[Ord. No. 3187 §1, 11-5-2014]
A. 
Blocks shall meet the following standards. Each block in a subdivision shall be numbered in a reasonable schematic method.
1. 
In residential areas, blocks shall be not less than six hundred (600) nor more than one thousand three hundred twenty (1,320) feet in length measured along the greatest dimension of the enclosed block area, unless necessitated by topography. Block length in commercial or industrial areas shall be as determined by the Planning Commission to be suitable for the intended use.
2. 
In blocks over six hundred (600) feet in length, the Planning Commission may require one (1) or more public walkways within an easement not less than ten (10) feet in width to extend entirely across the block and at locations deemed necessary at intervals not closer than four hundred (400) feet.
3. 
Blocks shall each be wide enough to allow two (2) back-to-back lots, with a minimum depth of one hundred twenty (120) feet, except where adjoining a major thoroughfare or where one (1) through lot is necessary because of topographic conditions.