The identified floodplain area shall consist of the following
specific areas:
A. The Floodway Area/District identified as floodway in the FIS which
represents the channel of a watercourse and the adjacent land areas
that must be reserved in order to discharge the base flood without
cumulatively increasing the water surface elevation by more than one
foot at any point. This term shall also include floodway areas which
have been identified in other available studies or sources of information
for those special flood hazard areas where no floodway has been identified
in the FIS.
(1) Within any floodway area, encroachments, including fill, new construction,
substantial improvements, or other development shall not be permitted
unless it has been demonstrated through hydrologic and hydraulic analysis
performed in accordance with standard engineering practice that the
proposed encroachment would not result in any increase in flood levels
within the community during the occurrence of the base flood discharge.
(2) No new construction or development shall be allowed, unless a permit
is obtained from the Department of Environmental Protection regional
office.
B. The AE Area/District shall be those areas identified as an AE Zone
on the FIRM included in the FIS prepared by FEMA for which base flood
elevations have been provided.
(1) The AE Area adjacent to the floodway shall be those areas identified
as an AE Zone on the FIRM included in the FIS prepared by FEMA for
which base flood elevations have been provided and a floodway has
been delineated.
C. The A Area/District shall be those areas identified as an A Zone
on the FIRM included in the FIS prepared by FEMA and for which no
one-percent annual chance flood elevations have been provided. For
these areas, elevation and floodway information from other federal,
state, or other acceptable sources shall be used when available. Where
other acceptable information is not available, the base flood elevation
shall be determined by using the elevation of a point on the boundary
of the identified floodplain area which is nearest the construction
site.
(1) In lieu of the above, the municipality may require the applicant
to determine the elevation with hydrologic and hydraulic engineering
techniques. Hydrologic and hydraulic analyses shall be undertaken
only by professional engineers or others of demonstrated qualifications,
who shall certify that the technical methods used correctly reflect
currently accepted technical concepts. Studies, analyses, computations,
etc., shall be submitted in sufficient detail to allow a thorough
technical review by the municipality.
The identified floodplain area may be revised or modified by the Council where studies or information provided by a qualified agency or person documents the need for such revision. However, prior to any such change to the special flood hazard area, approval must be obtained from FEMA. Additionally, as soon as practicable, but not later than six months after the date such information becomes available, a Borough shall notify FEMA of the changes to the special flood hazard area by submitting technical or scientific data. See §
205-22B for situations where FEMA notification is required.
Should a dispute concerning any identified floodplain boundary
arise, an initial determination shall be made by the Borough of Walnutport
Planning Commission and any party aggrieved by this decision or determination
may appeal to the Council. The burden of proof shall be on the appellant.
Prior to development occurring in areas where annexation or
other corporate boundary changes are proposed or have occurred, the
community shall review flood hazard data affecting the lands subject
to boundary changes. The community shall adopt and enforce floodplain
regulations in areas subject to annexation or corporate boundary changes
which meet or exceed those in 44 CFR 60.3.