contours at two-foot intervals in the
National Oceanic and Atmospheric Administration Survey datum of mean
sea level, or, where it is impractical to use a mean sea level datum,
an assumed elevation may be used at the discretion of the Planning
Board:
(1) Five-foot intervals may be used in cases where the
terrain is unusually steep.
(2) Contours shall extend 200 feet beyond the boundaries
of the subdivision unless waived by the Planning Board.
I. Existing site conditions:
(1) All street rights-of-way on the subdivision and within
200 feet of its boundaries:
(a)
Location, name and width.
(b)
Center-line elevation at intersections and other
critical points.
(c)
Designation as to whether highways are state,
county or Town highways.
(d)
Proposed state, county or Town highways as of
date.
(2) Other rights-of-way, trails and easements on the subdivision
and those within 200 feet of its boundaries which will influence the
subdivision design:
[Amended 2-27-1990 by L.L. No. 3-1990]
(a)
Location, identification and width.
(b)
Restrictions of use, if any.
(3) All drainage structures on the subdivision and within
200 feet of its boundaries:
(a)
Location and type of structure.
(b)
Invert elevations and similar data where applicable.
(4) Other utility structures, such as water mains, gas
mains and power lines, on the subdivision and those within 200 feet
of its boundaries which will influence the subdivision design.
(5) All wetlands, lakes, ponds, streams, creeks, bays,
ocean, canals, land subject to periodic or occasional flooding, dunelands
and crests of dunes or similar features located on the subdivision
or within 200 feet of its boundaries:
[Amended 5-12-1992 by L.L. No. 22-1992]
(a)
Location and area covered indicating apparent
mean high water or normal waterline if not subject to tidal effect.
(b)
Waterline referred to date of survey.
(6) Test hole data:
(a)
Data, location and graphic representation of
findings for all test holes, including groundwater level.
(b)
Locations shall include critical points and
areas where drainage structures requiring seepage are to be constructed.
(c)
In problem soil areas, the Planning Board may
require special borings to be made by the Suffolk County Soil and
Water Conservation District and may request comments as to the practicality
of the subdivision plan being considered relative to these soils.
(7) Federal, state, county or Town parks, schools or other
public lands and historic sites and buildings.
(8) Buildings and structures located on the subdivision
and those within 200 feet of its boundaries which will influence the
subdivision design.
J. Proposed site conditions. (See Article
X, Design Standards.) The proposed street and lot layout and drainage plan shall cover the entire holding of the subdivider:
(1) Street layout:
(a)
Location, name and right-of-way width.
(b)
Proposed center-line elevation at intersections
and at principal changes in gradient.
(c)
Center-line gradient shown in percent of slope.
(d)
Center-line profile at a horizontal scale of
one inch equals 50 feet and a scale of one inch equals 10 feet.
(2) Preliminary stormwater drainage system plan:
(a)
Location, type and capacity of storage structures,
including size, approximate invert elevations of all piping, structures
and recharge basins.
(b)
Watershed outlines, with approximate area in
acres. (United States Geodetic Survey maps may be used.)
(c)
Submission of preliminary drainage calculations
in accordance with Highway Department standards for the Town of Southampton.
(3) Lot layout:
(a)
Lot lines and dimensions to the nearest foot.
(b)
Approximate area of each lot in square feet.
(c)
Easements and restricted areas, with notations
as to purpose or restriction.
(d)
Identification of lots and parcels for special
uses to be offered for dedication.
K. Street and lane names. There shall be no duplication
of street and lane names within any fire, postal or school districts
in the Town or any duplication within any fire, postal or school district
which is partially in other Towns. In the case of private lanes, signage
shall conform to standards required for the public system.
[Amended 3-10-1992 by L.L. No. 4-1992]